Work Example: An electric supply has a demand as following: From To Load Mid night 6 am 400 kw 6 am 12 noon 1600 kw 12 noon 2 pm 5000 kw 2 pm 7 pm 600 kw 7 pm Il pm 3600 kw 11 pm Mid night 600 kw If max generation 10.000 kw, Plot the load curve and find: 1. load factor 2. the reserve capacity 3. utilization factor 4. plant capacity factor 5. the energy consumption during 24 hrs ?

Work Example: An electric supply has a demand as following: From To Load Mid night 6 am 400 kw 6 am 12 noon 1600 kw 12 noon 2 pm 5000 kw 2 pm 7 pm 600 kw 7 pm Il pm 3600 kw 11 pm Mid night 600 kw If max generation 10.000 kw, Plot the load curve and find: 1. load factor 2. the reserve capacity 3. utilization factor 4. plant capacity factor 5. the energy consumption during 24 hrs ?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.18P: Let a series RLC network be connected to a source voltage V, drawing a current I. (a) In terms of...

See similar textbooks

Similar questions

The real power delivered by a source to two impedances, Z1=4+j5 and Z2=10 connected in parallel, is 1000 W. Determine (a) the real power absorbed by each of the impedances and (b) the source current.
Let a series RLC network be connected to a source voltage V, drawing a current I. (a) In terms of the load impedance Z=ZZ, find expressions for P and Q, from complex power considerations. (b) Express p(t) in terms of P and Q, by choosing i(t)=2Icost. (c) For the case of Z=R+jL+1/jC, interpret the result of part (b) in terms of P,QL, and Qc. In particular, if 2LC=1, when the inductive and capacitive reactances cancel, comment on what happens.
Under balanced operating conditions, consider the three-phase complex power delivered by the three-phase source to the three-phase load. Match the following expressions, those on the left to those on the right. (i) Realpower, P3 (a) (3VLLIL)VA (ii) Reactive power, Q3 (b) (3VLLILsin)var (iii) Total apparent power, S3 (c) (3VLLILcos)W (iv) Complex power, S3 (d) P3+jQ3 Note that VLL is the rms line-to-line voltage, IL is the rms line current, and is the power-factor angle.
Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in Figure 2.27. (a) Obtain expressions for P12 and Q12. (b) Determine the maximum power transfer and the condition for it to
The voltage v(t)=359.3cos(t)volts is applied to a load consisting of a 10 resistor in parallel with a capacitive reactance XC=25. Calculate (a) the instantaneous power absorbed by the resistor, (b) the instantaneous power absorbed by the capacitor. (c) the real power absorbed by the resistor, (d) the reactive power delivered by the capacitor, and (e) the load power factor.
. A system consists of two plants connected by a tie and a load is located at plant two. When 100MW are transmitted from plant one a loss of 10MW takes place on the T-line . Determine the generating schedule at both the plant and the power received by the load when λ for the system is GHC 25 per megawatt hour and the incremental fuel cost are given by the equation dF1dP1=0.031P1 + 17 GHC/ MWh ; dF2dP2=0.06P2 + 19 GHC/MWh
Assume that a load of 100 kW is connected at the Riverside substation of the NL&NPCompany. The 15-min weekly maximum demand is given as 75 kW, and the weeklyenergy consumption is 4200 kWh. Assuming a week is 7 days, find the DF and the 15-minweekly load factor of the substation
A load impedance, Zo = 10 + j 3 ohm, is connected to a source with line resistance equal to 3 ohm, as shown in the figure. Determine the average powers delivered to the load and absorbed by the line. The average powers delivered to the load and absorbed by the line are ________ and ____________ , respectively.
Suppose the circuit shown represents a residential distribution circuit in which the impedances of the service conductors are negligible and Vg1=Vg2=120 0° V (rms). The three loads in the circuit are L1 (a new refrigerator, a coffee maker, and a microwave oven); L2 (2 incandescent lamps, a humidifier, and a ceiling fan); and L3 (a clothes washer and a clothes dryer). Assume that all of these appliances are in operation at the same time. The service conductors are protected with 20 A circuit breakers. Will the service to this residence beinterrupted? Why or why not?
A generating station has a maximum demand of 25,000 kW. Calculate the cost per unit generatedfrom the following data: Capital cost = P 120M; Annual load factor = 45%; Annual cost of fuel and oil = P6.5M ; Taxes, wagesand salaries etc. = P6M and Interest and depreciation = 13%
1. A motor load consists of a resistance of 6 Ohms in series with an inductance of 12 mH. Assume 120Vac, 60 Hz supply. a. What is the complex impedance of the load? b. What is the ac current through this load? c. What is theta, the angle between voltage and current through this load? d. What is the power factor? e. What capacitance should be added in parallel with this load to correct the power factor to 1? f. What is the current from the supply when the power factor is corrected?
A generating station distributes the following loads. 3000 kW ,8000 kW,14000 KW and 4000 kW. The maximum demand of the station is 30 MW. The annual load factor is 60%. So – find (1) diversity factor (2) demand factor and (3) number of units supplied.