When seeking to measure the voltage of a wall outlet (120 Volts AC) an electrician needs to do the following to prepare the Simpson 260 meter for measurement (inoer the words to make the following statements correct). a. Set the function switch to jack. b. The black lead should be inserted in the jack. c. The red lead should be inserted in the position. d. The range switch should be set to the

When seeking to measure the voltage of a wall outlet (120 Volts AC) an electrician needs to do the following to prepare the Simpson 260 meter for measurement (inoer the words to make the following statements correct). a. Set the function switch to jack. b. The black lead should be inserted in the jack. c. The red lead should be inserted in the position. d. The range switch should be set to the

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter16: Branch Circuits For The Garage And Outdoors

Section: Chapter Questions

Problem 5R

See similar textbooks

Similar questions

a. The Code requires a minimum of two small-appliance circuits in a kitchen. Is it permitted to connect a receptacle in a dining room to one of the kitchen small-appliance circuits? _______________ What Code section applies to this situation? _______________ b. Are outdoor weatherproof receptacles permitted to be connected to a 20-ampere small-appliance circuit? _______________ c. Receptacles located above the countertops in the kitchen must be supplied by at least _______________ 20-ampere small-appliance circuits.
How many lighting branch circuits are provided in this dwelling? __________ a. What is the minimum load allowance for small-appliance circuits for dwellings? See NEC 220.52(A). __________ b. An individual 15-ampere branch circuit is run to the receptacle outlet behind the refrigerator instead of connecting it to one of the two 20-ampere small-appliance branch circuits that are required in kitchens. For this separate circuit, an additional 1500 volt-amperes (shall) (does not have to) be added to the load calculations for dwellings. (Circle the correct answer.)
What is the 277-volt–single-phase–60-hertz system used for? Select one: A. RECEPTACLE BRANCH CIRCUITS B. LIGHTING BRANCH CIRCUITS C. MOTOR BRANCH CIRCUITS D. RESIDENTIAL BRANCH CIRCUITS
GFCI breakers or GFCI receptacles are relatively expensive. How would you arrange the wiring of the garage circuit B23 to make as economical an installation as possible that complies with the Code? __________________________________________________ _______________________________________________________________________ _______________________________________________________________________ _______________________________________________________________________
Sketch the symbol for a telephone outlet.
ANSWER AS BEST AS YOU CAN FOR A THUMBS UP A sole owner (without employees) of a contracting firm was performing maintenance and repair work for a cork processing company. He was working on the motor for a Nu Vac 480-volt, 14.9-kilowatt pneumatic roof-mounted conveyor system. He found the motor to be running roughly. As he was examining it, the motor tripped the electric starter. He went to the electrical room on the third floor of the building to open the Square D 60-ampere, standard-duty disconnect switch rated at 600 volts. An explosion and electrical fault occurred, involving not only the switch but also a portion of the surrounding electric equipment. The ensuing electric arc burned the contractor. He was hospitalized with first- and second-degree burns to his right hand and arm and his face.…
A 555 timer IC is connected as following: pin 1 with GND, pin 8 with Vcc of 15 volts, 12 volts is applied for pin 6 and 6 volts is applied for pin 2. 1. What will be the voltage value on pin 3? 2. Prove your answer with required calculation and explanation.
When the nameplate of HVAC equipment is marked “Maximum Size Fuse—50 Amperes,” is it permitted to connect the equipment to a 50-ampere circuit breaker with no 50-ampere fuse in the circuit? Explain.
what wire size is needed on a one 20 amp, 120-volt laundry branch circuit? what wire size is needed on a one 20 amp, 120-volt garbage disposal circuit?
A residential air-conditioning unit is installed in the attic. a. Is a lighting outlet required? __________ b. What Code section applies? __________ c. If a lighting outlet is required, how shall it be controlled? __________ d. What Code section applies? __________ e. Is a receptacle outlet required? __________ f. What Code section applies? __________
Refer to the specifications in the back of this text following Chapter 33. a. What electrical codes must be conformed to? ________________________________________________________________________ ________________________________________________________________________ ________________________________________________________________________ b. What is the wiring method to be used in the workshop? ________________________________________________________________________ c. What size conductors are to be used for the lighting branch circuits? ______________________ AWG the small-appliance branch circuits? ______________________ AWG d. What section of the specifications tells us the size of the service entrance to be installed for this residence?
draw a pictorial/wiring diagram of the jumpers connected to the front panel of a computer system unit.