When water freezes, it expands about 8.65%. What would be the pressure increase inside your automobile engine block if the water in it froze? The bulk modulus of ice is 2.00 x 10 N/m2. Pa

Q: The pressure on a volume of liquid V= 1.6 m3 at the surface is approximately equal to the…

A:

Q: A horizontal aluminum rod 4.8 cm in diameter projects 5.3 cm from a wall.A 1200 kg object is…

A: a) The required shear stress is,

Q: Normal forces of magnitude 1.0 × 106 N are applied uniformly to a spherical surface enclosing a…

A:

Q: A 19 -L volume of oil is subjected to pressure which produces a volume strain of 1.3 x L0-4. The…

A:

Q: How large a pressure increase (in ATM) must be applied to water if it is to be compressed in volume…

A: Answer Option ( c ) = 200 atm

Q: What hanging mass will stretch a 2.0-mm-long, 0.59-mmmm-diameter steel wire by 1.2 mmmm ? The…

A:

Q: In regions of the cardiovascular system where there is steady laminar blood flow, the shear stress…

A:

Q: Compute the pressure in Nm2 required to compress a given volume of water V, to 99 percent of its…

A:

Q: An aluminum rod of length 1.0 m and cross-sectional area 0.0005 m2 is used to support a load of…

A: Given data: Original Length (L) = 1.0 m Cross-sectional area (A) = 0.0005 m2 Force (F) = 5000 N…

Q: A 0.600-mm diameter wire stretches 0.500% of its length when it is stretched with a tension of 20.0…

A:

Q: 1. A hydraulic press contains 0.25 m³ of oil. Find the decrease in the volume of the oil when it is…

A: We are allowed to give the explanation of first question only which is given below.  Please repost…

Q: A leg has 1.4 m shaft of bone with an average cross sectional area of 3x10-4 m². What is the amount…

A:

Q: A wire of uniform cross sectional area of 0.15 mm2 is stretched at both ends by a total force of 40…

A: Given, Area of cross section of the wire A = 0.15 mm2 Total force acting on the both end F = 40 N…

Q: During exercise the volume of a human lung can increase by as much as 15%. If the bulk modulus for a…

A:

Q: A 50-kg bucket of concrete is suspended from a steel wire that is 1.0 mm in diameter 1.0 mm and 11.2…

A:

Q: What is maximum diameter of brass rod if it has to support a 400N load without exceeding its elastic…

A: Let Y be the stress on the brass rod, F be the load, A be the cross-sectional area, and D be the…

Q: A 90 kg mountain climber stretches her 1.0 cm diameter nylon rope by 1.3 m when she hangs below a…

A: Find the force exerted on the rope. F=mg=90 kg9.8 m/s2=882 N Find the cross sectional area of the…

Q: rizontal aluminum rod 3.4 cm in diameter projects 7.0 cm from a wall. A 810 kg object is suspended…

A: Given: d=3.4 cm L=7cm =0.07mm=810 kgG=3.0*1010 N/m2

Q: A horizontal aluminum rod 3.9 cm in diameter projects 7.1 cm from a wall. A 1200 kg object is…

A:

Q: A wire has 20 x 10^10 N/msquared young modulus. Its diameter is 1mm that can handle a tension of 0.2…

A: Given data- young modulus= 20×1010 N/m2 1mm diameter can handle a tension of 0.2 kN.

Q: A copper wire of length 23.179 is designed to withstand a maximum tension of 657 N and 0.627%…

A: Given  Length of copper wire  L = 23.179 m Tension  T = 657 N Strain  ∆L/L × 100 = 0.627 %  ∆L/L =…

Q: Oil in hydraulic cylinder is compressed from an initial volume 3 m³ to 2.12 m³. If the pressure of…

A: Initial volume, v = 3 m³ Final volume, V = 2.12 m³ Initial pressure, p = 50 MPa Final pressure, P =…

Q: A 28.0 m long aluminum cable with a cross-sectional area of 2.01 ✕ 10−3 m2 is used to suspend a 3.40…

A: Y=mg/A∆L/L   =mgLA∆L∆L=mgLYA

Q: It takes about 14140 N to punch a hole which is 20mm in diameter into a 25mm thick plate. What will…

A:

Q: A 23.0 m long steel cable with a cross-sectional area of 2.06 10-3 m2 is used to suspend a 3.80 x…

A:

Q: When water freezes, it expands by about 9.00%. What would be the pressure increase inside your…

A: Given data The expansion volume of the water is ∆vv=9 %=0.09 The bulk modulus of ice is k = 2 x 109…

Q: When a certain liquid freezes, it expands about 10.0%. What would be the pressure increase inside an…

A:

Q: The pressure in an explosion chamber is 345M Pa. What would be the per cent change in volume of…

A: Let P be the pressure, B be the bulk modulus of the chamber, V be the volume.Write the expression…

Q: An oil specimen has an initial volume of 597 cm³ and is subjected to 3.6 MPa pressure increase. The…

A: Initial volume V=597 cm3 Rise in volume △V=0.35 cm3 Rise in pressure △P=3.6 MPa=3.6×106 Pa To find:…

Q: When water freezes, it expands by about 9.00%. What pressure increase will occur inside your…

A: Given data The ratio of the expansion volume of water when the freeze is ∆VV = 9 % = 0.09 The bulk…

Q: Normal forces of magnitude 3.0 x 10° N are applied uniformly to a spherical surface enclosing a…

A: As per our guidelines we are supposed to answer?️ only one question. Kindly repost other questions…

Q: Suppose that an object was formed using 7.25 x 10° Pa. When it was released from the press and…

A: Given  :     Pressure, P1 = 7.25*108 Pa     Pressure, P2 = 1.01*105 Pa       Change in Pressure, ∆P…

Q: When water freezes, it expands by about 9%. What would be the pressure increase inside your…

A:

Q: In regions of the cardiovascular system where there is steady laminar blood flow, the shear stress…

A: Convert the shear stress on cells in N/m2.

Q: One end of a copper rod with a diameter of 20 mm and a length of 0.95 m is held in a vise. A force…

A:

Q: When water freezes, it expands by about 9.00%. What pressure increase would occur inside your…

A:

Q: When a certain liquid freezes, it expands about 10.0%. What would be the pressure increase inside an…

A: Bulk modulus is relative change in volume of a body produced by compressive or tensile stress. And…

Q: 5. When water freezes, it expands by about 9.00%. What pressure increase would occur inside your…

A:

Q: A solid steel sphere with a radius of 2.0 m falls off a ship and sinks to a depth where the pressure…

A: Given : radius, r= 2 m  Pressure, P = 15 MN/m2 = 15 × 106 N/m2  Bulk modulus, B=1.6×1011 N/m2  Find…

Q: A metallic cube of side 125cm is subjected to a uniform force acting normal to the whole surface of…

A:

Q: A hydraulic press contains 0.25 m3 of oil. Find the decrease in the volume of the oil when it is…

A: Let the Bulk modulus of oil is given by B. Let the change in pressure is given by ∆p. Let the change…

Q: A 6.10 m long marble column has a cross sectional area of 1.38 m^2 has a Young's modulus of 50.5 x…

A: The Young's modulus is given by, Y=σe Here, σ is the stress and e is the strain. The stress is the…

Q: When a certain liquid freezes, it expands about 11.5%. What would be the pressure increase inside an…

A: Write the expression for bulk modulus

Q: How large a pressure increase (in ATM) must be applied to water if it is to be compressed in volume…

A:

Q: An 80-cm-long, 1.0-mm-diameter steel guitar string must be tightened to a tension of 2.0 x 103 N by…

A: Given:- L= Length = 80 cm = 0.8 m r= radius of cross section=. d/2 = 1/2 = 0.5 mm = 0.5×10^-3 m Y=…

Q: 6. A) A 100-kg load is hung on a wire of length 6.00-m, diameter 2.00-mm, and Young's modulus 8.00 x…

A: Given, mass hung on wire =100 kglength of wire =6.00 mdiameter of wire =2.00 mmso radius of wire…

Mechanical Properties of Solids

There are three types of matter- solid, liquid and gas. Out of them, solids have a rigid shaped and size. The intermolecular forces of attractions in solids are greatest. Mechanical properties are the physical properties of a material which it shows, when it is provided with certain amount of force or load. These properties are to be kept in mind for various purposes. When a force is applied to an object, the object may or may not get deformed depending upon its elastic property. But every time the object develops a restoring force against the force applied. This is commonly known as stress. If the object changes its dimensions due to the force applied it develops strain ( which is the ratio of change in dimension to the original dimension).