When the temperature of a copper coin is raised by 100 C°, its diameter increases by 0.17%. To two significant figures, give the percent increase in (a) the area of a face, (b) the thickness, (c) the volume, and (d) the mass of the coin. (e) Calculate the coefficient of linear expansion of the coin. (a) Number i Units (b) Number i Units (c) Number i Units (d) Number Units (e) Number i Units

When the temperature of a copper coin is raised by 100 C°, its diameter increases by 0.17%. To two significant figures, give the percent increase in (a) the area of a face, (b) the thickness, (c) the volume, and (d) the mass of the coin. (e) Calculate the coefficient of linear expansion of the coin. (a) Number i Units (b) Number i Units (c) Number i Units (d) Number Units (e) Number i Units

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter19: Temperature, Thermal Expansion And Gas Laws

Section: Chapter Questions

Problem 39PQ

See similar textbooks

Similar questions

A surveyor uses a steel measuring tape that is exactly 75000m long at a temperature of 20 degree celcius? What is the length (in m) of the tape when them temperature is 35 degrees celcius? () The answer (in fundamental SI unit) is ___________
A steel bridge is built in summer when the temperature is 25 degree Celsius. At the time of construction its length is 80.000 meters. What is the length of the bridge on a cold winter day when the temperature is negative 10 degree Celsius? (Given, Solution,Figure)
Charles’s law states that if the pressure of a dry gas is held constant, then the volume VV of the gas and its temperature TT, measured in degrees Kelvin, satisfy the relationship V=cTV=cT, where cc is a constant. Which of the following best describes the relationship between the rate of change, with respect to time tt, of the volume and the rate of change, with respect to time tt, of the temperature?
An aluminum wire is wrapped in rubber insulation. Both are subject to thermal expansion, with the following coefficients of linear expansion: alphaa=24· 10−6 1/C and alphar=8· 10−5 1/C . If the wire and insulation are the same length of 1.85m at a temperature of20.00°C, what is the difference in length (in MILLIMETERS) between the copper wire and the rubber insulation when heated up to a temperature of 189.00°C? Express a magnitude only (no negatives!). ______mm (MILLIMETERS!)
The outer diameter of a glass jar and the inner diameter of its iron lid are both 760 mmmm at room temperature (20.0 ∘C). What will be the size of the mismatch between the lid and the jar if the lid is briefly held under hot water until its temperature rises to 62.5 ∘C, without changing the temperature of the glass? Use the coefficient of linear expansion for iron α= 1.2×10^−5 K^−1. Express answer in millimeters.
When air expands adiabatically (without gaining or losing heat), its pressure P and volume V are related by the equation PV^1.4=C where C is a constant. Suppose that at a certain instant the volume is 440 cubic centimeters and the pressure is 99 kPa and is decreasing at a rate of 7 kPa/minute. 1). At what rate in cubic centimeters per minute is the volume increasing at this instant? (Pa stands for Pascal-- it is equivalent to one Newton/(meter squared); kPa is a kiloPascal or 100 Pascals)
The rectangular plate has a length of l and width of w. If the temperature increases by ΔT, find the increase of the area of the plate, given that the coefficient of the linear expansion of the plate material is α.
Assuming the human body is primarily made of water, estimate the number of molecules in it. (Note that water has a molecular mass of 18 g/mol and there are roughly 1024 atoms in a mole)
An engineer who is working on the heat transfer analysis of a house in English units needs the convection heat transfer coefficient on the outer surface of the house. But the only value he can find from his handbooks is 22 W/m2·K, which is in SI units. The engineer does not have a direct conversion factor between the two unit systems for the convection heat transfer coefficient. Using the conversion factors between W and Btu/h, m and ft, and °C and °F, express the given convection heat transfer coefficient in Btu/h·ft2·°F.
The gas law for an ideal gas at absolute temperature T(in kelvins), pressure P (in atmospheres), and volume V(in liters) is PV=nRT, where is the number of moles ofthe gas R =0.0821 and is the gas constant. Suppose that,at a certain instant P=8.0, atm and is increasing at a rateof 0.10 atm/min and V=10L and is decreasing at a rateof 0.15 L/min. Find the rate of change of T with respect totime at that instant if n=10 mol.
The temperatures of two bodies measured by a thermometer are t1 = 20 0C ± 0.5 0C and t2 = 50 0C ± 0.5 0C.Calculate the temperature difference and the error theirin.
The quantity of energy Q transferred by heat conduction through an insulating pad in time interval Δt is described by Q/Δt = κAΔT/d, where κ is the thermal conductivity of the material, A is the face area of the pad (perpendicular to the direction of heat flow), ΔT is the difference in temperature across the pad, and d is the thickness of the pad. In one trial to test material as lining for sleeping bags, 86.0 J of heat is transferred through a 3.40-cm-thick pad when the temperature on one side is 37.0°C and on the other side is 2.00°C. In a trial of the same duration with the same temperatures, how much heat will be transferred when more of the material is added to form a pad with the same face area and total thickness 8.41 cm?