Answered: When a line was terminated by any other…

When a line was terminated by any other impedance than the characteristi Select one: O A Totally absorbed O B. No one is correct O C. Reflected

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.35MCQ: The affect of the earth plane is to slightly increase the capacitance, and as the line height...

See similar textbooks

Related questions

Q: (e) A 3-phase double circuit line is shown in the given figure. The diameter of each conductor is 2…

A: In this question, Determine the capacitance and chargeing current? We know Charging current I=…

Q: 1. What are the factors which governs the performance of transmission line? 2. How do you classify…

A: 1..>> The performance of the transmission line depends on parameters like :- Resistance of…

Q: For a lossy transmission line, the characteristic impedance does not depend on a) The operating…

A: Characteristics impedance is defined as square root of a ratio of inductance to capacitance. Zc =…

Q: 13.) In practice, what would happen to the transmission line voltage when it is heavily loaded and…

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: What is the importance of the inducatance in the transmission line?

A: The inductance is expressed as the ratio of the flux linkage with the magnitude of the current. It…

Q: What is the common power line transmission frequency?

A: The explanation is as follows.

Q: A lossless transmission line having a length of 100 metre is terminated by a resistive load of 200…

A: we need to find out transmission loss and return loss.

Q: In the analysis of Short Transmission Lines, the Lines should be in which type of Three-Phase…

A: SOLUTION- for short transmission lines show three phase connection used constellation diagram

Q: Using an end short circuit parallel side line impedance matching circuit, impedance matching is…

Q: Question 03: What is the difference between balanced and unbalanced line transmission lines, show…

A: We need to state the differences between balanced and unbalanced transmission lines.

Q: Explain what will happen to the characteristic impedance when the spacing between the center of two…

A: We know direct formula of two conductor transmission line.

Q: A lossless transmission line is terminated in an open circuit. The sending end is ener- gized by a…

A: . A lossless line is defined as a transmission line that has no line resistance and no dielectric…

Q: Calculate the voltage reflection coefficients at the terminating end of a transmission line with a…

A: Voltage reflection coefficient is determined based on characteristics impedence and load impedence…

Q: 1/In the Transmission Line Simulator, the Transmission Line is connected in Nominal-Pi Circuit.…

A: According to the question we have to discuss about transmission line simulator,the Transmission Line…

Q: A three phase 60HZ, 60kV transmission line consisting of 3 conductors are placed at the corners of a…

Q: 75 Ω lossless line is terminated in error with a 93 Ω resistor. A generator sends 100 mW down the…

Q: Voltage Regulation (VR) is the change in the voltage at the receiving end of the line when the load…

Q: For medium transmission line under light load or no load condition the receiving end voltage is…

Q: The towers of height 30 m and 90 m respectively support a transmission line conductor at water…

Q: characteristic impedance of Zo=302, load reflection coefficient is 0.5 .What is the load impedance?

Q: When a lossless line is terminated with an arbitrary load impedance ZĻ, then it : a) causes wave…

A: Every transmission line has a characteristic impedance (Zo). Usually, a transmission line is always…

Q: If a transmission line has to be designed with an ultimate strength 8000 kg and a safety factor of…

A: Given, l=275 m T=8000 kg w=2 kgmwi=0.7 kgmww=0.95 kgm where, l is the length of span, w is the…

Q: Impedance matching is provided at D = 0.074? and L = 0.094? values for an unknown load using the end…

Q: A lossless transmission line with Zo=78 [Ohms] is terminated with load ZL=39+j62.4 [Ohms]. If the…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: In the analysis of Short Transmission Lines, the Lines should be in which type of Three-Phase…

A: Choose the correct option In the analysis of short transmission line, the lines should be in which…

Q: For a 220 KV, 200 km lossless long line the receiving end voltage at no-load is approx (а) 220 KV…

A: Given: Sending end Voltage of transmission line (Vs)=220 KV Length of the transmission line (l)=200…

Q: Derive the expression for the receiving end power in the voltage control method.

Q: In a short transmission line resistance and inductance is considered as both lumped and distributed…

A: In this we need to tell that given statement is true or false.

Q: The char. impedance of the trans. line is 50-Ohm and the resistance of it is 0.1Ohm/meter. What will…

A: For the distortion less transmission line the attenuation constant is independent of the frequency.…

Q: Example 1: For the lossless TL shown in below with length l, let Zg = 0 and ZR = 3Z9. Use Zig-zag…

A: 1)

Q: 1- what do you understood about STAR connection? 2- What are the relationships between the Line…

Q: What is the percentage voltage regulation of short transmission line if its sending end and reciving…

Q: A lossless transmission line has Z₁ = 100 £, terminated by an unknown impedance. The termination is…

A: Given, A lossless transmission line has Z0=100 ΩVSWR=5

Q: The value of the phase constant for the entire transmission line (BI) in degrees is:

A: Most of human energy requirement is meet by generating electrical energy. Once electrical energy is…

Q: For a lossy transmission line, the characteristic impedance does not depend or a) The operating…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: If a transmission line has to be designed with an ultimate strength 7000 kg and a safety factor of…

A: Given Length of span (l) =300 m T= tension in the conductor Wt. of conductor per meter (W) =2 kg…

Q: What is the losses in the transmission lines?

A: There is no system out there in the real world which is 100% efficient, so as the transmission lines…

Q: The per-phase line loss in a 40 km long transmission line is not to exceed 60 kW while it is…

Q: A transmission line has a span of 150m between level supports of 16 meter height. The ground…

A: Span is 150 m Height of the tower is 16 m Ground clearance is 95% of the tower of height.

Q: A lossless transmission line is terminated in an open circuit. The sending end is ener- gized by a…

A: Note: " Since you have asked multiple question, we will solve the first question for you. If you…

Q: Refer to the lossless transmission line shown in Figure 11.49. (a) Find I and s (b) Determine Z, at…

A: We have given Refer to the lossless transmission line shown in given figure (a)Find τ and S (b)…

Q: A lossless transmission line having 50 Ω characteristic impedance and length λ/4 is short-circuited…

A: We know that the input impedance for a loss less transmission line for a quater wave λ4 is given…

Q: A lossless TL with characteristic impedance of to is terminated in Zv=3Z0. use crank diagram to…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: a) A line has a characteristic impedance of 307.70 and a termination resistance of 600n. Assume that…

A: Note: Since you have posted a question with multiple subparts, we will solve the first three…

Q: Explain (brief description) what will happen to the characteristic impedance when the spacing…

Question

When a line was terminated by any other impedance than the characteristi
Select one:
OA Totally absorbed
O B. No one is correct
OC. Reflected

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

A three-phase 50 Hz double circuit as shown below, assumed that the line is completely trasposed. The diameter of each conductor is 2.76 cm. Find the capacitance to neutral in juF /km a b a b' --- 6m 6m 6m 6m 6m
A three-phase 50 Hz double circuit as shown below, assumed that the line is completely trasposed. The diameter of each conductor is 2.76 cm. Find the capacitance to neutral in uF/km b O O O O - -- 6m 6m 6m bm bm
Paragraph Styles The power factor must be close to in the transmission lines will be reduced To insure that losses D(Ctrl) -
ば 52+GS+13
When we short Vsig , Rsig why does not shrorted and it should be apart of the source ?
The affect of the earth plane is to slightly increase the capacitance, and as the line height increases, the effect of earth becomes negligible. True False
A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight 1-The capacitance in uF/km without effect of ground is 2-The capacitance in pF/km with effect of ground is
For b) what is Vry, Vbr, Vyb? Why is Vyb phase -90 degrees and Vby phase 90 degrees?
If the first and the third reflection coefficients of a matched line are 0.2 and 0.01, then the total reflection coefficient if quarter wave transformer is used for impedance matching is: O a. 0.2 O b. 0.21 O c. 0.2+j*0.01 O d. 0.19 O e. 0.2-j*0.01 O f. 0.01
In a balanced three-phase four-wire circuit, when the current in each line is I[A], the current in the neutral conductor is said to represent I0 ampere.If the phase voltage of the circuit is only the fundamental wave and the third harmonic, what is the current of the fundamental wave and the third harmonic?
not palagarized
A single phase line has two parallel conductors 2m apart. The diameter of each conductor is 1.2 cm. Calculate the loop inductance/ phase/ kmoftheline.