What is the percent purity of the obtained crystal after one recrystallization?

Q: The rate of shear versus the shear stress curves are time dependent for Thixotropic Rheopectic…

A: The ratio of the rate of shear and the shear stress gives viscosity to the fluid. The fluids are…

Q: One kilogram of air is heated reversibly at constant pressure from an initial state of 300 K and 1…

A: For a detailed solution, please see the attached files.

Q: Air compressor Steam turbine

A: Answer. Data given below:-

Q: steady-flow process.

A:

Q: und a

A:

Q: g Define Gray body and black body.

A: Gray and black body is to be defined.

Q: J 5

A:

Q: 100g/s of methane at 300°C is combusted with a stoichiometric amount of oxygen gas which is at…

A: Methane is burnt with stoichiometric amount of oxygen. Stoichiometric amount of oxygen means there…

Q: What is the carbonate (CO32-) concentration

A:

Q: An equimolar mixture of nitrogen and acetylene enters a steady-flow reactor at 25°C and atmospheric…

A: Write the reaction as follows: N2g + C2H2g → 2HCNg One mole of N2 reacts with one mole of C2H2 and…

Q: Determine the rate of liquid residue if the feed rate is 100 mol/hr by analyzing the given graph.…

A: Given that F =100 mol/hr there is a graph between 1y-x and x

Q: transfer functions:

A:

Q: Topic: Isothermal Reactor Design PROVIDE HANDWRITTEN SOLUTION PLEASE A rxn occurred in an isochoric…

A:

Q: Q1) A steel cylinder 10 cm in diameter and 10 cm long is initially at 300 °C. It is suddenly…

A: The properties of steel cylinders are considered. Biot number is calculated. The other dimensionless…

Q: Derive the velocity profile of the fluid inside the two stationary plates. The plate is initially…

A: Considering a small volume of a cube and velocity profile is obtained then it is integrated to…

Q: state and explain Plank's Law and Wein's displacement Law,

A: The Planck's law and Wien's law are to be mentioned.

Q: a) An ideal gas undergoes an expansion from the initial state described by initial pressure (Pi),…

A: The gas is an ideal gas. The expansion is isothermal. In isothermal expansion, the temperature…

Q: Please explain, thank you so much

A: EGL refers to the energy grade line, and HGL refers to the hydraulic grade line. For a steady-state…

Q: A fluid whose apparent viscosity increases with shear rate is termed as the fluid. Viscous…

A: Viscosity is a fluid [property. This property studies liquid motion behavior. The measure of the…

Q: Q2: A closed cycle gas turbine unit operating with maximum and minimum temperatures of 760°C and 20…

A: The closed cycle gas turbine works on the Brayton cycle. This has reversible adiabatic compression…

Q: For a 400 L reactor, through which water is flowing at a rate of 100 L/min, the F curve can be…

A:

Q: Problems on Module IV [Mass Transfer - I: PCMT 405] Semester IV: 4 Yr. B.Tech. 2022 Problems on…

A: A mixture of benzene and toluene is batch distilled.

Q: 5. In the following table are listed various aqueous solutions. For one or more of the solutions…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: The unit cell of chromium contains two atoms. Without using the crystal structure infor- mation,…

A: (a) Given, The chromium contains two atoms in a unit cell. Let r be the radius of the atoms and a be…

Q: We desire to produce two ethyl alcohol-water mixtures each containing 90% and 50% alcohol by mole…

A: Let feed rate(F) = 1000KMol And top product Flow rate are D1 And D2 with composition 90% and 50%…

Q: express in 4 decimal places    ans asap

A:

Q: A liquid phase reaction A B

A:

Q: 4. A bottle of HBr has printed on its label that it contains 31%wt HBr. Using this information,…

A: Given that- The bottle contains HBr= 31% by weight. The density of the reagent solutio =1.22 kg/L…

Q: During the summer solstice, a solar heater is installed in a house in the morning to heat the water…

A:

Q: amount of energy released

A:

Q: Identify, with reason, the type of amine solution that should be opted for to prioritize the removal…

A:

Q: Use the appropriate property table to fill in the values (letters a to x) in the following table:

A:

Q: Cinnamaldehyde (C,H,O), an organic liquid responsible for the scent of cinnamon, has a specific…

A:

Q: Determine the power requirement (in kW) of the compressor if 5 mol/s of the gas flows through it

A: given data  T=300K P1= 1 bar P2=20 bar T2= 700K

Q: counter current multistage leaching process.

A:

Q: Calculate the effect of an increase in pressure of 77000 mmHg on the vapour pressure of toluene at…

A:

Q: Chemical Engineering: Material Balance

A:

Q: A 15kg sample of water is held at 200°C in a variable-volume container (a piston-cylinder…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: Right now, Malampaya is the only sizeable source of natural gas in the Philippines. A certain sample…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: QUESTION 2 Fresh oilseeds having 25 wt% solute and 1 wt% solvent is to be leached at a rate of 2000…

A:

Q: Create a Pxy diagram using Raoult's Law for water and methanol at 60 C. Make sure to label: A)…

A: P, x-y diagram of water and methanol at a given temperature is to be created.

Q: It is desired to produce 46.4 mol/s of Ethylene glycol (EG). The reactor is to be operated…

A: Ethylene oxide is produced by the reaction of ethylene glycol and sulfuric acid solution. In the…

Q: 4. An ideal vapour-compression refrigeration cycle operates at steady state with Refrigerant 134a as…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: b) Consider a refrigerant-134a power plant that operates on a simple ideal Rankine cycle. The boiler…

A:

Q: can u explain why more about the equation u use to calculate the specific area of adsorbent.

A: To explain about the equation  used to calculate the specific area of adsorbent

Q: A laboratory investigation into the spontaneous decomposition of a liquid organic compound Z under…

A:

Q: The content of l- in 2.3 g of sample was determined by volumetric precipitation. The sample was…

A: Given that- Mass of I- sample= 2.3 g Molar mass of  I- =63.5 g/mol Hence,  Moles of I-=MassMolar…

Q: A certain catalyst undergoes sintering overtime, causing its catalytic activity to decrease…

A:

Q: Consider a 1000 mL chemostat (continuous reactor) operating with cellular recycling. The bioreactor…

A: Volume of chemostat = 1000 mL Volumetric flow rate = 100 mL/h µmax = 0.2 h-1 kS = 1 g/L…

Q: Air at 100°F and 2 atm is being passed over a shallow bed of naphthalene spheres that are 0.5 inch…

A: Given data: Diameter of spherical particles = 0.5 in Superficial velocity = 5 ft/s Molecular weight…