Answered: What is the percentage removal rate for…

Engineering

Civil Engineering

What is the percentage removal rate for 2.5 log removal (LR)? A. 99.51% B. 99.75% C. 99.68% D. 99.15

Fundamentals Of Construction Estimating

4th Edition

ISBN:9781337399395

Author:Pratt, David J.

Publisher:Pratt, David J.

Chapter14: Pricing General Expenses

Section: Chapter Questions

Problem 6RQ

See similar textbooks

Related questions

Q: A block of mass m = 2 kg is resting on a rough inclined plane of inclination 30° as shown in figure.…

Q: the following data were taken on five vehicles travelling consecutively 1.5km portion of the NLEX.…

A: Given: The distance is 1.5 km. The data of five vehicles are, Vehicle Time (min) 1 1.2…

Q: 3.11 The moist density of a soil is 1750 kg/m³. Given w = 23% and G, = 2.73, determine: a. Dry…

A: γd= 1750kg/m3w = 23% = 0.23Gs= 2.73 And it has been asked in the question to determine the Dry…

Q: S = 5.5m RLL = 900 N/m^2 RDL = 850 N/m^2 1. A 20m Fink Truss are spaced at 'S' meters o.c. the…

A: sagging : Hogging and sagging are terms used in solid mechanics, structural engineering, and…

Q: Given the truss shown, determine the value of the horizontal reaction at B. C= 14 KN D=20 KN E = 54…

A: The system is in equilibrium, so we can apply equilibrium condition, i.e ∑FX=0∑Fy=0 ∑MA=0 and A is…

Q: d limit and plastic limit test. liquid limt. id Limit Test Wt. Wt. of of No. pil Wet Dry nple Soil…

Q: the following data were taken on five vehicles travelling consecutively 1.5km portion of the NLEX.…

A: in table above, five vehicles traveled consecutively 1.5km portion of the NLEX. It has been asked in…

Q: 1 The relative density of a fluid is 1.26 and its dynamic viscosity is 1.50 Pa.s. Calculate its (i)…

Q: An odd shaped body weighing 7.5 kg and occupying 0.01 cubic metre volume wil| be completely…

A: given- weight=7.5 kgvolume=0.01 m3

Q: 2. Given the reinforced concrete T-beam in the figure, determine the following: 500 mm 150 mm s00 mm…

A: The given figure is shown below:

Q: The volume of gravel and cement used in a 1 ft3 concrete mixture is 0.58 ft3 and 0.12 ft3,…

A: Given, Vgravel = 0.58 ft3 Vcement = 0.12 ft3 Vconcrete = 1 ft3

Q: Q Determine Was x to balance the beam shown below: 1ow R=12 T R8T.. A 6 m 2X

Q: Explain the term meandering, its causes,

A: To explain the term Meandering, its causes and the parameters associated with it with the help of a…

Q: For the cantilever beam and loading shown

A: Given: Cantilever beam with below loading conditions: To calculate: Vertical reaction at support A

Q: 24. Refer to the Figure shown. A car hit a tubular steel post at B. The post is fixed to the ground…

Q: A plane frame as shown in figure has clamp support at A, hinge support at G and H, axial force…

Q: Note: Replace all zero digits of your ID number by number "2" Problem #4: Use X = Last 3 digits of…

Q: 3.7 Undisturbed soil sample was collected from the field in steel Shelby tubes for laboratory…

Q: A retaining wall against a mud slide is to be constructed by placing 1.2-m-high and 0.25-mwide…

Q: 2. A 6 m long cantilever beam 250 mm x 600 mm carries a uniformly distributed dead load (beam weight…

Q: An isolated T-beam is composed of a flange 700 mm wide and 175 mm deep cast monolithically with a…

Q: The given soil sample is having porosity value of 30% and degree of saturation 78%, then the…

A: given- porosity n=30%=0.30degree of saturation S=78%=0.78

Q: Determine the reactions at A and B on the Fink truss shown in figure below. Members CD and FG are…

Q: Q1: - A simple horizontal curve has: A= 38° 42', St. P.I = (40+17) and coordinates of points P.C.…

Q: A small circle is tangent internally to a big circle such that AB=CD=5 cm and EF=9 cm as shown.…

Q: What is the beam deflection at point C when P = 10 kN, L = 1.5 m, E = 200 GPa, and I = 20E6 mm4? M,…

Q: SITUATION 2: The truss has the following configuration where O is 45° 10 kN 15 kN B D. M 17.5 kN 7.5…

Q: 10. For the intersection shown below draw a 3-phase traffic signal operation.

Q: An iceberg floats in sea water with 14% of its volume projecting above the sea surface. If the…

A: Volume above sea surface = 14% specific weight of sea water = 10400 N/m3 It has been asked in the…

Q: The rod ABC is made of an aluminum for which E = 70 GPa. Knowing that P = 6 kN and Q = 42 kN,…

Q: ss how you will perform a spatial-temporal research of urban land use, paying special

A: Introduction Spatial Resolution alludes to the size of the littlest component that can be…

Q: A Venturi Meter has water is flowing through the Venturi Meter, the pressure in the pipe and the…

A: Given, D = 0.2 m d = 0.06 m ∆P/γ = 0.15 m

Q: The bell crank, which is in equilibrium under the forces shown in the figure, is supported by a…

Q: The altitudes of a star at upper and lower transits of a star are 70°20' and 20°40' respectively;…

Q: The uniform concrete slab has a mass of 2900 kg. The slab is held in the horizontal plane by three…

Q: Determine the moment of inertia of the area bounded by the curve y = 9 - x² and y = 3x – x? at the…

Q: Symbols for water installations

A: Symbols for water installations:

Q: Q3: Analysis the composite structure shown in figure. The beam CD has El=40000 kN.m², the member AB…

Q: 8 mm 9 mm 18 mm 9 mm 4 mm 12 mm 5 mm For the shaded area shown and the given reference coordinate…

Q: Problem 2 Given the truss below, the cross sectional area of compression members is 700 mm2 and…

A: 1. What is the axial stress at CF in MPa? 2. What is the axial stress at HF in KPa? 3.What is the…

Q: The bell crank, which is in equilibriun under the forces shown in the figure, is supported by a…

A: Figure is as shown

Q: Situation 7 - A 6-m long fixed-ended beam carries a uniformly distributed load of 36 kN/m. Use E =…

Q: The table below gives area information on earthwork of road cross sections at three different…

Q: Equation of straight line fitting the Road length vs Number of accident as per below data is

A: Given data: Number of accident Road Length 52 2756 59 3599 86 7654 86 7740 84 7476…

Q: Refer to Problem 3.9. Determine the weight of water, in kN, to be added per cubic meter (m³) of soil…

Q: In drained triaxial compression test, a saturated specimen of cohesionless sand fails under a…

Q: is the structure statically determinate?

A: Calculation of indeterminacy of truss

Q: A design wastewater flow of 1.5 MGD containing 175 mg/L BOD (in the primary effluent) is to be…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: 2. For the two fixed-free columns having natural periods of vibration (T1) and (T2), respectively,…

A: Answer is (C) 3.0T1

Q: a) Compute for the reaction at all supports b) Draw the shear and moment diagrams (specify…

Concept explainers

Pricing Excavation and Backfill

Backfill, in construction, is the activity of returning the soil and gravel that are removed during building construction or using them again to toughen and support the foundation of the building or any other structural component.

Question

What is the percentage removal rate for 2.5 log removal (LR)?

A. 99.51%

B. 99.75%

C. 99.68%

D. 99.15

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Choose the most economical alternative in disposing non-hazardous chemical sludge using (a) PW analysis, (b) Future Worth Analysis, and (c) Annual Worth Analysis. (d) If the contract award cost increases by 20% every 2-year renewal determine the PW of each alternative. (Please make it clear, thank you) Land Application Incineration Contract First Cost, Php -130,000 -900,000 0 Annual Operating Costs, Php/year -95,000 -60,000 -120,000 Salvage Value 25,000 300,000 0 Life, years 3 6 2
do not solve it wrong, uploading for the second time, need detailed solution
A surcharge of 100 kPa is applied over a large area above the soil profile shown in the figure below. Assume that the drainage length remains unchanged during the consolidation process. Calculate the time required in months to reach a consolidation ratio of 70% at Point A after applying the surcharg
What are the factors affecting the cyclone collection efficiency?
Conduct a lock-out and tag-out activity in the oil rig to repair the drilling equipment and well-logging instruments. Identify the specific steps that you will make for the above case.
Choose the most economical alternative in disposing non-hazardous chemical sludge using (c) Annual Worth Analysis. (d) If the contract award cost increases by 20% every 2-year renewal determine the PW of each alternative. (Please make it clear, thank you) Land Application Incineration Contract First Cost, Php -130,000 -900,000 0 Annual Operating Costs, Php/year -95,000 -60,000 -120,000 Salvage Value 25,000 300,000 0 Life, years 3 6 2
Explain a hydraulic trap in landfill design? What is the difference between a natural hydraulic trap and an engineered hydraulic trap landfill
A contractor is to excavate an area of 350′ × 150′ to a depth of 9′ and haul it by dump truck to a site where it is to be used for fill. The soil will then be fully compacted. If the swell factor is 25 percent and the shrinkage factor is 18 percent. Estimate the total bare cost for the job (excavation only) using a 2½ CY front-end loader, track mounted. Consider average nation price. Use the crew below.
How many hectare will a disk plow finish in 10 hours if the effective cut is 12”/ disk at a speed of 5 kph and an average of 30% time loss
Define the term Compensation grouting.
Briefly discuss the advantages of preloading methods?
A construction company is bidding on a project comprising five high-rise buildings to be erected one after the other. The company considers the use of advanced, hydraulically operated tunnel forming systems to be purchased and used 40 times on each building over a 1-yr period of time. The tunnel forms cost $30/sf. No salvage value is expected at the end of the 5-yr project. As the two last buildings to be constructed slightly differ in their design, the forms will have to be modified at the cost of $5/sf. Periodical maintenance is expected every 80 uses at a cost of 5% of the purchase cost. Consider an annual interest rate of 4%. What is the expected average material cost per sf for each use? Hints: There is no salvage value. The average material cost has three components: purchase cost, modification cost, and maintenance cost. Purchase occurs at the start = year 0. Modification occurs at the end of the third year = year 3. Maintenance occurs at the end of years 2 and year 4.…