Answered: What is the value of Rx in kQ to be…

What is the value of Rx in kQ to be connected in parallel to a 75 kO to reduce the value of total resistance to 10 kQ ? O 11.7 О 15.7 O 7.5 О 12.7

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter3: Electric Circuits

Section: Chapter Questions

Problem 6RQ: The current draw in a series circuit is _____. a. the sum of each load in the circuit b. the same...

See similar textbooks

Related questions

Q: 6. Reduce the block diagrams below to a single transfer function, T=U2/Ui. A (a) D (b)

A: For the given question we have to find the transfer function

Q: Explain any two signal presentations in the measurement system with neat diagrams.

A: Measurement system is defined as the system which is used to measure required terms in some defined ...

Q: DEGREE: ELECTRICAL ENGINEERING SUBJECT/COURSE: AC CIRCUITS NOTE: Please solve in this way. 1. Pl...

A: In this question ,balanced delta connected load phase current is given...We have to find out line cu...

Q: Input Count 1 1 2 3

Q: Vus ELC 260S Tutorial 1 Sem 1 2022.doc - Protected View Saved to this PC - nces Mailings Review View...

Q: The transistor lead that serves as a source charge is known as?

A: Note: As pert the policy we can answer only one question please re-upload the remaining question as ...

Q: Q// For the two-bus power system shown in Fig.(PA) Slack bus (G1 V1= 1.0L0° pu Sg2 = 0.2 +j0.05 pu B...

A: Answer -

Q: Calculate the capacitive reactance in Q-km of a bundled 60 Hz three-phase line having three ACSR Rai...

A: Conductor- A conductor is a material which contains a significant population of free electrons that ...

Q: A 500 kVA, 2300/230 V, 60 Hz transformer was open- and short-circuit tested. The data is provided be...

Q: An RC circuit (see Figure 4) contains a resistor (10 ohms) and a capacitor (0.2 F) linked in series ...

Q: What is the attenuation in Nepers for a 1 km length of RG-58 A/U coax with loss of 5dB/100ft?

Q: differentiator has an input of sin wt calculate the output voltage given the following values; R = 1...

A: In this question we will find output voltage for differentiator.....

Q: Solve the following problems completely. Box and Round-off your final answer in nearest two decimal ...

Q: 3. Consider a three-wire Y-Y circuit. The voltages of the source are Van V3 o Vrms, Vin V3 <- 208 12...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: it. 20v 8V Irleal 个十 20v

Q: A load draws current from a voltage source. The equation of current and voltage are I = 10 cos wt an...

A: The solution is given below

Q: Suppose an amplifier has an open-loop voltage gain of 20, an input impedance of 100Ω, and an output ...

A: Use basic circuit law , voltage division rule to find out the output voltage.

Q: The sequence components of phase A currents are: • lao=0.47+j1.49A • la1=18.4 cis-31.6°A • la2=3.23 ...

A: To get the actual line currents using sequence components we us the following formula: IaIbIc=1111α2...

Q: A cable has a VSWR of 10. If the minimum voltage along the cable is 20 volts, what is the maximum vo...

Q: Given the UJT relaxation oscillator circuit below. The value of Rbb is 4.06kN, the intrinsic standof...

Q: Find I Using Nbrton's theorem 360 80V

Q: Consider the series RL circuit shown below. The emf is given by ?=10e−0.1t and it’s given that the i...

Q: Find I Using Norton's theorem 360 80V

A: Norton and Thevenin are the two important electrical circuits theorem which reduce the conplex circu...

Q: *9. Determine Vo, and Vo, for the networks of Si 4.7 kN Ge Si 1.2 k2 +12 Vo ,Voz -10 Vo- GaAs 3.3 kN...

A: Part (a) - The circuit diagram is shown below, We know,Vsi = 0.7 VandVGe =0.3 VConsider that the S...

Q: Given the following circuit, compute for the value of current I 60 12 0 www 80 20 20 V 40 10 2 50 ww...

Q: QI Using branch-current analysis, find the magnitude and di- reetion of the current through cach res...

Q: 4 Determine vỵ in the circuit of Fig. 3.11. using nodel analysis 2 A 2Ω 8 Ω + 10 N FIGURE 3.11

Q: The conductors of a 10 km long, single phase, two wire line are separated by a distance of 1.5m. The...

Q: In a standard parallel RC circuit, the supply voltage is v(t) = 6sin(@t), %3D f= 50 Hz, R = 22 and C...

A: Given data, Parallel RC circuit vt=6sinωtf=50 HzR=2 ΩC=5 mF

Q: The electrons in the outermost orbital determine the physical and chemical properties of the element...

Q: Determine the Fourier series of f(t) = 2 - 2t -π < t < π Justify your answer when necessa...

Q: A certain silicon UJT has an intrinsic standoff ratio of 0.58. This UJT is used in an experimental c...

A: Given Vp= 14.09 v x=0.58 Assume cut off voltage Vc= 0.6v Find VBB=?

Q: A coil with an air core has a resistance of 14.70. When it is connected to a 42V, 60 Hz ac source, i...

Q: zero. a. Find the charge on the capacitor at t=6ms b. Find the voltage on the capacitor att= 10ms A)...

Q: νουτ +14V +5V ov

A: The solution is given below

Q: Please show all steps A parabolic dish antenna has a diameter of 5 meter, operating at 30 GHz frequ...

A: Given, Parabolic dish antenna has Diameter (D) = 5 meter Operating frequency (f) = 30 GHz

Q: 4. O Find RT X I Sor cet shown? 2KA fov T

A: In this question, A circuit is given. Find the total equivalent resistance and total current in th...

Q: The second question: a wheel rotates from rest with uniform angular acceleration, and its speed reac...

Q: 2. Find I in the circuit of using the superposition principle. 8 V (+ 2 A 6 V

A: According to superposition principle, output across the load is algebric sum of individual outputs w...

Q: 540 conductors. The armature resistance is 0.1 2 and the drop at each brush is 1 v. find (i) the use...

Q: Ahe sending end coltage of Calcul ate three phase 5ottz, l00km cong Aine Supplying load of 30Miet at...

A: The solution is given below

Q: In a series RC circuit the voltage across the capacitor

Q: Find the lapiare transform using the definihon/ integration metnod.

Q: Calculate the number of stages and number of switching nodes in a Multistage Omega Network with 16 i...

A: The given Omega Network is 16x16. The number of stages in the NxN omega network is given by the form...

Q: In the given circuit, Vx = 6.5 V and Rx = 50. R 0.1V 3.32 V2 Referring to the given circuit, determi...

Q: R1 L1 R2 C1 5000 795.77mH 2000 5.53µF V1 R3 L2 300Vrms 60HZ 0° 530.52mH

A: Maximum power theorem: This states that in the circuit load resistance is equal to the source resist...

Q: 2.The voltage across a 10 Q inductive reactance is: v(t) = 100 sin wt. a. What is the sinusoidal exp...

Q: R1 L1 R2 C1 5000 795.77mH 2000 5.53µF V1 R3 300Vrms 60HZ 0° L2 530.52mH

A: Maximum power theorem: This states that in the circuit load resistance is equal to the source resist...

Q: what is this element that is capable of generating electrical energy under certain conditions

A: Electrical energy is the ability of an atom's charged particles to perform an activity or move an ob...

Q: A half-wave rectifier circuit employing an SCR is adjusted to have a gate current of 17.86mA. The fo...

Concept explainers

Current Division Method

The generalized current divider formula is given by the following relation below,

Question

What is the value of Rx in kQ to be connected in parallel to a 75 kO to reduce the value of total resistance to 10 kQ ?
O 11.7
О 15.7
O 7.5
О 12.7

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

step 3 second is the following line correct G = tf((abs(a-5i)^2), [1 (a+5i) (a-5i)]);
un Could you show me how part III answer is 0.33x10^9 and wo=166x10^6 and Part IV's answer (-2.7x10^9)et^(-ã/2)t
Determine iL(t) in the circuit in Figure 6.12
Find the following a) find the voltage and current of AB BC CD b) Find RT c)Transfer the ground from Node D to Node C. Then measure again the voltage and current of AB BC CD d) Remove 2kohm resistor connected to nodes A and B ground is at node D 1) Original circuit
In the series parallel circuit in figure 1 . Calculate the total resistance, total current , and V1. Whenswitch 1 is closed
The following data are given in connection with the series - parallel circuit of Figure 1; E = 97.5volts, R1= 18 ohms, R2 = 9 ohms, R3= 16 ohms, R4= 14 ohms, R5 =7 ohms, I₂=2.5 amp. Calculate (a) the resistance of R6, (b) the total equivalent resistance of the circuit, (c) the total power.
Calculate the resistance of the following combinations: a) 15 Ω in parallel with the series combination of 5 Ω and 10 Ω, b) 5 Ω in series with the parallel combination of 10 Ω and 15 Ω.
Please use parts (i) and (iii) to complete Table 2.0 for the circuit shown in Figure 2.0a and 2.0b, respectively. Please include all calculations done. Ignore the MultiSIM input sections when completing Table 2.0. Thank you very much!
My answers here are 1.8421 V and -0.6315 V verify
For the voltage-divider bias network of Figure 1: a. Determine re. b. Calculate Zi and Zo. c. Find Av. d. Repeat parts (b) and (c) with ro = 25 k.
17. Two storage batteries are connected in parallel to supply a load having a resistance of 0.1 Ω. The open-circut e.m.f. of one battery (A) is 12.1 V and that of the other battery (B) is 11.8 V. The internal resistances are 0.03 Ω and 0.04 Ω respectively. Calculate (i) the current supplied at the lead (ii) the current in each battery (iii) the terminal voltage of each battery. [(i) 102.2 A (ii) 62.7 A (A). 39.5 A (B) (iii) 10.22 V]
HW. Determine the value R, of that will draw the maximum power P, from the rest of the circCuit in figure below. Calculate the maximum power. Answer: 4.22 2, 2.901 W.