Elaborate the working of half wave rectifier with neat diagram and waveforms. Determine the peak output voltage and current in the 4 kW load resistor connected to the output terminals of full wave bridge rectifier, if the transformer secondary voltage is 28 Vrms. Use the practical silicon diode model.

Elaborate the working of half wave rectifier with neat diagram and waveforms. Determine the peak output voltage and current in the 4 kW load resistor connected to the output terminals of full wave bridge rectifier, if the transformer secondary voltage is 28 Vrms. Use the practical silicon diode model.

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter59: Motor Startup And Troubleshooting Basics

Section: Chapter Questions

Problem 12SQ: How is a solid-state diode tested? Explain.

See similar textbooks

Similar questions

How is a solid-state diode tested? Explain.
What is the PIV rating of each silicon diode in volts for a bridge type rectifier where the voltage in the secondary transformer is 100V peak? Assume 2.2K ohms load.
Determine the peak output voltage and current in the 4 kW load resistor connected to the output terminals of full wave bridge rectifier, if the transformer secondary voltage is 28 Vrms. Use the practical silicon diode model.
Determine the peak output voltage for the bridge rectifier in this figure. Assuming the practical model, what PIV rating is required for the diode? The transformer is specified to have a 12 Vrms secondary voltage for the standard 110 V across the primary.
Design Half-wave Rectifier Circuit to provide an output of 100 VDC. Then calculate its transformer peak voltage rating, the diode PIV rating, and the transformer turns ratio, if the power is taken from the 220V line AC supply
In a center-tapped full wave rectifier circuit utilizing ideal diodes, if the primary voltage is 160Vpeak, the turns ratio is 8:1 and the load resistance is 860 ohms, what is the rectified dc voltage at the output? express answer in volts
The half-wave rectiﬁer as shown is operating at a frequency of 60Hz, and the rms value of the transformer output voltage vI is 12.6V±10%. What are the nominal and worst case values of the dc output voltage VO if the diode voltage drop is 1V?
Design a center-tapped full-wave Rectifier Circuit to provide an output of 100 VDC. Then calculate its transformer peak voltage rating, the diode PIV rating, and the transformer turns ratio, if the power is taken from the 220V line AC supply
A 24-V secondary of a transformer is connected to a half-wave rectifier and a 50 ohms load device. Calculate the DC output voltage Calculate the average current Which rectifier diode would be adequate for this application?
What is the PIV rating of each silicon diode in volts for a bridge type rectifier where the voltage in transformer secondary is 100V peak? Assume a load of 2.2K ohms. (answer in numeric only)
The full-wave rectiﬁer ias shown is operating at a frequency of 60 Hz, and the rms value of the transformer output voltage is 18 V. (a) What is the value of the dc output voltage if the diode voltage drop is 1 V? (b) What is the minimum value of C required to maintain the ripple voltage to less than 0.25 V if R = 0.5 Ω? (c) What is the PIV rating of the diode in this circuit? (d) What is the surge current when power is ﬁrst applied? (e) What is the amplitude of the repetitive current in the diode?
(a)Derive the average and rms output voltages and currents for three-phase half controlled rectifier with free wheeling diode and RLE load.(b))In a single phase full converter, if output voltage has peak and average values of 325V and 133V respectively, find the firing angle.