Which of the following is NOT true about constant weighing in the experiment? It involves a cycle of heating, cooling, and (A weighing. A desiccator is used to avoid moisture to (B be absorbed by the sample. A proportionality constant will be multiplied to the measured weight to account for loss of water. Constant weight is achieved when two consecutive measured weights agree within plus or minus 0.3 mg.

Which of the following is NOT true about constant weighing in the experiment? It involves a cycle of heating, cooling, and (A weighing. A desiccator is used to avoid moisture to (B be absorbed by the sample. A proportionality constant will be multiplied to the measured weight to account for loss of water. Constant weight is achieved when two consecutive measured weights agree within plus or minus 0.3 mg.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter33: High-performance Liquid Chromatography

Section: Chapter Questions

Problem 33.17QAP

See similar textbooks

Similar questions

In this experiment, the problem is that the volume of the volumetric pipet is not accurately known (only 2 sig figs), so any density calculation will also be limited to 2 sig figs. Calibration increases the number of sig figs from 2 to 4. As a result, the density also increases from 2 to 4 sig figs. Explain how and why this is possible.
After the extraction process, the organic solvent containing the organic compound was cooled and filtered after the crystals appeared. Upon filtration, the filter paper with the crystals are weighed immediately. Assume there were no additional steps in between and after, what are the possible errors committed in this set up?
It is emphasized in the procedure that the water bath should be continuously stirred while heating and cooling the sample. What will happen if the water bath was not stirred? Identify its effect to the related derived data
Would you consider Sample 2 to be an outlier? Discuss with evidence and with consideration to the limitations of the test used
The density of the first fraction collected would be expected to be close to a value of ______. 1.00 g./mL 0.895 g/mL 0.789 mL 0.950 g.mL
The amounts reported for the monitored ingredients under internal standard calibration are insensitive to illegal dilutions performed to the preparations, once the internal standard substance was in. True False
Can you please fill the rest of tghe data based on the on inforamtion you have and answer Average percent by mass of acetic acid in vinegar sample (%) ________________ Standard deviation of percent by mass of acetic acid in vinegar sample (%)
What is the purpose of the internal calibration mass at the upper left in the electronic balance
The gravimetric factor used to express CoCBr6·H20 in a sample that is finally weighed as PbClBr is choose below: FW PbClBr / 6 x FW CoCBr6·H20 FW CoCBr6·H20 / FW PbClBr FW CoCBr6·H20 / 6 x FW PbClBr 6 x FW PbClBr / FW CoCBr6·H20
A new method is proposed to simultaneously detectand separatefour foodadditives by reversed-phase liquid chromatography. The data were obtained using theliquid chromatographic column with a flow rate of 0.5 mL per min and with the followingparameters: Pore size 100 A Particle Size 3.5 Internal diameter 4.6 mm Length 150 mm The food additives found in the sample resulted in the following data: ( see image for table) a.Calculate the number of plates from each peak. b.Calculate the plate height for the column. c.Retention factor for each peak.
The following results were obtained in the replicate determination of the lead content of a blood sample: 0.752, 0.756, 0.752, 0.751, and 0.760 ppm Pb. Calculate the relative standard deviation and coefficient of variation of this set of data
During the course of an analysis for a solid sample, a loss of 0.40 mg occurs. Calculate the percentage (%) of relative error due to weight loss inherent in the method. A. When the method is performed on a sample with a total weight of 4.0 mg. B. When the method is performed on a sample with a total weight of 400.0 mg. C. Briefly, discuss what would be the most appropriate sample size ((a) or (b)) for the analysis assuming that weight loss is inherent in the method and is not due to gross error.