When 0.39 mol of solid CO2 is reacted with 0.23 mol of CH3MgBr in an ether solvent, the resulting product is isolated in aqueous solution (assuming 100% yield) and any excess CO2 is removed. Following this, 0.13 mol of HCl (aq) is added. What is the resulting solution's pH? Please note that you will need to research a pKa value for this query, and your answer should be reported to two decimal points.

When 0.39 mol of solid CO2 is reacted with 0.23 mol of CH3MgBr in an ether solvent, the resulting product is isolated in aqueous solution (assuming 100% yield) and any excess CO2 is removed. Following this, 0.13 mol of HCl (aq) is added. What is the resulting solution's pH? Please note that you will need to research a pKa value for this query, and your answer should be reported to two decimal points.

Chemistry: Principles and Reactions

8th Edition

ISBN:9781305079373

Author:William L. Masterton, Cecile N. Hurley

Publisher:William L. Masterton, Cecile N. Hurley

Chapter20: Chemistry Of The Metals

Section: Chapter Questions

Problem 34QAP: The equilibrium constant for the reaction 2CrO42(aq)+2H+(aq)Cr2O72(aq)+H2O is 31014 . What must the...

See similar textbooks

Similar questions

The solution of total volume 0.50 L was prepared by the addition of 0.10 moles of KF to sifficient water. What are the major species of the solution and pH ?
As part of the analysis of water samples, the hardness of water is commonly measured and calculated. It is commonly expressed in ppm by mass (parts per million) of CaCO3. Parts per million is also equivalent to milligrams of CACO3 per liter of water. In a sample taken by an environmentalist, he was able to observe a hardness count of 205 mg CacO3/L. Given this hardness count of the sample, what is the molar concentration of Ca2+ ions in the water sample?
A test tube contains the following chemical equilibrium: N2O4(g) + 59 kJ ⇌ 2NO2(g). You notice that the colourless contents of the test tube turn brown. Provide two realistic reasons as to why this change would occur in a laboratory setting. Support claims with evidence from course concepts
A brand of window-cleaning fluid is composed of ammonia solution, water, a colouring agent, and a very small quantity of soap. It has 0.15 mol/L concentration of NH3(aq). What is the pH of this fluid?
The pH of a 0.2 M solution of CuSO4 is 4.0. Write chemical equations to explain why a solution of this salt is neither basic [from the reaction of SO42-(aq) with water] nor neutral, but acidic.
Surface water in an open area of the Indian Ocean adjacent to Kenja has an alkalinity 2320 micromoles/liter and a total carbonate concentration of 2.03 x 10^-3 moles/liter. Calculate the concentrations of HCO3- and CO32-, and also the pH of this sea water.
Determine the pH and concentration of all species at equilibrium for the basic 5-fluorouracil species (C4HFN2O22-). Justify the use of approximations if necessary.Provide the equation for the mass balance of this solution. C4HFN2O22-= 0.30 M
Calculate the pH, pOH, and fraction of solute protonated or deprotonated in the following aqueous solutions: (a) 0.150 M CH3CH(OH)COOH(aq) (lactic acid), (b) 2.4 x 10-4 M CH3CH(OH)COOH(aq), (c) 0.25 M C6H5SO3H(aq) (benzenesulfonic acid). The appropriate values for pKa or pKb are given inthe table.
If the molar solubility of Tl2S at 25 oC is 5.31e-08 mol/L, what is the Ksp at this temperature?Ksp = (b) It is found that 9.14e-08 g of Sc(OH)3 dissolves per 100 mL of aqueous solution at 25 oC. Calculate the solubility-product constant for Sc(OH)3.Ksp = (c) The Ksp of Cu3(PO4)2 at 25 oC is 1.40e-37. What is the molar solubility of Cu3(PO4)2?solubility = mol/L
The first step in purifying the urine collected on the ISS is to treat every liter of urine with 20 mL of 1.0 M H2SO4. To simplify the calculations, lets assume that urine is water. a) What is the pH of a solution of 20. mL of 1.0 M H2SO4 added to 1.00 L water? To determine this, you can safely assume that 100% of the H2SO4 reacts to form H3O+ and HSO4- ions. Use pKa2 (1.92) to determine if any more protons are added to the solution from HSO4-.
Determine the molar solubility of CaF2 in a 0.10 M CaCl2(aq) solution. Clearly identify any assumptions/approximations that you make.
State the limits to the generality of the expression for estimating the pH of an amphiprotic salt solution. Suggest reasons for why these limitations exist.