When discussing shift problems, Technician A says that worn or broken engine and transaxle mounts can cause a transaxle to have shifting problems. Technician B that poor shift boot alignment can cause a transaxle to jump out of gear. says Who is correct? A. A only C. Both A and B B. B only D. Neither A nor B

When discussing shift problems, Technician A says that worn or broken engine and transaxle mounts can cause a transaxle to have shifting problems. Technician B that poor shift boot alignment can cause a transaxle to jump out of gear. says Who is correct? A. A only C. Both A and B B. B only D. Neither A nor B

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter44: Four- And All-wheel Drive

Section: Chapter Questions

Problem 6ASRQ: Technician A says that a seized shift linkage may cause the transfer case to operate only in 4WD....

See similar textbooks

Similar questions

When discussing shift problems,Technician A says that worn or broken engine and transaxle mounts can cause a transaxle to have shifting problems.Technician B says that poor shift boot alignment can cause a transaxle to jump out of gear?
Technician A says that broken or worn engine and transaxle mounts can cause a transaxie to have shiftinf problems.Technician B says that poor shift boot alignment can cause a transaxle to jump out of gear.Who is correct? a.Technician A only b.Technician B only c. both A and B d. Neither A or nor B.
What is the importance of studying how to perform assemble/disassemble manual transmission?
32. Technician A says hypoid gearset are only used in RWD vehicle drivetrains. Technician B says hypoid gearset multiply torque. Which technician is correct? A- Technician A B- Technician B C- Both A and B D- Neither A nor B.
What is the importance of studying on how to pull-out and mount manual transmission?
Explain the role of shift rails and shift forks in theoperation of a transmission or transaxle.
A clicking noise during transmission/transaxleoperation may be an indication of .
The typical RWD drive shaft rotates how many times faster than wheels
List five things that could cause incorrect shift times and poor shifting quality
Which of the following would not cause noise while driving in 2WD under a heavy throttle? a. Faulty ignition switch b. Worn transfer case clutch c. Inoperative locking hubs d. Bad front half shaft
Before making a clutch adjustment, it is necessary to______. a. measure clutch pedal free travel b. lubricate the clutch linkage c. check the hydraulic fluid level d. place the transmission in reverse
Technician A says that most transaxles have a countershaft between the main and output shafts. Technician B says that a countershaft is always in motion when the engine is running. Who is correct? a. Technician A only b. Technician B only c. Both A and B d. Neither A nor B