Answered: Which materials is not used as in the…

Which materials is not used as in the Insulation Layer of the Underground Cable? O A. PVC O B. XLPE O C. IMPREGNATED PAPER D. HESSIAN TAPE

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter20: Special-purpose Outlets For Ranges, Counter-mounted Cooking Unit , And Wall-mounted Oven

Section20.2: Wall-mounted Oven Circuit And Free-standing Range

Problem 14R

See similar textbooks

Related questions

Q: 23. What Cable Color-Coding is typically used for the Earth Wire in the Sultanate of Oman? A. BLACK…

A: (A) black wire is used for neutral of ac. (B) where is Blue wire is used for neutral.

Q: Any example traced in your reading material, connections between the current and the potential…

A: Correct option is c.

Q: what is the voltage drop percent on two 10 AWG THW copper, stranded, branch- circuit conductors,…

A: Given: what is the voltage drop percent on two 10 AWG THW copper, stranded, branch- circuit…

Q: List down the different types of Cables.

A: Dependig on the purpose of use cables are classified in to five types1)Shielded cables2)Fibre optic…

Q: calculate the current carrying capacity of cable protected by fuse with 60 A ,the first half of the…

Q: Hi. What kind of connector used by the Plenum cable? What is the example of Plenum cable. Thanks…

Q: Explain the use of cable glanding

A: Cable glands are commonly defined as mechanical cable entry devices The use of cable glanding?

Q: 17. In wiring lighting that does not require thick wires, which splice is more suited? * O A.…

A: Given, It is mcq.. Please find below for the clear explanation.

Q: 8. Where the nameplate of an air-conditioning unit specifies the minimum ampacity required for the…

Q: Assume a bank of heating strips is rated at 22 KW and is connected to 240 volts. The heat strips…

A: Obtain the total current flowing through the heat strips. I=PV=22×103240=91.67 A

Q: Which of the following property the insulating material should possess to resist the flow of current…

A: Dielectric strength is defined as the electrical strength of an insulting material. In strong…

Q: Article 300 cable or nonmetallic raceway-type wiring methods installed in a groove, to be covered by…

A: cable or nonmetallic raceway-type wiring methods installed in a groove, to be covered by wallboard,…

Q: 11. What type of cable would be used to connect telecommunications rooms on the ground floor and…

A: The telecommunication cabling standards ANSI/TIA-568 has divided the structured cabling into six…

Q: Skitch a wire of installation

A: Sketch a wire of installation

Q: 5.0 Question 5.1 5.2 Define the terms of electrical conductors? Define the term of cable insulator?

A: 5.1 Electrical conductors: In electrical engineering or in physics, an electrical conductor is a…

Q: Which layer in the construction of Underground Cables protects the Steel Wire or Tape from…

A: Which layer in the construction of Underground Cables protects the Steel Wire or Tape from…

Q: Table 314.16(A) of the Code shows the maximum number of conductors permitted in a given size box. In…

A: When setting a job, an electrician often makes a circuit, thinking of the best way to use wires…

Q: What should be the CPC cable size for a line conductor of sizes up to 16mm² Same size 35 mm2 Half…

A: CPC cable size for the given line conductor of different sizes is given in accordance with table…

Q: QI/B: For underground cables, what is the purpose of using insulation part?

A: Given : In the question they want to know the purpose of the insulation part of the cables which…

Q: Airframe Electrical System Question: Name two acceptable conductor types used in aircraft wiring?…

A: All aircrafts require lightweight body parts. So, the wiring material required in aircraft must be…

Q: Nec article 210 q.#1 the rating of a branch circuit shall bedetermined by the rating of the?

Q: The motor takes 3 HP at an efficiency of 2%. The voltage at the terminals of the motor is 110 volts.…

A: Given: η=0.02P0= 3×746=2238 WV =110 V

Q: Please answer all questions and give me a sample answers, 1- What determines the ampacity of a…

A: Since we answer only first question out of all given by student, we’ll answer the first .Please…

Q: when the insulation of the equipment tested healthy ? justify .

A: As we know that the current sent through a conductive wire to the destination means to the consumer…

Q: What ampacity must all branch-circuit conductors used for wiring a ceiling outlet box be de-rated…

A: Dear student as per our guidelines we are supposed to solve only one question .kindly repost other…

Q: The connection method from the equipment grounding conductor to the box is carefully controlled.…

A: Referring the NEC code 250.148 (C), it concludes that a connection should be made between some…

Q: Explain the method of carrying out insulation resistance test on an electrical installation

A: Insulation resistance is the quality of an electrical system that degrades with time, temperature,…

Q: Airframe Electrical System Question: Name 10 wire insulation characteristics that must be considered…

A: Ten wire insulation characteristics that must be considered when selecting the best wire insulation…

Q: 45. What section of the Code prohibits the use of sheet metal screws as a means of attaching…

A: As per the bartleby policy you can ask one question at a time so please ask other questions a…

Q: The minimum point of attachment of the service-drop conductors to a building must in no case be less…

A: Service drop conductor is used to supply power to the consumer. These conductors either used as…

Q: 4.a. Conductors, including splices and taps, shall not fill an auxiliary gutter to more than _______…

A: Note Pull box is used in the electrical raceway system to feeding and pulling the conductor…

Q: 17/ Which is among these show incorrect order of the layers (inner going outward) in the…

Q: If you know that the power of the load that is supplied with a voltage source of (220 volts) is 2000…

A: The resistance of the wire can be written as R=ρlAA=ρlR For voltage V and…

Q: 15. Why is it necessary to have a good grounding system for the building?

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: 11. A neutral will be used as the grounding conductor for a cooking range. Which of the following is…

A: Based on the power system protection

Q: Which type of equipment is used to bridge sections of horizontal, backbone, or patch cable? A.…

Q: what is the largest size conductor allowed to be used with a wirenut

A: Wire nut is an electrical connector used to connect two or more than two wire together. largest…

Q: Which of the following is not an approved grounding method? A) Metallic underground water piping B)…

A: Electrical grounding is a backup pathway that provides an alternating route for the current to flow…

Q: A motor had a full load current rating of 74.8 and the terminations are rated for 75c . What is the…

A: Full load current of motor = 74.8 × 125% = 93.5 From table 310.15 (B)(16) of NEC, we get the size…

Q: Which of the following products are not suitable for bonding on the supply side of the service…

A: The problem of bonding is frequent where the electrical installation is required. The load side…

Q: a)How do voids in the insulation cause breakdown of the cable? b)How do the various devices protect…

A: High voltage cables are used for the transmission and distribution purpose for electric power. In…

Q: Sixteen 8 AWG copper conductors with type RHW insulation are to be run in a conduit. The conduit is…

A: The power is transmitted using the electric cables. The conductors are made of copper or with…

Q: Couses EEP Draw a WIRING DIAGRAM for wiring Two Way - One Gang Switches (51 and S2) to control…

Q: 1. A wire used for wiring electric ranges, hot water heaters, stoves and hairdryers where both heat…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: In which type of wiring polyvinyl chloride and vulcanized Indian rubber insulated wires are used as…

A: Vulcanized Indian Rubber: These comprises of a copper conveyor covered with a protection layer of…

Concept explainers

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.

Question

Which materials is not used as in the Insulation
Layer of the Underground Cable?
O A. PVC
O B. XLPE
O C. IMPREGNATED PAPER
O D. HESSIAN TAPE

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

17/ Which is among these show incorrect order of the layers (inner going outward) in the construction of Underground Cables? A. METALLIC SHEATH, BEDDING, ARMORING B. INSULATION, INSULATION SHIELD, BEDDING C. INSULATION SHIELD, METALLIC SHEATH, BEDDING D. CORE, CONDUCTOR SHIELD, INSULATION
You're installing an aluminum grounding electrode conductor that has an insulating jacket. Which of the following letters should the jacket contain in the suffix of the insulation type? A. W B. R C. T D. C
What is the minimum size copper grounding electrode conductor for each of the following residential electrical services? Refer to Table 250.66. The ungrounded conductors are Type THW copper. 310.15(B)(7) is only for 120/240-volt, single-phase residential services and feeders. This Section does not apply to services and feeders other than residential.
It is permissible for an electrician to connect aluminum, copper, or copper-clad aluminium conductors together in the same connector. (True) (False) (Circle the correct answer.)
23. What Cable Color-Coding is typically used for the Earth Wire in the Sultanate of Oman? A. BLACK B. BLUE C. BROWN D. GREEN AND YELLOW
Which of the following products are not suitable for bonding on the supply side of the service disconnecting means? a) Threaded hubs b) Bonding bushings with jumpers c) Standard locknuts d) Threadless connectors made up tight
In both exposed and concealed locations, where a cable or raceway-type wiring method is installed through bored holes in joist, rafters, or wood members, holes shall be bored so that the edge of the hole is not less than ____ in. from the nearest edge of the wood member. Select one: A. 1/16 B. 1.6MM C. 1 D. 1 1/4
The following problems refer to grounding requirements. Give the source of yourresponses.1. What is the proper size copper grounding electrode conductor for a 100-ampere service that consists of 3/0 AWG ungrounded conductors?
Article 300 Direct-buried conductors or cables can be spliced or tapped without the use of splice boxes when the splice or tap is made in accordance with 110.14(B). a. True. B. False
Type MI cable shall be supported securely at intervals not exceeding _____ ft by straps, staples, hangers, or similar fittings designed and installed so as not to damage the cable. Select one: A. 6 B. 8 C. NONE OF THE ABOVE D. 4
a)How do voids in the insulation cause breakdown of the cable? b)How do the various devices protect the penstock?
The minimum point of attachment of the service-drop conductors to a building must in no case be less than above finished grade. A. 8 ft B. 10 ft C. 12 ft D. 15 ft