why we don't need to put the ground on the seven segment ic
Q: Q6) A source emits one of four messages randomly every millisecond. The probabilities of these…
A: We need to find out entropy band code for given message .
Q: For a single wire antenna, explain (in your own wc radiation from this antenna.
A:
Q: A three-phase balanced wye-wye system has a line voltage of 208 V ms. The line current is 6 A ms and…
A: Steps: Draw the per-phase model of the given circuit Find R using per phase power loss Find Z using…
Q: 8.8 Explain what is meant by micro stepping.
A: Micro stepping is a process to drive or run stepper motor in which it rotates upto only a fraction…
Q: Q2// Find the equivalent resistance across terminals MN in part B. B/ ww 3.25 Q 2.5 2
A:
Q: PROBLEM: Derive the z-transform for f(t) = sin pt u(t).
A:
Q: Solve the linear differential equation
A:
Q: 2. Consider the variable gain amplifier circuit below. Varying the input Vg will let the…
A: Given Consider the variable gain amplifier circuit below. Varying the input VG will let the…
Q: P5.4 A temperature sensor was connected to a 16-bit A/D converter with 0 to 5 V analog range. The…
A: Analog to Digital Converter: Analog to Digital Converters (ADC) convert analogue electrical impulses…
Q: Determine the Power consumed by the load (Green) when it is connected to a supply voltage of 48Vdc…
A: It is given that:
Q: 23 Given: Vrms = 120 V, what is its peak voltage 84.85 V 169.71 V -169.71V O 339.41 V
A: In this question we need to choose a correct option
Q: 11.63 A balanced three-phase source serves the following loads: Load 1: 60 kVA at 0.8 pf lagging…
A: The solution is given below
Q: 11.27 In a balanced three-phase wye-delta system the source has an abc phase sequence and V= 120…
A:
Q: Find the Fourier transform of e72t O a. None of the answers оъ. 2т6(w + 2) Oc. О с. 6(ш + 2) Ο d…
A: here we have to find the fourier transform of ej2t
Q: circuit Find the R perame ters for the gwon I, V, 2
A: In this question, We need to determine the h parameters. We are using the virtual property of the…
Q: (a) Consider the continuous-time linear time-invariant system with impulse re- sponse sin(4(t – 1))…
A:
Q: 5.16. When operating from rated voltage, a DC machine has a no-load speed of 5,000rpm and rated…
A: Efficiency is defined as x x= (((no load speed)- full load speed)/full load speed))*100
Q: 3dB frequency wo in radians per second. R R VIN Vo Rb 1.2K Ra 1.0K C 0.4uf .1xF R =1000 2 = 4 KR
A:
Q: 19 Given the equation, Ve = 42. 1 V sine, What is the value of peak voltage? 42.1 V 84.2 V 59.54 V…
A:
Q: VCC 12V RC-6.4K Find: RF =220k UA a. Ig = b. lE = C. VCE= d. Vg = e. Vc = B 100 V V %3D RE=1.2k
A:
Q: 11.60 An abc-sequence wye-connected source having a phase-a voltage of 120/0° V rms is attached to a…
A: In this question, We need to determine the total complex power supplied by source and active and…
Q: 2. Unbalanced delta connected load has a. Symmetric Current b. A symmetric current c. Infinite…
A:
Q: Question: With necessary diagrams and equations, describe the operations of single-phase half-bridge…
A: The inverter is a device which converts the DC electric supply to AC. This is majorly used in Power…
Q: Find the equivalent resistance across terminals XY in part A, and MN in part B. A/ 10 2 Xo ww yo ww…
A:
Q: Given FM and PM modulators with the following parameters. FM modulator PM modulator kg = 1.5 KM₂/V…
A: According to the question, for the given data of FM modulator and PM modulator, we need to find the…
Q: A B R1 R3 R6 9 8 R2 4 R4 5 R7 7 R9
A:
Q: A discrete-time signal x(n) is illustrated in Figure 3.1. x(п) 1-0- 0.25 0.0625 0.015625 오 -3 -2 -1…
A:
Q: The task is to determine the number of elements in the vector x = [1, 4, 9, 16, 25, 67] and store it…
A: The vector is like array but unlike array, we don't define its size first. In vectors size is…
Q: Laplace transform of t cos at
A: Laplace transform of t cos at
Q: find the current using maxwell's mesh
A: In this question, We need to determine the current using maxwell's mesh?
Q: What would be the current in a circuit that has two2Ω resistors followed by 3Ω resistor in parallel…
A:
Q: A dc shunt motor is taking 20 A from the 220-V source. The field and armature resistances are 110…
A:
Q: 12. In a balanced Delta- Connected load, current in the impedances are referred a. Dark current b.…
A:
Q: A current filament of 10 7 A in the +X direction lies along x-axis, and a current sheet, K=2 ay A/m…
A: Solution- a) Current filament of 10π Amperes in +ve x direction along axis - produces H1 at P(…
Q: 1. CITAL 2. Qnn %3D TITAL 3. Q2 4. V7 5. Va
A: The total capacitance can be calculated by reducing the parallel connection and cascade connection…
Q: A + ĀB + ABC + ABCD + ĀBCDE = A+ B + C + D + E_ Q1/ Proof that
A:
Q: SHOW COMPLETE SOUTION C2 Cs C8 C7 a=C2 -Ca - 4MF C4 = Cr =Co 2MF CT= C8 = 6AF %3D 1. CNTAL - ?
A: In this question we will find total capacitance and total charge and charge on C2.. Note:- as per…
Q: A 4-pole, 3-phase, 50 Hz induction motor has a voltage between slip-rings on open-circuit of 520V.…
A:
Q: QUESTION 11 The size of the conductor feeding the motor should be able to carry at least 125% 200%…
A: while designing windings of motor, it is made sure that it can handle some percentage of current…
Q: or False. In converting a given sequential circuit to state diagram, getting the boolean expression…
A: 1.) For converting a given sequential circuit to state diagrams consists of various steps which…
Q: Q2 ĀC + AC + B By using NAND gates only, implement the Boolean expression
A:
Q: Assume that r(t) and y(t) are both continuous-time aperiodic signals, and Fourier Transform of æ(t)…
A:
Q: Q/ If the bandwidth of PAM system not exceed 4kHz is used to transmit voice signal sampled at…
A: Given,The frequency is,fm=4 kHz
Q: QUESTION 12 The proper way to determine the required over-current protection is to: determine the…
A: There are several ways to determine the requirement of overcurrent protection as there should be an…
Q: 15 +100 V Solve for the voltage at 40° OV -100 V 36.4 V 43.6 V 64.3 V 100 V
A: We need to find out the value of signal at given angle .
Q: Sketch the root-locus Plot for the system shown in Figure below Ges) s? (s+3)
A: In this question, We need to draw the root locus of the given transfer function.
Q: SHOW COMPETE SOUTION C2 50v C8 C7 C4 = Cr =Co = 2MF C7 C8 6AF %3D 1. CRTAL 2. QnnAL ? 3. Q2 - ? %3D…
A:
Q: Phase deg Gain dB - Ph2 Ph3 Ph 10w W4
A:
Q: 11.69 A balanced three-phase source supplies power to three loads: Load 1: 30 kVA at 0.8 pf lagging…
A: Steps: Find the net active and reactive power Compare with the active power of all load Compare…
Q: The signal is created using a NRZ-I line coding scheme. Find the data bits or symbol. USE: No…
A: The signal is created using an NRZ-I line coding scheme. We need to find the data bits or symbols.…
Step by step
Solved in 2 steps
- [Fill-in-the-blank] in dwelling units shall supply only loads within that dwelling unit or no loads associated only with that dwelling unit. Select one: a. None of these b. Ground-fault protection c. Service-entrance conductors d. Branch circuitsHow we will add them in parallel or series or it does not matterThe ladder diagram of OR gate will have two Normally closed contact in parallel. Select one: True False
- Please answer the "required" portion. Show full solutions with brief explanation. Required: - total resistance in the picture - type of circuit (either parallel-series or series-parallel) between terminals - AC - BCExplain in detail what is a nodal line. Provide an example and diagram for it.Draw a schematic diagram for parallel circuit