With the help of a sketch, explain why and where building separation joints should be provided.   What is creep, and how does it affect the movement of building components? Explain.

Q: Consider Euler's equation for one-dimensional (horizontal) unsteady flow. In a 20 cm diameter…

A:

Q: The following strains were measured using a 0-45-90 degree rosette, with the 0 degree strain gauge…

A:

Q: (3) DESIGN & DETAIL A SHEAR CONNECTION CONNECTION. USE DOUBLE ANGLE (BOLTED - BOLTED) TO COLUMN BOLT…

A: A325 bolts (Assuming threads excluded from the shear planes)R = 80 K(ASD)W 18 x 35

Q: efine surface water, runoff, and watershed (drainage basin

A: In hydrology, surface water, runoff, and watersheds are fundamental concepts that help us understand…

Q: The direct and indirect costs estimated by a contractor for bidding a project is 160000 and 2000…

A: Direct cost DC = Rs 160000,Indirect cost IC = Rs 20000,Markup =10 % of the bid price.

Q: A pressure increase of 200 N/cm² increases the density of water by 0.1%. What is the bulk modulus of…

A:

Q: For the splice connection shown in the figure,  a. Check all spacing and edge-distance…

A:

Q: Given Find Wo к Whenne W₂ = 400db/ft 5ft AMB. ж 7 ft Зооль ft •леасном от Beam бирролу C 000 7777

A:

Q: Find the resultant of the nonconcurrent force system below (Magnitude, Direction, and Location). 10…

A:

Q: What's the Displacement of the beam in mm at 2.0 meters from C?

A: Concrete load  = 6/mTile load = 6/mSteel load = 0.01self weight of beam = 77*(100*150-43.75*125) =…

Q: geomaterial. Case history- Housing Project established in 2013 Location Dubai, UAE Geomaterial (0-6…

A: 1.rapid impact compaction is not a good selection because it is not an accurate on and it is not…

Q: Use: fe'=28Mpa and Fy-420Mpa in all questions. Q1: For the beam shown in Fig. (1), design flexural…

A:

Q: Determine the Reactions of the support in the given truss. ZH|H=0 A WWWwwwww 3m с 3m 50KN B 3m D…

A: Determine the support reaction of the truss.

Q: 1. Calculate the force on each member and the type of load (tension or compression) for the…

A: Determine the force in the each member of the truss.

Q: How might a brick-and-mortar store implement FBA?

A: Fulfilment By Amazon (FBA) is a service offered by Amazon that allows sellers to store their…

Q: 3. Factor Method: The frame shown is subjected to lateral loads as shown. Supports S, T, U V, W and…

A: frame;

Q: (4)+The-sandbag-in-the-figure-below-weighs-50-lb.--The-coefficient-of-friction-between-the-rope-and-…

A:

Q: What are the primary factors influencing the formation and behavior of groundwater in a given…

A: Hydrological system-The hydrological cycle involves the ongoing movement of water throughout the…

Q: A 50 cm diameter precast pile is driven by 9 m into a sandy soil. The standard penetration test…

A: D = 50 cm or 0.5 m L = 9 m Q = 4400 kNFS = 2.5

Q: 2. Consider the system of cable subjected to a uniformly distributed load. Determine the tension at…

A: Diagram;d = d1 = 6 m

Q: : The lower sand layer sand layer in the soil profile of Figure 3a is in an artesian condition.…

A: Given;1 mg/m3 = 9.81 kn/m3

Q: The force applied at the handle of the rigid lever causes the lever to rotate clockwise about the…

A: The wires are unstretched in the horizontal positionclockwise rotationTo find:average normal strain…

Q: Pls answer asap. Complete solution with figure. Determine the discharge in a rectangular channel…

A:

Q: 13- (a) You are about to set a water balance for a sanitary landfill. Draw a definition sketch for a…

A: a).Leachates are produced when water or other liquids percolates and interacts with waste. The…

Q: What is the moment about point C caused by force F? The moment about D? (Answer needed for each…

A:

Q: Determine the force in each member of the loaded truss. The forces are positive if in tension,…

A: ###Determination of members forces of truss using method of joint ###

Q: 2. Use the Green-Ampt method to evaluate the infiltration rate and cumulative infiltration depth for…

A: Note:- I have calculated the values for 1 hr only, similarly the values for time up to 5 hr can be…

Q: A masonry dam with base 6 m wide is subjected to a total horizontal force of 320 kN and a total…

A:

Q: The observed lengths of the sides (in feet) of a five- sided closed polygon traverse are as follows:…

A: The lengths and bearings of a five sided closed traverse are given asCourseLength…

Q: QUESTION 3 What is the allowable bending stress number, sat, in ksi, for grade 1 Steel Material…

A: Grade 1 steel with Rockwell surface hardness of 54 HRC

Q: For a given moist soil, given that volume = 33m3; mass = 33kg; moisture content = 10%; Gs = 2.7,…

A:

Q: 1 THE MASS SPECIFIC GRAVITY OF A FULLY SATURATED SPECIMEN OF A CLAY HAVING A WATER CONTENT OF 30.5%…

A:

Q: The sewage is flowing at the rate of 4.7 million litres per day from a primary clarifier to a…

A: Rate of flow = 4.7 million liters/dayBOD of the influent = 150 mg/lOrganic loading rate = 160…

Q: ABC Construction Company enters into a contract with XYZ Municipality to construct a new public…

A: It is given that ABC Construction Company enters into a contract with XYZ Municipality to construct…

Q: This is a uniform slope. The the soil density is 2350 kg/m3, the friction angle p=30 and the…

A: Density = 2350 kg/m3.Friction angle, Cohesion, C=15 kPaRadius, R=28 mCenter = (10, 40)It is asked to…

Q: B) The rates of rainfall for the successive 30 min period of a 3-hour storm are: 1.6, 3.6, 5.0, 2.8,…

A:

Q: Find the corresponding hydraulic conductivity of aquifer when discharge 3 through the aquifer is…

A: Discharge, Q = 1,500 m3/dayLength, l = 10.000 mBreadth, b = 1,500 mEntry head = 300 mExit head = 250…

Q: (3)+For-the-figure-shown-below, what-force-must-the-man-exert-to-raise-the-crate-of-weight-W?..…

A:

Q: Briefly, Explain How to construct the Forming Limit Diagram (FLD) for any metal?

A: The construct of FLD by the two methods is theoretical and the other is an experimental method.In…

Q: A cantilever beam of span 'L' and uniform flexural rigidity 'Er is loaded with an upward force 'W'…

A:

Q: Q2: Determine the moment at the fixed end (a). 3m 10 kN 3m 2 kN/m ob

A:

Q: Q1/A brake shoe is applied to a drum by a lever AB which is pivoted at a fixed point A and rigidly…

A:

Q: An agricultural land of 486 ha is to be irrigated for a crop having delta as 120 cm and 17 cm of…

A:

Q: Q₁/ Along flexible strip Looting of 2.5m width having a smooth buse, is subjected to amniformly…

A: B = 2.5 m q = 80 kPa

Q: Solve for the Resultant (Magnitude and Location x) for the parallel force system below. A 3 ft 3…

A: To find:The magnitude and location of the resultant.

Q: Su = 50 kPa Vary = 17 kN/m³ Y = 18 kN/m³ 'sat 6 m

A: Assumption of Rankine Earth Pressure Theory :- Soil is Homogeneous and Isotropic.Backfill surface is…

Q: QA 5m deep deposit of silty sand lies above a 4m deep deposit of The undler- gravel. gravel is lain…

A: We know, 1 mg/m3 = 9.81 kn/m3 , Calculation of effective stress ;

Q: The steel connection below shows a beam W310 x 52 connected to column W310 x 74 using 2 Web Plates…

A: CAD Template 1st;

Q: ou take a representative soil sample back to your home laboratory and determine the following data:…

A: Concentration of Al+3 = 2.8 cmol/kg soil 1 AFS soil = 2,000,000 lbs

Q: The Dwelling Broad Form policy provides protection for additional perils insured against, which are…

A: Dwelling Broad Form policy provide protection for additional perils insured against which are not…