What is the total weight of steel reinforcing mesh, 6 x 6 10/10 that is used for a concrete slab that measure 12,750 square feet?

Q: An open rectangular Bốx is to bê made from a 9 x 12 inch piece of tin by cutting a square of side x…

A:

Q: Example 4: Draw the plan below as 3D with walls height of 3m 7.75 0.90 5.00 2.00 4.00 4.00 4.50…

A:

Q: How many board feet are contained in a piece of lumber measuring 6" x 6" x 16"?

A:

Q: When the length of the board is in inches, what is the formula used for B.F? _____

A: Board foot ( B.F.)  is the standard unit used for measurement of lumber

Q: How much "steel per foot" is there in a slab with #4 bars (area=0.2 in2) spaced 8 inches on center?

A: Number 4 rebars, Ab= 0.2 in2 Spacing= 8 inches on center

Q: Q4: Find the total area A of the shape below in Figure 3?

A: Given data- A semi-circle of radius 'r' as shown- To Find- The total area of the shape.

Q: Define the equation or formula used to determine the shear force V per unit width of the mat caused…

A: A mat or raft footing is a slab that is resting on the ground to transfer large loads to the soil,…

Q: identify  the different structural parts of a two story house and illustrate with labeling in an…

A:

Q: What is the weight of the reinforcement in the longitudinal direction of the roof shown in the…

A: Given data, Longitudinal reinforcement:  1. #10@300 mm c/c 2. #12@250 mm c/c Unit length weight: 1.…

Q: 2. A surveyor measured the distance between two points marked on the plan drawn to a scale of 1cm =…

A: Given data in question  Wrong scale Correct Scale Measured distance  To find out  Correct length

Q: What is the general range of L/G ratios?

A: L/G ratio stand for the liquid to gas ratio. which is the ratio of the waste slurry to the flue gas…

Q: An interior wall of a building is made up of metal studs with 5/8 in. wallboard on each side.  See…

A: Given: Width of the metal studs=58inWidth of the stud=338inThen,Width of metal studs 58in on both…

Q: dimensional lumber. What is the angle of the roof? What is the height of the roof? If there is 8"…

A: Data given are: Pitch of the roof = 4/12=1/3 Span = 24 ft Overhang=8" We need to find out  1. Angle…

Q: Given a partial wood wall stud that is to be covered with marine plywood and lumber to be used for…

A:

Q: Support straps for a duct are each 1 foot 2 inches long. How many supportstraps can be cut from a…

A:

Q: How would trusses as part of the construction of a house be measured?

A: A truss is an important part of the construction. A truss is a group of beams connected together…

Q: Compare the frame design in Figure 31 with the one in Figure 32. (b) If you use steel beams as…

A: Given : Cross bracing: Simple triangulation of frame:

Q: Find the dimensions of the square base box which have maximum volume possible with just 10 m² of…

A: To find:-  the dimensions of the square base box which have maximum volume possible with just 10 m²…

Q: Three boards, each 2 in. thick, are nailed together to form a beam that is subjected to a vertical…

A:

Q: Problem 10. DETERMINE THE DIMENSION FOR THE PLYWOOD BOX BEAM FIGURE SHOWN. y = A1 = 21 x 4.5 41 = A₂…

A: Given data:- The expression Area A1=21X4.5 The expression Area A2=(21-6)×3.5=15×3.5

Q: 2.0 Refer to the Figure 2, measure the total of height to estimate the building cost. X = 2.5 m 6.8m…

A: The total height of the building as per the values given in the figure is from the top of the…

Q: When erecting a steel building structure, what is the maximum height that the erection deck can be…

A: A building that is constructed by using steel metals is known as a steel building structure. In the…

Q: What standard diameter deformed bar used as stirrups for beam?

A: A stirrup is  a closed loop of reinforcement bar. Its main purpose is to hold the reinforcement bars…

Q: I need a long explanation with details like a project on “ultra high strength concrete”

A: Concrete is versatile material which is used in construction industry due to its high workability…

Q: weight of the block?

A:

Q: Determine the estimated weight of an A-36 steel plate size 3/16” x 6” x 20

A: Given data in question  A-36 steel Plate size To find out  Weight of A-36 steel   Density of A-36…

Q: a. What is the length of the stretchout in inches?

A: At first an in. was the width of a man's thumb. In the 14th century, King Edward II of England ruled…

Q: (b) Figure shows two beams of the same shape and size. Which one is safer to walk over? Explain…

A: As shown in above figure the transverse load is acting on the beam and for the safe walking on the…

Q: What is the economic dimension(length and wid) of the rectangular beam as a substitute for the T…

A: While designing T beam there are 2 criteria: 1. When neutral axis lies in flange the beam it is…

Q: Determine the lengths installed for continuous bars in FTB in meters.

A:

Q: How did you come up with the size of the rectangular cross section b = 16 inches and h = 24 inches…

A: Answer  We need to provide minimum required gross section area of rectangular section Ag = 166.67…

Q: 42. How many square feet of forms are needed to construct the columns shown in Figures 5-26 and 5-…

A: Consider the footing placement as in Figure (1).

Q: what is the minimum work required to raise a 1000 pounds piano from a street level to a window at 70…

A: Weight of Piano is 1000 pounds Piano is to be lifted at a height of 70 ft

Q: (b) Figure 5 shows a timber column and several forces acting on it. As an engineer, you were…

A: Given , F1= 250N F2= 500N

Q: b) Darcy is given a scale diagram of the completed truss bridge. Each vertical beam in the scale…

A: For the first beam,  Dimensions are: Depth= 4cm Width= 15 cm Length= 1.4m

Q: What is the weight (Ibf) of a cube of stainless steel with 16.5 cm on each edge?

A: Given: Density of stainless steel, ρ=7860 kg/m3 Edge, a=16.5 cm=0.165 m

Q: Should one way slab be used for Steel Deck if the slab is a Square

A: Yes. Generally that is true.   The beauty of steel structures lie behind the short construction…

Q: The shape of the Gateway Arch in St. Louis is approximately a parabola with a base and a height…

A:

Q: Given a partial wood wall stud that is to be covered with marine plywood and lumber to be used for…

A:

Q: Q2) For the shown beam, calculate beam web yielding capacity? 1-178X102X19 1-305 X 127 X 37

A: b (Width of section on top of beam) = 101.8mm

Q: discuss skewness

A: Mathematically to describe skewness, it is an asymmetry or distortion seen in a graph which deviates…

Q: what is the size of single  exterior door and single  interior door

A: It is required to mention the size of single exterior and single interior door.

Q: What are the Danish formula and the Gates formula? Explain.

A: Danish pile driving formula: The danish formula is used for the pile driving bearing capacity:

Q: be (in inches) if the volume of the box is to be maximized?

A:

Q: Given a partial wood wall stud that is to be covered with marine plywood and lumber to be used for…

A:

Q: Which two curves can be used to calculate modulus of elasticity (E)? Draw the curves and explain

A: Modulus of elasticity is simply the slope of the stress-strain line. Considering a non linear curve,…

Q: Because answers are provided, work must be thorough and clear! 1,000.0 Extra Credit: Bridge Truss 0.…

A: i have solve in great detail  ok plz go through it

Q: When the length of the board is in feet, what is the formula used for G.F? _____

A: Unit conversions ; 1 feet = 12 inches  1 inch = 1/12 feets