What is the maximum voltage across the capacitor? (Hint: Observe from the oscilloscope graph) Function Generator Set up: Frequency = 100 Hz, Amplitude = 5 Vp [Peak voltage = 5 V i.e. Peak- peak = 10 V] Waveform = square wave Oscilloscope Set up: Time base scale: 2 ms/div (Input signal) Channel A scale: 2 V/ div (Output Signal) Channel B scale: 2V/ div

What is the maximum voltage across the capacitor? (Hint: Observe from the oscilloscope graph) Function Generator Set up: Frequency = 100 Hz, Amplitude = 5 Vp [Peak voltage = 5 V i.e. Peak- peak = 10 V] Waveform = square wave Oscilloscope Set up: Time base scale: 2 ms/div (Input signal) Channel A scale: 2 V/ div (Output Signal) Channel B scale: 2V/ div

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Similar questions

What is the unit of measurement for the strength of a capacitor? microamp microtorque microfarad microwatt
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
What is the minimum AC voltage rating of each capacitor in Question 11?
Can current flow through a capacitor?
In a pure capacitive circuit, does the current lead or lag the voltage?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
A pure capacitive circuit is connected to a 480-volt, 60-Hz power source. An ammeter indicates a current flow of 24 amperes. The circuit current must be reduced to 16 amperes by connecting a second capacitor in series with the first. What is the value of the existing capacitor? What value capacitor should be connected in series with the original capacitor to limit the circuit current to 16 amperes?
Explain how you would use an oscilloscope to measure an alternating potential difference of the order of 10V peak-to-peak. (You may assume that an alternating PD of 5V peak-to-peak is available).What is the RMS value of a peak-to-peak voltage of 10.0V?
The waveform displayed on an oscilloscope is as shown in Figure The 'time/cm' switch is set to 20 ms/cm, and the 'volts/cm' switch is set to 30 V/cm. Determine the (i) amplitude of waveform Q, (ii) peak to peak value of waveform P, (iii) frequency of waveform P and (iv) phase angle difference between P and Q in Degrees and (v) R.m.s value of waveform Q.
The waveform displayed on an oscilloscope is as shown in Figure The 'time/cm' switch is set to 20 ms/cm, and the 'volts/cm' switch is set to 30 V/cm. Determine the (i) amplitude of waveform Q, (ii) peak to peak value of waveform P, (iii) frequency of waveform P and (iv) phase angle difference between P and Q in Degrees and (v) R.m.s value of waveform Q. Note: Please do not handwriting
How many milliseconds after the switch has been moved does the inductor voltage equal 45V?
Draw the electrical model of a piezoelectric crystal. (ii) Over what portion of the reactance curve do we desire oscillations to take place when the crystal is used as part of a sinusoidal oscillator? Explain.