Answered: When the similar terminals of high…

When the similar terminals of high voltage and low voltage windings of a transformers are diagonally opposite, then that transformer have subtractive polarity

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.6MCQ: Consider Figure 3.4. For an ideal phase-shifting transformer, the imda nce is unchanged when it is...

See similar textbooks

Related questions

Q: True or False? There are fewer number of turns in Y-Y transformer required than in delta-delta…

Q: Explain the open circuit test on single phase transformer.

A: Open circuit test :- It is carried out at rated frequency & rated voltage to determine the core…

Q: 1) What are the advantages and disadvantages of 3- phase transformers over 3 single-phase bank of…

A: 1.) The advantages of 3- phase transformers over 3 single-phase bank of transformers are as follows:…

Q: Insulation detorioration of transformer winding due to high temprature is an incepient fault O True…

A: Insulation deterioration of transformer winding due to high temperature is an incipient fault Is it…

Q: How many types of winding in distribution transformers? What is the impact of each type on…

A: There are three types of windings: Single Helical Winding. Double Helical Winding. Disc-Helical…

Q: The full load voltage drop in a single phase transformer are 2% and 4% due respectively to…

A: Given values are - Voltage dropR%=2%%R=2%Voltage dropX%=4%%X=4%

Q: Why it's improctical carry out actual load test on large rating transformer

A: When a huge transformer is fully loaded, it can carry a lot of current and voltage. As a result,…

Q: The point of common coupling always located at the secondary side of the service transformer. True…

A: Service transformer : A transformer that steps down utility-supplied voltages to voltages that used…

Q: "Under saturated core condition, transformer become a source of harmonics" True False

A: In this question , we will write about harmonics in transformer..

Q: B/ Short answer questions 1- What is the function of instrument transformers? 2- What are the…

A: In this question we will write about instrument transformers, core type and shell type…

Q: The apparent power in primary and secondary side of the distribution transformer remains the same at…

A: Given Apparent power is same in both primary and secondary of transformers Ture or false

Q: The shell type transformer has less leakage flux compared to the core type transformer True False

A: Choose the correct option Is it true or false? "The shell type transformer has less leakage flux…

Q: ) In a Ideal transformer (assuming no losses), the magnetizing component of no load current is in…

Q: What conclusions you can come up with after implementing open circuit test on single phase…

A: Conclusions from open circuit test on single phase transformer

Q: True or False 3 - Single Phase Transformers cannot be used to replace a 3-Phase transformer.

Q: The shell type transformer has less leakage flux compared to the core type transformer True False

A: In the question, choose the correct option? "The shell type transformer has less leakage flux…

Q: Why do we represent leakage flux in a transformer by inductive reactance? 2. What will happen if…

A: In the transformer, the magnetic flux is produced by both the primary and secondary winding…

Q: "The per unit value of impedance, voltage and current of a transformer are not same regardless of…

A: Per unit value is given as Per unit = actual value / base value

Q: Detailed conclusions we can come up with after conducting open circuit test on single phase…

A: According to the question we have to, Detailed conclusions we can come up with after conducting an…

Q: Short circuit test on a single phase transformer is performed to determine_____________ a.…

A: Need to Find the correct option

Q: The efficiency of two identical transformers under load conditions can be determine by what test?

Q: When conducting no-load test on a given single-phase transformer, the following test data were…

A: As per the guidelines, we supposed to answer first three part of the question at a time so please…

Q: What's The relation between turn ratio current ratio annd voltage ratio(if it exists) for single…

A: The transformer is a static device that steps up or steps down the voltage depending upon the turn…

Q: When the similar terminals of high voltage and low voltage windings of a transformers are diagonally…

A: Transformer is a static electrical device which transfers power from one circuit to another circuit…

Q: What are the advantages and disadvantages of Back To Back Test on Two Similar Single Phase…

A: When we require to test large transformer for determining their efficiency, temperature rise and…

Q: A 15-kVA, 2400/240-V transformer is to be tested to determine its excitation branch components, its…

A: Solution a)- Equivalent circuit of the transformer referred to high voltage side-

Q: a) Discuss why a starldelta or delta/star configuration of a three-phase transformer is optimal for…

Q: Determine the load sharing in MVA for each transformer. Draw the parallel transformer diagram for…

Q: Discuss the potential transformer with neat schematic diagram.

Q: )A. Draw approximate transformer model into all quantities of a secondary referred to primary.…

A: Transformer model Equivalent transformer circuit diagram:- Secondary referred to primary side

Q: What are the reasons for using transformer oil in power transformers and why are mineral oils…

A: The explanation is as follows.

Q: Three Phase Transformer connections: Discuss Fully the various methods available for transforming…

A: The methods of transformation of a 3-phase voltage into higher or lower 3-phase voltages is done…

Q: What are the objectives of implementing an open circuit test on single phase transformer

A: In this question we will write objective of open circuit test on single phase transformers...

Q: When a closed- delta bank is changed to operate as an open-delta bank, the capacity of the…

A: If one of the transformer of delta-delta connection is removed , then also power can be transformed…

Q: at happens if one phase of a 3-phase transformer fails?

A: Primary delta connected and secondary star connected: If the primary (delta) side loses one phase of…

Q: TRUE or FALSE: If a transformer is loaded from full-load value to half-load value, then the amount…

Q: Which of the following is/are true? a) Base current is proportional to base VA b) Base VA is the…

A: In this question , 4 statements is given about transformers..We have to find out which is true.

Q: if the core loss of 1 phase transformer at full load is 42 W, then the core loss at 25% of load is…

A: Given, 1-ph transformer has Full load core loss(Pc)= 42 watts

Q: The shell type transformer has less leakage flux compared to core type transformer O True False

A: In this question ,we have to write that shell type transformer has less leakage flux or not compared…

Q: a) Discuss two (2) advantages and disadvantages of using three single-phase transformers instead of…

A: NOTE: Since you have asked multiple questions, we will solve the first question for you. If you want…

Q: An autotransformer have two separate windings, and are known as double-wound transformers. Select…

A: An autotransformer is an electrical transformer with only one winding. The "auto" (Greek for "self")…

Q: Why are single-phase distribution transformers made whit the low-voltage winding in two sections? A-…

A: Single-phase distribution transformers made with the low-voltage winding in two sections to minimize…

Q: What is the Influence of the manner the core coil assembly of the transformer on calculations of…

Q: 2- What are the differences between core and shell type transformers? 3- The iron losses is constant…

A: In this question we will write about core type and shell type transformers differences....

Q: When two winding transformer is not connected to the load, primary balancing current flows in the…

Q: 8/ As a transformer core, silicon steel has lower hysteresis losses than air. Select one: True…

A: The main problem with transformer core is, its hysteresis loss and eddy current loss in transformer.…

Q: What is phase angle of voltage induced in primary and secondary windings of transformers due to…

Q: Describe the star-delta connection configuration types in three phase transformers and their…

A: In the star-delta connection configuration of a three-phase transformer, the primary winding of the…

Concept explainers

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.

Question

When the similar terminals of high voltage and low voltage windings of a transformers are diagonally opposite, then that transformer have subtractive polarity

True

False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

(a) An ideal single-phase two-winding transformer with turns ratio at=N1/N2 is connected with a series impedance Z2 across winding 2. If one wants to replace Z2, with a series impedance Z1 across winding 1 and keep the terminal behavior of the two circuits to be identical, find Z1 in terms of Z2. (b) Would the above result be true if instead of a series impedance there is a shunt impedance? (c) Can one refer a ladder network on the secondary (2) side to the primary (1) side simply by multiplying every impedance byat2 ?
The direct electrical connection of the windings allows transient over voltages to pass through the auto transfonner more easily, and that is an important disadvantage of the autotransformer. (a) True (b) False
The ideal transformer windings are eliminated from the per-unit equivalent circuit of a transformer. (a) True (b) False
An ideal transformer has no real or reactive power loss. (a) True (b) False
In developing per-unit equivalent circuits for three-phase transformers. under balanced three-phase operation. (i) A common Sbase is selected for both the H and X terminals. (ii) The ratio of the voltage bases Vbase/VbaseX is selected to be equal to the ratio of the rated line-to-line voltages VratedHLL/VratedXLL. (a) Only one of the above is true. (b) Neither is true. (C) Both statements are true.
Consider Figure 3.4. For an ideal phase-shifting transformer, the imda nce is unchanged when it is referred from one side to the other. (a) True (b) False
How many transformers are needed to make an open-delta connection?
For an ideal 2-winding transformer, the ampere-turns of the primary winding, N1I1 is equal to the ampere-turns of the secondary winding, N2I2 (a) True (b) False
An infinite bus, which is a constant voltage source, is connected to the primary of the three-winding transformer of Problem 3.53. A 7.5-MVA,13.2-kV synchronous motor with a sub transient reactance of 0.2 per unit is connected to the transformer secondary. A5-MW,2.3-kV three-phase resistive load is connected to the tertiary Choosing a base of 66 kV and 15 MVA in the primary, draw the impedance diagram of the system showing per-unit impedances. Neglect transformer exciting current, phase shifts, and all resistances except the resistive load.
In per-unit equivalent circuits of practical three-phase transformers, under balanced thr-phase operation, in which of the following connect ions would a phase-shifting transformer come up? (a) Y-Y (b) Y- (c) -
Reconsider Problem 3.64 with the change that now Tb includes both a transformer of the same turns ratio as Ta and a regulating transformer with a 4 phase shift. On the base of Ta, the impedance of the two comp onents of Tb is jO.1 per unit. Determine the complex power in per unit transmitted to the load through each transformer. Comment on how the transformers share the real and reactive pors.
The ratings of a three-phase three-winding transformer are Primary(1): Y connected 66kV,15MVA Secondary (2): Y connected, 13.2kV,10MVA Tertiary (3): A connected, 2.3kV,5MVA Neglecting winding resistances and exciting current, the per-unit leakage reactances are X12=0.08 on a 15-MVA,66-kV base X13=0.10 on a 15-MVA,66-kV base X23=0.09 on a 10-MVA,13.2-kV base (a) Determine the per-unit reactances X1,X2,X3 of the equivalent circuit on a 15-MVA,66-kV base at the primary terminals. (b) Purely resistive loads of 7.5 MW at 13.2 kV and 5 MW at 2.3kV are connected to the secondary and tertiary sides of the transformer, respectively. Draw the per- unit impedance diagram, showing the per-unit impedances on a 15-MVA,66-kV base at the primary terminals.