Which one of the following is the most popular data link layer connection used in wired networks? a. Internet b. Ethernet c. Intranet d. None of these

Q: q20-  What is the media access control method used in Wireless technology? Select one: A.…

A: The above question is solved in step 2 :-

Q: Using draw.io, microsoft visio, or lucidchart, Create a network diagram including 5 desktop…

A: Given Components in Network : 5 Desktop computers 1 Laptop computer 1 router 2 switches 1 cloud…

Q: Which of the following is widely used inside the telephone system for long-haul data traffic? a.…

A: It uses a connection-oriented model in which a virtual circuit must be established between two…

Q: Which of these connection technologies are viable for general-purpose networking of more than two…

A: The answer is

Q: Which of the following is not supported by cable modem? coaxial cable carries hundreds of channels O…

A: Cable modem: cable modem is a device that connect to home to internet. cable modem is used to…

Q: In _________, autonegotiation allows two devices to negotiate the mode or data rate of operation. a.…

A: Given DAta:- In _________, autonegotiation allows two devices to negotiate the mode or data rate of…

Q: 18.a. What does an Ethernet network use to synchronize data traffic? A. Coding B. UTP C. STP D. WDM

A: Defined an Ethernet network used to synchronize data traffic

Q: Which of the following is the most often utilised data link layer connection in wired networks? a.…

A: Introduction Data Link Layer is used in transferring the data between various nodes in the network

Q: Your tasks include configuring initial settings using the Cisco IOS. You are to use a switch and two…

A: Step 1: Basically switch and two hosts/PCs and two laptops on a cabled and powered network

Q: Which layer 1 devices can be used to enlarge the area covered by a single LAN segment? Switch O RJ45…

A: a. Switch operates at the data link layer (layer 2) of the OSI model. So option a is incorrect. b.…

Q: * The layer responsible to sent the data from A to B without error called Data link layer O Network…

A: The data link layer is the protocol layer in a program that handles the moving of data into and out…

Q: Which methods are used to switch between primary and protect fiber in a deployed Ethernet network

A: Both STP and RSTP follows the IEEE standards. Spanning Tree Protocol follows the standards of RSTP…

Q: Which one of the following layers provides end to end communication in IoT? a. Session Layer b.…

A: In computer network, there are mainly 7 layers, that include: Physical layer Data link layer…

Q: 20. Which of this is not a network edge device? a. PC b. Smartphones c. Servers d. Switch

A: Which of these is not a network edge device?

Q: 201. Two computers connected by an Ethernet hub are of a. LAN topology b. MAN topology c. WAN…

A: Answer: a. LAN topology

Q: What determines how large (in length) a 10 Mbit / s Ethernet network can be? Group of answer options…

A: Option (d) Number of HUBS is correct Hubs is a hardware device that is used to connect multiple…

Q: AT1 circuit provides a data rate of min 2.5Mbps and more. True or false?

A: According to the information given:- We have to find the correct option to verify the statement.

Q: What Is the Difference Between 10base2, 10base5, and 10baset Ethernet Lans?

A: Intro the question is about What Is the Difference Between 10base2, 10base5, and 10baset Ethernet…

Q: Demonstrate your ability to configure a switch. Your tasks include configuring initial settings…

A: Answer: This question is from computer networking . and we have answered in handwritten format. you…

Q: 1. Name three types of Ethernet. What transmission speed does each support? 2. When using dynamic IP…

A: NOTE: ACCORDING TO COMPANY POLICY WE CAN SOLVE ONLY 1 QUESTION. YOU CAN RESUBMIT THE QUESTION AGAIN…

Q: ain how communication occurs across a local Ethernet network? You must include detail on the…

A: Lets see the solution.

Q: 10.a. Ethernet networks are normally designed using a _______ topology. A. ring B. star C. linear D.…

A: 10.a. Ethernet networks are normally designed using a _______ topology.A. ringB. starC. linearD.…

Q: The below network diagram consists of Rustaq, Middle and Sohar networks. Both Sohar and Rustaq…

A: Given:

Q: 72. Which of the following is an important characteristic of LAN? a. parallel transmission b.…

A: A local area network (LAN) is a collection of devices connected together in one physical location,…

Q: Communication processors such as switches, routers, hubs, and gateways are required for…

A: We are going to understand communication processors and which is used for interconnected network.

Q: What Ethernet cabling category is most suitable in supporting 10GB/s transfer speeds? O Cat 7 Cat 3…

A: Here in this question we have given some ethernet cabling category and we have asked that which is…

Q: Which components of a computer's hardware are required for it to establish a connection with another…

A: Given: Topology is the plan of a network's components (links, nodes, etc.).  Network topology may…

Q: nded to provide access to networking devices for admi

A: VLAN is intended to provide access to networking devices for administrative purposes

Q: 6. Which of the following is a standard type of physical connector for network cables. * 1 point UTP…

A: Find the answer with reason given as below : As per company guidelines we are supposed to answer…

Q: QUESTION 1 For each question, use the dropdown list on the left to select the correct answer from A…

A: Ethernet Cables: These are of two types: Straight - through cable: This cable type has identical…

Q: Ethernet frame, similar to IP packet, has two addresses: source and destination (but MACS). However,…

A: Ethernet frame contains two addresses that are source MAC address and destination MAC address. MAC…

Q: Which of the following is not the type of cable used to connect to the computer network?   Fiber…

A: The answer to this question is aluminium.

Q: Which of the following are true about Network Interface Cards? I. NIC is the combination of…

A: Introduction: The purpose of the network adapter is to connect the computer to the outside world.…

Q: Which type of media uses electromagnetic signals to communicate between IoT devices? a. Copper b.…

A: This question comes from Networking which is a paper of Computer Science. Let's discuss it in the…

Q: Here you see one of the Ethernet frames. Do you see the different layers of the OSI-model Frame 1 /…

A: OSI Model:- OSI stands for open systems interconnections and it is a set of standards established so…

Q: MCQ: Which is the central node of 802.11 wireless operations?   a. WPA   b. WAP   c. Access…

A: Given Data:- Which is the central node of 802.11 wireless operations? a. WPA  b. WAP  c. Access Port…

Q: What is the name of the port used by an Ethernet cable? What is the name of the port used by a…

A: Please find the answer below

Q: Lab - Basic Switch and End Device Configuration Required Resources • 2 Switches (Cisco 2960 with…

A: Step1 : set up the  Network Topology    a) Power on the devices  so first of all we have to power…

Q: Using what we have covered in the course to this point, you are to design and draw a diagram that…

A: Aim :To design and draw a diagram that shows the topology, networking devices, hosts, and other…

Q: Which layer of the Seven-Layer OSI model does network cabling belongs to? 2. Why do we need a…

A: 1. The bottom layer of OSI model is physical layer. Physical layer of the Seven-Layer OSI model does…

Q: Which of the following implement the OSI physical layer? a. Ethernet b. Token Ring c. FDDI d. all…

A: Answer - D. All of the above

Q: 154. Which one of the following is not used in media access control? a. ethernet b. digital…

A: Given that, Which one of the following is not used in media access control? (a) Ethernet (b) digital…

VLAN

VLAN stands for Virtual Local Area Network, and it is created from one or more local area networks. A Virtual Local Area Network (VLAN) is a customized network made up of one or more LANs. It allows a set of devices from different networks to be converted into a single logical network. As a result, a virtual LAN that is managed similarly to a physical LAN emerges.