Which of the following is NOT TRUE for a state of stress at point for a thin spherical pressure vessel? The maximum in-plane shear stress is equal to zero. O The minimum principal stress is equal to pr/2t. The maximum principal stress is equal to + pr/2t. O The maximum in-plane shear stress is equal to pr/2t.

Which of the following is NOT TRUE for a state of stress at point for a thin spherical pressure vessel? The maximum in-plane shear stress is equal to zero. O The minimum principal stress is equal to pr/2t. The maximum principal stress is equal to + pr/2t. O The maximum in-plane shear stress is equal to pr/2t.

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter8: Stresses In A Soil Mass

Section: Chapter Questions

Problem 8.25P: Refer to Figure 8.27. The flexible area is uniformly loaded. Given: q = 300 kN/m2. Determine the...

See similar textbooks

Similar questions

The flexible area is evenly loaded. Knowing that q = 200 KN / m2, determine the increase in vertical stress at point A at a depth of 4 meters. x = 6m
A thin walled tube of thickness (t) 5mm and diameter (d) 200mm with closed ends is subjected to an internal pressure (p) 7.0 MN/m2, producing an axial and circumferential direct stresses given by pd/4t and pd/2t respectively. A torque T = 15.0 kNm is also applied which sets up a shear stress ? = ?/2??2? where r is the radius. (a) Determine the magnitude and direction of the principal stresses. (b) Calculate the overall maximum shear stress.
a 4 meter square sectional load of 100 kpa is distributed evenly on ground surface determine the increase in stress 4m below the center
The effective stress at a point located at a depth of 5.5 ft in a saturated soil (γm = 108 lb/ft3, γsat = 118 lb/ft3) is most nearly:
An electric power transmission pole is 12 m above ground level and embedded 2 m into the ground. The butt diameter is 450 mm and the tip diameter (the top of the pole) is 320 mm. The weight of the pole, cross arms, and wires is 33 kN. Assuming the pole transmits the load as a point load, find the change in vertical stress in kPa at 2 m depth.
A 4m^2 sectional load of 100 kPa is distributed evenly on ground surface. Find the following : A. Increase in stress 2meters below the center B. Increase in stress 4meters below the center.
Answer the ff: continuation i) The total stress at the depth of 30 meters from the ground surface is: j) The neutral stress directly below the depth of 20 meters from the ground surface is k) The effective stress directly below the depth of 20 meters from the ground surface is: l) What is the unit weight of the fully saturated clay m) What is the unit weight of the dry clay layer? n) The total stress at a depth of 20 meters from the ground surface is: o) The effective stress at the depth of 30 meters from the ground surface is:
Compute for the combined stress
The circular flexible area uniformly loaded (q=320KN/m^2). Determine the change in vertical stress: (a) at point A. (b) at a point 2m below point A
(a) What is the pore water pressure at point A (kPa), and what is the effective stress at point A (kPa) ? (b) True or False: The effective strength at point A will increase if the groundwater table rises to the ground surface.
If the hoop stress on a cylindrical pressure vessel with diameter d, thickness t and gauge pressure p is 58.54 MPa, then the longitudinal stress must be equal to (in MPa)...
a)Calculate the stress components acting on the inclined plane AB. b)Calculate prime stresses c)Calculate the maximum shear stress Shear stress = 60 Mpa