When the ground is removed from the sheath at one end to reduce heating in a cable, what hazard exists at the ungrounded end of the cable?

Q: 1) Draw a circuit below which has resistors both in series and in parallel (each of whose…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: THEVENIN'S THEOREM  2   find Vth , Rth , IL

A: The thevenin's equivalent circuit can be calculated by calculating the open circuit voltage and…

Q: 8.6 Given that B = 6xa, - 9ya, + 3za. Wb/m², find the total force experienced by the rec- tangular…

A: Given: In this question, the given details are, The given equation is,  B=6xax-9yay+3zaz Wb/m2 To…

Q: Explain each circuit on how it works and its output

A: We have to explain the given circuit. The given circuit is drawn in Proteus software.

Q: A 440 V, 50 Hz, 25 hp, 4-pole, Y-connected three-phase wound-rotor induction motor has the following…

A: “Since you have posted multiple questions with multiple sub parts,we will provide the solution only…

Q: 6. Figure 6 shows a DC resistive circuit. (a) When the switch SW is opened, calculate the current…

A: Given data: The voltage source,V=100 V The resistance connected in the series with the source is 5…

Q: Your turn: Determine V3 employing voltage division 6 Volt (+ S www 10 202. + V3 +51 402 20 V₂

A: We need to find out the voltage for given circuit by voltage division rule .

Q: Q.2) A three-phase, star-connected, 8 pole synchronous generator is required to generate a line…

A: In this question,  The given parameters No of pole P= 8 q= slot per pole per phase = 4 We know  1…

Q: (2)Draw the composite sequence network of a phase short circuit grounding.

A: Draw the composite network of a phase short circuit grounding.

Q: Referring to the circuit shown, determine: the total resistance RT, the current IT and the current…

A: The required parameters can be calculated by using the parallel resistance reduction techniques and…

Q: The element values of a series RLC bandpass filter are R = 5* Max , L = -mH, C = 0,5 * Max MF. 4.1.…

A: We need to find out the all parameters for bandpass filter and we need to find out new value of L…

Q: The average (DC) value of a half-wave rectified voltage with a peak value of 200 V is: a. 63.7 V b.…

A:

Q: Plot the torque/speed curve of a 6-pole, 50-Hz, 3-phase induction motor. The rotor resistance and…

A:

Q: Which of the following has a sine look-up table stored in memory? ODDS chip OPLL chip O Op amp O All…

A: The sine look-up table is used by the synthesizer to generate the sinusoidal waveform and it will be…

Q: Vdc T S₁ R 54 G Drive D Voda L S3 -S₂ 1 3 Vo(Vimis) 2

A:

Q: How long does it take electrons to get from a car battery to the starting motor? Assume the current…

A: We need to find out the time for given charge and current .

Q: V₂/0° R₁ R₂ -jX, Q + 180° Using the node-voltage method, determine the magnitude of the phasor…

A: Given, The circuit diagram, The value of resistors, R1=10 ΩR2=18 Ω The voltages, VA=8 VVB=5 V

Q: (3) The system is in steady state. Find ia(t). (In your answer, combine cosines/sines with the same…

A:

Q: If the current density in a copper, whose conductivity is 5.8 x 107 S/m, is 8 x 106 A/m², the elec a…

A:

Q: 1. Find the currents and determine the voltage per node. 18Ω 30V bF 320 2502 M 14 15 15Ω 13 502 d 16…

A:

Q: Find the Norton equivalent circuit for the network external to the elements between a and b for the…

A: Given: A network,  To find: Norton's equivalent circuit.

Q: Given the NPN common emitter amplifier circuit below with I₁ = 0.13 mA, RF = 160 kN, R₁ = 95 kn,…

A:

Q: Consider a uniform quantizer that uses 3 bits and whose input ranges from -1 V to +1 V. a. How many…

A: We need to find out number of level and step size and quantization power for given quantization .

Q: 1(b). Find the Thevenin Equivalent for this circuit.

A: The thevenin's equivalent circuit can be obtained by calculating the open circuit voltage and…

Q: 15a. The closed-loop transfer function be b. The system type OY OTTO whcota contoh c. The…

A: As per our company guidelines we are supposed to answer only first three subparts kindly repost the…

Q: the C(s) eady 20. Given the system of Figure P7.8, design the value of K so that for an input of…

A: We need to find out the value K for given steady state error .

Q: A 440 V, 50 Hz, 25 hp, 4-pole, Y-connected three-phase wound-rotor induction motor has the following…

A: “Since you have posted multiple questions with multiple sub parts,we will provide the solution only…

Q: 12V 60 30 40 Isc

A:

Q: . The unity feedback system of Figure P7.1, where K(s + a) s(s+ G(s) = ns то Jugni as 101 bato(+B)…

A:

Q: 4. Find the current in each resistor using Nodal Analysis. 10 20 5 A 30 6V

A: We need to find out the current for given circuit.

Q: Find the following (a) V, (b) V₂. (c) Frequency (d) Period (e) Angular Velocity (1) Phase angle (g)…

A:

Q: The switch in the RL circuit shown in Figure 3 was closed for a long time before opening at t = 0 s.…

A: In this question we need to find expression for iL(t) for t>0 and voltage across indicator at t=…

Q: 12-GHz weather radar uses a 50-cm-radius lossless antenna. At a distance of 1 km, what is the volume…

A: Given: Diameter, d=50 cm=0.5 m Distance, D=1 km Frequency, f=120 GHz=120×109 Hz Speed of light,…

Q: V. 2. Measure VAG, VBG and VCG 3. Compute the values of VAC, VBG and VCO using Nodal analysis and…

A:

Q: A 100-MVA, 230/115-kV, A-Y three-phase power transformer has a per-unit resis- tance of 0.015 pu and…

A: It is given that: MVA=100V2V1=230115 kVR=0.015 puX=0.06 puRC=100 puXM=20 pu

Q: Solve for the total resistance of the DC circuit across terminal a and b 1202 1302 1502 I 0.55 F 28…

A: In DC analysis, under steady state condition, aa capacitor will behave as Open circuit and an…

Q: Refer to the given circuit below. Whatever the value of the source voltage, which resistance will…

A: We need to find out the current for resistance .

Q: Draw the circle diagram for a 5.6 kW, 400-V, 3-0, 4-pole. 50-Hz. slip-ring induction motor from the…

A:

Q: using superposition, solve 6 amps and 5v using mesh analysis in clockwise

A: For finding loop currents apply kvl to each loop linear equations are obtained. Then by solving all…

Q: Find the Norton equivalent at terminals a-b of the circuit.

A: The norton's equivalent resistance circuit can be removing the independent sources and then reduce…

Q: There’s only 2 possible outputs for a specific transmitter: 0V and +3V (logic low and high). Find…

A: Given, Transmitter having Output values possible are 0V and +3V (logic low and high). a message…

Q: A 1GHz cosine wave of 1V rms amplitude travels down a transmission line with a propagation velocity…

A:

Q: Two homogeneous dielectric regions 1 (p ≤ 4 cm) and 2 (p ≥ 4 cm) have dielectric constants 3.5 and…

A: Given data Electric displacement; D2=12 aρ-6aϕ+9az nc/m2 Relative permittivity; ∈r1=3.5 ∈r2=1.5…

Q: 1. Find the Laplace transform of the function f(t) = tsin(2t) + e

A:

Q: 5.1 A three-phase, 5 hp, 208 V, 60 Hz induction motor runs at 1746 rpm when it delivers rated output…

A: Given: In this question, the given details are, A three-phase, 5 hp , 208 V, 60 Hz induction motor…

Q: A 10K wire-wound pot has 100 loops of wire and has a range of 350 degrees. Calculate the resolution…

A: The pot coil has 100 turns of wire. Thus, the smallest increment of resistance corresponds to one…

Q: If the supply voltage in three phase delta connection is 400 V, Calculate phase voltage. a. 400 V b.…

A:

Q: Find the following (a) V, (b) V₂. (c) Frequency (d) Period (e) Angular Velocity (1) Phase angle (g)…

A:

Q: () Use nodal analysis to calculate voltage Vo in the circuit of Figure Q2a.

A: The required voltage can be calculated by using the nodal and mesh equations and by solving them we…

Q: A string of Suspension Insulators consists of 8 units. If the Voltage across the string is 44 KV and…

A: Given data, Voltage across string Vs=44 KV. Number of string n = 8. Voltage across nearest the…

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.