Answered: Which protocol should be run on the LAN…

Which protocol should be run on the LAN side of the edges router to provide quick failover in case of primary WAN circuits failure? O a. VTP O b. RIP VRRP O d. STP

A+ Guide To It Technical Support

10th Edition

ISBN:9780357108291

Author:ANDREWS, Jean.

Publisher:ANDREWS, Jean.

Chapter8: Network Infrastructure And Troubleshooting

Section: Chapter Questions

Problem 1TC

See similar textbooks

Related questions

Q: Which protocol dynamically reports errors to source hosts by using IP directly to buildpackets?

A: The Internet Control Message Protocol (ICMP)

Q: What is a device called that takes in an Ethernet packet, checks the web addresses, and sends the…

A: What is a device called that takes in an Ethernet packet, checks the web addresses, and sends the…

Q: Which of the following port scans attempts to initiate a communication channel via every available…

A: TCP FIN scan is used to determine if ports are closed on the target machine. This type of scanning…

Q: Which of the following routing protocols offer fast convergence times and can be used on both core…

A: OSPF is a link-state routing protocol, which means that routers exchange topological information…

Q: Since a gateway (NAT) router only has one public IP address, but may forward packets from many…

A: We are going to understand how NAT works and how NAT could remember these many IP addresses to…

Q: Refer to the below exhibit. What protocol should be configured on SW-A Port O/1if it is to send…

A: Lets see the solution.

Q: How long does a station, s, have to wait in the worst case before it can start transmitting its…

Q: AN technique gives physical po

A: Below VLAN technique gives physical ports addresses?

Q: Which Scopes is used to assign IPV4 address pools for Class A, B, and C networks in a DHCP Server,…

A: Normal Scope - Allows A, B and C Class IP address ranges to be specified including subnet masks,…

Q: What device separates a single network into two segments but lets the two segments appear as one to…

A: Answer B) Bridge

Q: You are a network administrator and want to configure both IP v4 and IPV6 in the router interface.…

A: you are a network administrator and want to configure both ipv4 and ipv6 in the router interface.…

Q: XYZ has deployed Routing Information Protocol (RIP) as their routing protocol. Recently, a User from…

A: Step 1 The answer is given in the below step

Q: The SEU has deployed Routing Information Protocol (RIP) as their routing protocol. Recently, a User…

A: Given information : Routing Information Protocol (RIP) has been deployed in the setup. User reports…

Q: Which of the below statements is not true about Exterior Gateway Protocol? An Exterior Gateway…

A: let us see the answer:- Introduction:- The correct option is d) i.e. Exterior Gateway Protocols…

Q: Which of the following port scans attempts to establish a communication channel via TCP three-way…

A: TCP basically stands for Transmission control protocol.It controls all transmission of data in…

Q: In case if a router learned more than one paths that are guide to the destination network from the…

A: Given:

Q: Which is not the element of router? Routing table Forwarding Table Buffers…

A: Given: Which is not the element of the router? Routing table Forwarding Table…

Q: Q6) Which protocol for PPP LCP (Link Control Protocol) performs a challenge handshake? A. CHAP B.…

A: According to the question the handshake authentication protocol is the more secure than…

Q: Which device ( switch /router ) can read ip address attached to a sent message ?

A: Ans:- Router is a device which is used to read ip address attached to sent message.

Q: Which fields are modified in IPv4 and IPv6 packets to help prioritize traffic for QoS?

A: IPv4: IPv4 stands for Internet Protocol version 4. The size of the address in the IPv4 is 32-bit.…

Q: ode is used for LAN? Write the po

A: Sorry for that as the per bartleby guidelines we can solve only one question for you if you want to…

Q: Which of the following is used by hosts and routers to report errors? (A) ICMP (в) NAT CIDR DHCP

A: A distributed denial of service attack is attacked by the attackers which tries to avert allowable…

Q: Which routing protocol does an exterior router use to collect data to build its routing tables? a.…

A: Border Gateway Protocol (BGP) routing protocol uses external router to acquire data and build…

Q: When a fresh IP configuration is required, DHCP clients issue a DHCPREQUEST packet. Is this true or…

A: DHCP Dynamic Host Configuration Protocol is a network management protocol. It is used on Internet…

Q: The differences between Static Routing and Dynamic Routing that is the Static routing is used in…

A: The correct answer options are provided with explanation for question 1,2 and 3 in below steps

Q: Which of the following utilities can be used to check TCP/IP configuration and test…

A: Utilities for checking TCP/IP configuration TCP/IP protocol is used for ensuring the data packets.…

Q: What will the router do when it received a packet and encapsulate this packet with new Ethernet…

A: Dear Student, A packet if has to be dropped is dropped before sending it to the egress port or exit…

Q: • Host A and Host B are connected to a network. Packets sent from Host A to Host B transit through…

A: The answer is

Q: Which MAC protocol has higher efficiency: CSMA/CA or CSMA/CD? You must explain your selection…

A: Answer : CSMA/CD is more efficient then CSMA/CA.

Q: seconds and when the Q4: RIP sends routing updates after every. network changes. Q5: A message that…

A: Answer: Answer-4: The correct answer is 30 seconds. Explanation: The Routing Information Protocol…

Q: Q) Which task is necessary o encrypt the transfer of data between the ACS server and the AAA-…

A: Lets see the solution.

Q: erform a Bridge Configuration in Cisco Packet Tracer Connecting two LANs?

A: Users can plug a router in between Switch A and Switch B (from right here on called Router C, with…

Q: EtherNet/IP communications that are used for real-time l/O data transfers that must occur at very…

A: Before stating the correct answer first let's know about the Ethernet/IP technology. Ethernet/IP has…

Q: Which of these is used to trigger retransmissions in TCP protocol ?

A: Triggering retransmissions in TCP protocol The sender of TCP depends upon the incoming duplicate…

Q: Question 2 You need to create 8 subnets in the 192.168.1.0/24 network. What is the new network mask…

A: Hi, since there are multiple questions in this post, as per our policy, I'll answer the first…

Q: Which protocol is used the majority of the time when bonding ports between busy server and a switch?

A: Which protocol is used the majority of the time when bonding ports between a busy server and a…

Q: Which type of IPV6 address is used to send a single IPV6 packet to multiple destinations? a.…

A: Question from basics of IPv6, we have different types of addresses in Ipv6 like Multicast, Unicast…

Q: Which of the following is used by hosts and routers to report errors? A ICMP B) NAT CIDR DHCP

A: One of the most important protocols in the internet protocol suite is the (ICMP)Internet Control…

Q: Proseware, Inc., requires you to install a 24-port switch that directs TCP/IP traffic to logical…

A: Switches are networking devices that receive the incoming data in form of packets and they direct…

Concept explainers

Properties of different architectures

Software architectures are the blueprint of a software system. They consist of all components involved in a system, relations between various components, the environment of operation, and the principle used in designing the software. In other words, software architecture shows the organization of different software structures and helps understand their behavior.

Question

subject Scaling Networks

Which protocol should be run on the LAN side of the edges router to provide quick failover in case of primary WAN circuits failure?
О а. VТР
O b. RIP
VRRP
O d. STP

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

Which Scopes in a DHCP Server is used to issue IPV4 address pools with the subnet mask, exclusions, and reservations for Class A, B, and C networks? Typical Interpretations Failover Scopes, Multicast Scopes, and Super Scopes
Which of the following routing protocols offer fast convergence times and can be used on both core and edge routers? Choose two.a. RIPv2b. IS-ISc. OSPFd. BGPe. EIGRP
Which Scopes in a DHCP Server is used to provide IP address ranges, complete with subnet mask, exclusions, and reservations, for Class A, B, and C networks? * Typical Interpretations Super Scopes, Multicast Greeting Scopes, and Failover Scopes
Each OSPF router needs to have an unique router ID which is based on the highest IP address on any active interface? Can you talk with items in the hello packet?
Question p 1. What TCP port did the old AOL IM program run on and was referenced in the PCAP challenge? 2. What switch would be used by tcpdump to limit the number of bytes captured by each packet? Full explain this question and text typing work only We should answer our question within 2 hours takes more time then we will reduce Rating Dont ignore this line
I want all TCP traffic originating from my internal network to be allowed back through the firewall on its return from the receiver. What kind of rule will allow this kind of traffic? Port 80 / HTTP Standard Established ICMP
With which type of policy, a router can manage the flow of data and voice traffic, giving priority to voice communications if the network experiences congestion? fault tolerance Scalability QoS Security
Which of the following statements is true about routing functions? A router uses network addresses to forward messages. A router forwards DHCP frames at Layer 2. Both (A) and (B) are correct. None of the above are correct. 2) A WiFi access point is responsible for the following: Flow and error control. Identifying Network protocols. Multiple-access resolution. All of the above.
During the process of redistributing a route into EIGRP, which parameter has to be specified? Exit interface and next hop IP address are all factors that affect administrative distance.