What is the Norton's resistance

Q: The input to a full-wave rectifier is 20 V AC (RMS). The load resistor is 20 ohms and rectifier…

A:

Q: A 600 meters copper wire is to be used for a three loads that dissipates 1600W, 795W, 1560W power…

A: Dissipation of power is the process through which heat is produced by electric or electronic…

Q: Adding more resistors to a parallel circuit will __________ the total resistance.     decrease…

A:

Q: 1. Determine v using superposition theorem.

A: It is given that:

Q: Explain the relationship between Transmitted power (dBm) and Optical link length (km) in Optical…

A: Given: Explain the relationship between Transmitted power (dBm) and Optical link length (km) in…

Q: Question A dc series motor with a resistance between terminals of 10, runs at 800 rpm from a 200 V…

A: Given- Voltage V=200 V, Current Ia=15 A, Speed- N1=600 rpm,N2=475 rpm, To Find- The additional…

Q: Which of the following represents the phasor form of a uniform plane wave travelling in Teflon (μ₁ =…

A:

Q: Дидь P₂D₁ 00 01 11 60 X 1 1 D D O 01 El Q₁ = D3 + D4 F Q22 Ри Дз. P2D1 00 01 "1 10 00 X O 1 01 0 O 0…

A:

Q: Determine the current across R1 if Vi=5V.

A: The required parameter can be calculated by replacing the diode with a short circuit and then we…

Q: 2. Find the equivalent capacitance. Assume all capacitors are 1F. Ceq

A:

Q: .Use Nodal analysis to find current flowing through all the branches in the following Circuit V₁ =…

A: In this question,  We need to determine the current in the each branch using the nodal analysis.  We…

Q: 4. Determine the total impedance. ZT 202 M 452 WIE -j62 M 3.12 m j42

A:

Q: Find the transfer function of the following block diagrams

A: The given block diagram can be reduced by using the block diagram reduction techniques. The negative…

Q: From the previous item, find the time response of vL(t) to an input v(t) = 8(t), an impulse…

A:

Q: Determine the output y[n] = x[n] * h[n] given that input x[n] is applied to an LTI system with…

A:

Q: Determine the Thevenin's and Norton's equivalent circuits of the following: 1. 3A (1 5.2 100 N 62 ±…

A:

Q: 1₁ Determine to using superposition theorem. Io ↓ 852 N -120 HE J45 LO° A 62 M +30/30°V

A: In this question,  We need to determine the current Io  as shown the circuit using the super…

Q: Problem 7 v₁ = 45v V/₂=15V Energy and Natural Response in Series Caps t = o 20nF 3.0nF 10052 T The…

A: We need to find out the energy stored by capacitor.

Q: WARNING: The circuit diagram below is NOT a full-adder. C₁ 1st half -adder S₁ P Q. R C₂ 2nd half…

A: Given:  Required:  (a) Output for P=0,Q=1 and R=0. (b) Output for P=1,Q=1 and R=1.

Q: • Find out currents through all the resistors and voltage all resistors Using mash analysis. Vp=12v…

A:

Q: (i) A 420 V, 60 Hz, star connected, the four-pole synchronous generator has a synchronous reactance…

A: When the generator is turned, the magnetic field created by the stator poles induces a voltage in…

Q: Use dynamic programming method to determine the most economical units to be committed to supply a…

A:

Q: An electrical lamp is rated 120 volts, 500 watts. If the voltage applied across the lamp is twice…

A: Let us suppose that the base voltage is equal to the rated voltage and the base power is equal to…

Q: Formulate the Routhian array for each number and indicate the number of R Q(s) = $5+2s4+3s³…

A: Number of RHP is equal to number of sign change in first column of routh table.

Q: (a) Find the node voltages v1, v2 and v3 in the circuit shown below. (b) Find the total power…

A:

Q: (a) For the following network, derive an expression for the system reliability in terms of the…

A:

Q: Formulate the Routhian array for each number and indicate the number of RHP. Q(s) = s³+10s²+31s+1030

A:

Q: 1. Determine the value of R₁ for maximum power transfer. Also, determine the maximum power. 902 -W 0…

A: The given circuit is:

Q: Find the transfer function, 02(s)/T(s) for the given rotational mechanical system. (Non-anonymous…

A:

Q: 19. Apply Thevenin's theorem to find Va ЗА Μ 4 Ω 16 Ω 5Ω 1Ω www 12 V 10 Ω

A:

Q: If the load resistance in an envelope detector is doubled, will the charging time constant change or…

A: Given, the load resistance(RL) in an envelope detector is doubled. We need to explain the changes…

Q: The figure shows an instrumentation amplifier driven by a bridge. Obtain the gain vdviof the…

A:

Q: 1. Find the value, that is, the current across the 3Ω resistor. 30 Μ 24V ΤΩ ΣΑ ΘΩ

A:

Q: A 3600-rpm 10-kilowatt 400-volt separately-excited DC generator has a field resistancce Rf=100ohms…

A: Given Separately excited DC generator with Field resistance Rf= 100 ΩArmature resistance Ra=0.1…

Q: Make a general statement on the effect of increasing excitation to the power factor of the…

A:

Q: Unsimplified Boolean expression and truth table

A: Given:  Required: Unsimplified Boolean expression and truth table.

Q: A 489V shunt motor delivers 30hp at the shaft at 1120rpm. If the motor has an efficiency of 86% at…

A:

Q: Explain the environmental hazard of Nuclear power generation with neat diagram

A: Nuclear power plants use uranium as fuel. During the process of mining uranium released high amounts…

Q: 4. For the circuit shown in Figure 4, use Kirchhoff's Current Law to write a nodal equation for the…

A: It is given that:

Q: Given the circuit below, apply mesh-current analysis to determine the current I1 and I3 flowing in…

A: First apply KCL at node b and write the I2 in terms of I1 , I3. Apply KVL in the two loops and using…

Q: what are the advantages of high voltage DC transmission compared to high voltage AC ??

A: Advantages of High voltage DC transmission over high voltage ac transmission

Q: 2.09KW to hp show the so

A: Given  P = POWER = 2.09 kW Conversation of kW to HP is given below.

Q: 3. Find the output voltage v, in each of the 3 circuits below and explain how you found it Assume…

A:

Q: Formulate the Routhian array for each number and indicate the number of RHP. Q(s) =…

A: According to Routhian array, the total number of RHP will be equal to the number of sign changes in…

Q: A separately excited DC motor runs at 1000 rpm on no load when its armature terminals are connected…

A: Given- Speed N1=1000 rpm, Voltage V=200 V, Armature resistance Ra=1 Ω, No load back emf- Eb1=200 V,…

Q: circuit in Figure 3: for the a) Find the following: ii. VGs; and iii. Vos. b) Plot the Q-point. 6.8…

A: We need to find out drain current, drain to source voltage and drain to source voltage for given…

Q: 7. The input is 1 W and the network loss is 27 dB, the output is 8. A filter has a voltage gain of…

A:

Q: Implement f(x,y,z) = Σm(0,1,3,4,7) as a two-level gate circuit, using a minimum number of gates. Use…

A: Given data: The function, fx,y,z=∑0,1,3,4,7

Q: 1. For the following circuit find the value of the current ID, and the voltage V +8 V 1.2 ΚΩ lp •…

A:

Q: An ideal voltage divider consists of only R₁, R2, and the voltage source in series with each other.…

A: As we have given in the above question about the voltage divider and stray capacitance, here we have…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.