What is the S.G. of the unknown fluid?

Q: (6c) i. Explain the operation of a u-tube manometer ii. State three (3) advantages and three (3)…

A: Solution is attached below:

Q: Question 7 Two chambers with the same fluid at thei separated by a piston whose weight is 25 N, .…

A: Given Data→ Chambers are having the same fluid The weight of the piston is 25 N. w =25 N Dia of the…

Q: Therefore, the dimension of Reynolds number is:

A: Reynolds Number is given by, Re = ρ v DυWhere, ρ = Densityv = VelocityD = Diameterμ = Viscosity

Q: H.w:- Find the diPfrent between A eued B? in pressure

A: Applying Pascal's law: PA-600*9.81*0.6+1200*9.81*0.1+4000*9.81*0.4=PB

Q: Calculate the pressure difference between the two points РА- Рв A B oil S.G 0.91 y 10cm Hg

A: To determine the difference of pressures at points A and B

Q: nown in Fig 1, calculate the op of the tank is sealed ane the depth of the oil, h, as

A:

Q: discuss the effect of temperature on the viscosity of the liquid

A: A liquid is a kind of fluid which is assumed as incompressible in cases of ideal, that has a…

Q: s an area of 1 ane, having an ontal, with a v of oil film betw

A:

Q: a caloulaTE THE Velocire OF THE PlUID INSIDE THE TUBE. b) CaloulATE THE HeiGHT DIFFERENCE l To THE…

A:

Q: Which step of the following steps is for use of a manometric tubes to measure the * differential…

A: Given: Which step of the following steps is for use of manometric tubes to measure the differential…

Q: An oil drop with the diameter of 1mm, is in the contact with the air with the pressure of 80 KN/m2.

A: The given values are - d=1mm , Patm=80 kNm2The surface tension of oil-air is generally taken as-…

Q: The total weight of the plunger and load is 30 kN, the plunger diameter is D=200 mm. Neglecting…

A:

Q: 3- Comment on the relationship between the depth of the center of pressure and the depth of…

A: Given :-  Comment on the relationship between the depth of the center of pressure and the depth of…

Q: gate and its center of pressure

A: Given Data→ Gate AB Assumptions made in solution - (1)Density of water at standard conditions is…

Q: a conical tank having a height of 5ft and base of 12 in radius contains 0.7ft^3 of water. How much…

A: GIVEN DATA HEIGHT h=5ft Radius r=12in = 1ft ALready contain water = 0.7 ft3 WE HAVE TO FIND AMOUNT…

Q: The mass of nitrogen

A: Given; Temperature of nitrogen in a vessel of;Volume=2m3Temperature, T=288 Kheight=70 cm of Hggas…

Q: ?What is the total force lifting the tank

A:

Q: e are willing to design a simple setup for the lubrication of a rotating rod. To do so, the…

A: The power will be dissipated due to the viscous shear resistance provided by the film of liquid on…

Q: Explain in brief the mercury thread method for accurate determinations of the radius of the…

A: Introduction: Capillarity is the phenomenon of a liquid surface rising or falling relative to the…

Q: ?What is the shear force that acts on the circumference of the piston (N) Assume the variation in…

A:

Q: water, while the other arm contains both f to-water height ratio of 4. Determine the heig n that…

A:

Q: Water is flowing. Calculate direction and aproximate magnitude of the manometer reading.

A: for solution refer below images.

Q: Determine the pressure of the water in pipe As

A: Given: To determine: Pressure at A

Q: er. Find the fluid force against the surface.

A: To find Fluid force

Q: 1-What is the pressure difference between the pipes with fresh and salt water? In which of the two…

A:

Q: height of the water h which will first cause the gate to open.

A: Given: To determine height h

Q: Select the inclined manometer as the manometer type and oil as the manometer fluid from the upper…

A: Select the inclined manometer as the manometer type and oil as the manometer fluid from the upper…

Q: d its kinematic viscosity in m?/s and in stokes

A: To find Absolute viscosity Kinematic viscosity

Q: You have the thin walled pressure vessel shown. Given

A: Given that ,  Inner radius Ri=3.00ftWall thickness t=0.25in =0.020833 ft Length L=10 ft

Q: (c) Determine the height of the water at 60 "F will rise due to capillary action in a clean…

A: given data,water temperature=60°Fdiameter of tube=0.25 inchsurface tension=5.03×10-3 lb/ft2specific…

Q: the specific volume of the fluid is ?m3/kg

A:

Q: mass of water

A: Given;  Total pressure is= 100 KPaTemperature is= 300CGiven that,  Saturation pressure of water at…

Q: What time (in second) is required to fill the circular tank with incompressible ?water from h= 2 m…

A:

Q: At what temperature in °F at which liquid water has the highest density?

A: Ans)  39.2  F

Q: the oil is linear then the thickness

A:

Q: minimum depth of water in the tank.

A: To determine the minimum depth of water in the tank

Q: a)Negligible flow of heat, Hont flou indenendent of ti

A: steady state heat flow depend on

Q: This pertains to the mass divided by the volume of the fluia O Capillary Rise

A: As we knowMass density  is defined as the mass of the fluid per unit volume occupied by the fluid.

Q: A liquid of viscosity 0.1 Ns/m2 and sp gr. 0.9 is filled between two horizont

A: Given:Viscosity of liquid, μ=0.1 Ns/m2specific gravity=0.9Density of liquid,ρ=0.9×1000=900…

Q: direction, acting on the plug if it is inverted and if the tank contains 600mm of oil having an SG…

A:

Q: 2) Describe the different types of fluids and illustrate them on a graph of shear stress vs du/dy.…

A: Answer for Question (2) Different types of Fluids :

Q: Describe a Newtonian fluid

A: A fluid is a liquid, gas, or other substance that continually deforms (flows) under an applied…

Q: ontains oil and w ultant force that b the side has a wi- neasured from the

A:

Q: Ultra-Heavy crude oil has a density of approximately 925 kg/m3, specific gravity? And what is its…

A: Density of crude oil  = 925 kg/m3 Specific density = density of substance / density of water

Q: A square tube is welded on one side and will be filled with liquid of a relative density of

A: Liquid when enclosed within a container makes a pressure inside and then exerts force on the walls…

Q: Derive the expression for the capillary rise.

A: Capillary rise: When a thin tube is inserted into the water, the water starts flowing in the narrow…

Q: Explain about PRESSURE IN A FLUID.

A: Fluid pressure is finding force... per unit area  It can be caused by gravity, acceleration,... or…

Q: Both pistons are moving to the left, but piston A has twice the speed of piston B. What happens to…

A:

Q: ssure. If the reading che distance between the e fluid is (a) mercury (p on t

A: