Answered: Which is better and why, dc generator…

Which is better and why, dc generator or ac generator including rectifier, both ac and dc generators have the same voltage output. Explain.

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter59: Motor Startup And Troubleshooting Basics

Section: Chapter Questions

Problem 12SQ: How is a solid-state diode tested? Explain.

See similar textbooks

Related questions

Q: If Vc is equal to 277∠173 and Vab is 479.778∠83, the phase sequence is:"

Q: In the circuit of Fig. 2.76, obtain v1, v2, and v3. 15 V 25 V 10 V + U2 20 V v1 = V V2 = V V3 =

A: In this question we will find unknown voltages...

Q: Calculate for damping ratio, natural frequency, delay time, rise time, peak time, settling time and…

A: In this question, We need to calculate for damping ratio, natural frequency, delay time, rise time,…

Q: 1 20 O 30. O 40. O 50. O 60. O 70. C:

A: We need to find out equivalent resistance for given circuit

Q: 16 T(s) s2 + 3s + 16

Q: Show complete solution: A parallel LC tank circuit has L = 40mH, C = 0.68nF, and a coil winding…

A: It is given that L=40mHC=0.68nFR=10Ω

Q: . A 5 Hp 220 V 4 pole 60 Hz 3phase induction motor

A: Induction machine- This Induction machine comprises of rotor and stator as it basic parts and it…

Q: 9- For the transistors in the circuit shown in Fig.9, B 100. Find the voltages at all nodes, the…

A: According to the question, for the given circuit diagram We need to find the node voltage and the…

Q: efine dipole antenna with diagram and label

A: Dipole antenna: A dipole antenna (also known as a doublet or dipole aerial) is defined as a RF…

Q: In the circuit of Fig. 2.75, calculate Vị and V2. 1 V 2 V + + + 5 V V2 V1 = V V2 = V

Q: Using the superposition theorem, determine the indicated currents.

A: Here we use superposition theorem to calculate branch currents of the given circuit. In…

Q: "If Vb is equal to 302∠194 and Vbc is 523.079∠164, the phase sequence is:" POSITIVE…

A: for positive phase sequence line voltage (Vbc) leads phase voltage (Vb) by 30 degrees and for…

Q: The load in each phase of a delta connected network is equal to 62∠64 Ohms.The network is connected…

Q: A 6-pole, 50hz, 3-phase induction motor has a fully load speed of 950 rpm. Its speed in Rpm at half…

Q: For a citizens band receiver using high-side injection with an RF carrier of 27.04 MHz and a 10.645…

A: The principle of a citizen radio receiver includes the local oscillator implemented to heterodyne…

Q: Ql: For the circuit shown in Fig. 1, find the line currents and the phase currents at the load. 5-20…

Q: 5 MH A 10 n 20 n 60 MH 100 cos (377 t) 10 n 5 mH 40 n 40 mH N 100 cos (377t + 120 ) 10 n SmH 60 n 20…

Q: For the system shown in Fig. 1, determine the values of gain K and velocity- feedback constant K, so…

Q: no load test, VNL= 220 V P= 310W INL= 6.2 A load test , V = 220 V P;= 3650 W N = 1710 rpm %3D | =…

Q: 3.53 Find V, in the network in Fig. P8.53 using nodal analysis. V 2Ω 1Ω j2 0 12/0° V 2/0° A 4/0° V…

Q: 8k2 12 V 8kN +- 6kQ 2kQ 4k2 6 mA

A: To find the output voltage shown in figure

Q: Q2 / Answer TWO ONLY of the -: following 1- Numerate (e) FIVE Advantages of Real-Time Systems 2-…

A: In this question we will write about opamp configurations and explain one of them...

Q: x(t) = sin(2.5rt) + 3

Q: ) An 800-turn is the wound on the central limb of the cast-steel frame shown in Fig.4. Determine the…

Q: 9- Suggest that you are an electrical power engineer with the Iraqi National Grid (ING ), you need…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: (c) A fusion splice machine is to be designed for multimode fibre splicing, with a maximum…

A: A fusion splicer machine weld two optical fibers together and The ends of the fiber are cut,…

Q: "If Vc is equal to 285∠97 and Vab is 493.634∠7, the phase sequence is:"

Q: Using the Routh-Hurwitz criterion, determine the stability of the closed-loop system that has- he…

A: Given: Characteristics equation Ds=s3+3s2+3s+1+k

Q: 1. Using a three (3) variable map, draw the simplified logical circuit for the ff; а.) А ВС +…

A: As per the guidelines of Bartley we supposed to answer first question only for solution of remaining…

Q: Magnetization Curve - 170 kW, 250V, 850 rpm DC Shunt Generator 350 300 250 200 150 100 50 2 3 6 7 8…

A: Given magnetization curve The figure above shows the excitation curve (including residual voltage)…

Q: What is the voltage drop across C2

Q: 2. If E = -xã, + yãy V/m. find the work involved in moving a unit positive charge on a circular arc,…

A: The potential difference is also termed as the work done to bring a unit charge in a uniform charged…

Q: If Ibc is equal to 661.643∠159 and Ia is 382angle;69,the phase sequence is:" POSITIVE…

Q: For the multipath profile given in figure Q5, if a particular modulation provides suitable…

A: PSK stands for Phase Shift keying and is the modulation technique in which the phase of the carrier…

Q: 8.56 Find I, in the circuit in Fig. P8.56 using nodal analysis. I. 2 20 2/0° A 20 1Ω -j2 0 12/0° v+…

Q: 1. Find the transfer function from input R(s) to output Y(s) Y(s) R(s) 3 1/s 1/s Y(s) R(s) 3s+1…

Q: Using mesh analysis, find Vo. Pg. 4 NAME: 6 V 1 kΩ 1 kN 1 k2 12 V 2 kN Vo

Q: v*-9V 100A (b) Consider the circuit shown in Fig.(6-b). The current gain for the npn transistor is…

A: NPN transistor consists of three layers is made of two N layers with one single Player. they are…

Q: (a) Calculate current i in Fig. 2.68 when the switch is in position 1. (b) Find the current when the…

Q: r(t)=u,(t) e(n) u(n) C(t) D(2) Z.O.H G,(s) 200 (s+3)(s+10)² a) Find the physically feasible deadbeat…

A: In a deadbeat system, the input signal must be applied such that with a minimum number of steps the…

Q: 6.9 The current in and the Voltage across a 10 are known to be zero for t < 0. The voltage across…

A: aCase i For 0<t<25msConsider the expression for voltage across the inductor 10 H in the…

Q: 4. A 3-ph, 500-V motor load has a pf of 0.4. Two wattmeters connected to measure the power show the…

Q: Find the transfer function of the second order recursive filter in frequency domain whose impulse…

A: Impulse response of the filter is, hn=rnsinωonun Writing Z-transform of sine signal.…

Q: kindly help me with this one. Write your answer with four decimal places and enclose them in a box.…

Q: a description of what a flip-flop circuit does and how it may be utilized Whether the circuit is a…

A: A flip-flop is used to store single bit of binary information. This single bit may be 'zero' or may…

Q: Determine the impulse response and frequency response of the LTI system defined by, y(n) = x(n) + b…

Q: In the feedback system shown in Figure Q3, the controller and the plant have the following transfer…

A: As per the guidelines of Bartley we supposed to answer first three subpart only for solution of…

Q: 3-ph, 3-wire balanced load with a lagging power factor is supplied at petween lines. A single-phase…

Q: Analyse the amplitude modulated wave represented by the expression: v = 5 (1 + 0.6 cos 6280 t) sin…

A: Given data, AM wave v=51+0.6cos6280tsin211×104t V

Q: Vb is equal to 302∠200 and Vbc is 523.079∠230, the phase sequence is:" POSITIVE NEGATIVE

A: In this question , we will find phase sequence of given voltages....

Question

Which is better and why, dc generator or ac generator including rectifier, both ac and dc generators have the same voltage output. Explain.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is CEMF?
How is a solid-state diode tested? Explain.
A DC generator or AC generator with rectifier having the same output voltage produced, which is better? Explain in details.
Answer in Sentence/Paragraph form. Maximum of 5 sentences each. Lesson: Electronics: HALF-WAVE Rectifier with and without Filter1. What is the function of the filters?2. What is TUF or Transformer Utilization factor? 3. What is the average value of output voltage for half-wave rectifier? 4. What is the peak factor?
Question 1: a) Draw the circuit diagram and explain the working of Half Wave Rectifier (HWR). b) With the help of a neat circuit diagram, explain the working principle of a Centre tapped Full Wave Rectifier. Also, Draw the expected output voltage wave forms with/without using a capacitor parallel with the load. Show the factors affecting voltage ripples and how to eliminate these ripples as much as possible.
Discussion and calculations 1. Compare between the practical and theoretical results for input and output voltages 2. What design parameters of the half wave single-phase rectifier? 3. How do you calculate VRM of a half wave rectifier?. 4. How do I know if my rectifier is single phase ? 5. Design a single phase uncontrolled RL half wave rectifier with R=1KQ , L=500 mf and calculate the Vo &lo
1_Why Ripple factor should be minimized in Rectifier Circuit? 2.Explain the operation of Negative clamping with circuit diagram and waveforms. 3.Write any two difference between Center tapped full wave rectifier and Bridge Rectifier.
Elaborate the working of half wave rectifier with neat diagram and waveforms. Determine the peak output voltage and current in the 4 kW load resistor connected to the output terminals of full wave bridge rectifier, if the transformer secondary voltage is 28 Vrms. Use the practical silicon diode model.
Suppose you are an electronic circuit designer. How you can use the center-taped step down transformer in bridge rectifier circuit?
A single-phase fully controlled, full-wave, bridge rectifier has a source of 220 V rms at 50 Hz. The firing angle α = 45˚ and the current extinction angle β =255˚; (i) Determine whether the current is continuous or discontinuous and write the condition. (ii) Sketch the appropriate load voltage and load current waveform. (iii) If the firing angle is increased into 110˚, state the polarity of voltage and power for that condition.
2.Why do you use filters in Rectifier circuit ?
Both ripple factor and harmonic factor should be unity for ideal controlled rectifier. Select one: True False