Answered: write true if the statement if correct…

write true if the statement if correct and change the bold word/phrase to make it correct in nelson's assay, addiion of arsenomolybdic acid to Cu2O will "reduce" copper to Cu2+ ion

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter31: Introduction To Analytical Separations

Section: Chapter Questions

Problem 31.1QAP

See similar textbooks

Related questions

Q: a) b) НО ОН PCC CH2Cl2

Q: Copper has a specific heat of 0.385 J/g °C. 5 g of copper receive 40 J of heat. What was the…

Q: 1. 1. For each of the four IR spectra shown in A and Fig. B tell which of the six bonds are present…

A: A question based on IR spectroscopy that is to be accomplished.

Q: 4.05 kg + 567.95 g + 100.1 g

A: Given-> 4.05 kg + 567.95 g + 100.1 g ->In addition and subtraction answer contains least…

Q: Name this compound: O ortho-methoxyphenol O meta-methoxyanisole o meta-methoxyphenol O…

A: The IUPAC name of the compound can be written on the basis of the number of carbon atoms in the main…

Q: In his experiment, Jireh wanted to determine the molar mass of his unknown sample. Based on his…

Q: Calculate the cell potential for the reaction as written at 25.00 °C25.00 °C, given that…

A: Given-> [Cr2+] = 0.790 M [Fe2+] = 0.0190 M T = 25°C

Q: Assignment Reaction progress data of the decomposition of NO were collected and graphed Reaction…

A: Given, Graphical representation of decomposition of NO2. The decomposition reaction of NO2 :…

Q: 1. A special sample of household vinegar contained 7.3% acidity. Determine the number of moles of…

Q: Chemistry Determine how many atoms are in each formula and then determine the molar mass. Show your…

Q: appropriate torg. 5. Aromatic ketones can be prepared by of an aromatic ring 6. Acetaldehyde…

Q: Give the systematic name of the compound: 00 || CH3CH₂COCCH3

Q: For chemical reactions, which one of the following is correct. Ο ΔΕ =q+w Ο ΔΕ =q-W Ο ΔΕ =-q-W Ο ΔΕ…

Q: write true if the statement if correct and change the bold word/phrase to make it correct the…

A: We have to identify whether the statement is true or not

Q: Write the formula for the following compounds: mercurous dihydrogen arsenate stannic perchlorate…

Q: :CI: O :CI:

A: Tertiary (3°) carbocation is more stable than secondary (2°) carbocation which is more stable than…

Q: Chemical Formulas Scientific Notation Periodic Table Tables Calculate the pH of an aqueous solution…

Q: لد EFG OGFE 0 0 12. OHIJ JIH ه 13. (0) MLK KLM CH₂OH, dry HCI NH2OH, H* دهد CI CH₂OH EFG OH HIJ KLM…

Q: 1. If 1.39 g of carbon monoxide is reacted with oxygen, what volume of carbon dioxide is produced at…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 04 = (b) Calculate the pH of 0.0005 mol dm³ ethanoic acid when its pK₁ 4.75 CH₂COOH(aq) à CH₂COO…

Q: Precipitation Reactions with Polyatomic Ions Balance the following a. V3+ (aq) + BrO4 (aq) → b.…

A: Since you have asked a question with multiple sub-parts, as per our company guidelines we are…

Q: Sample Problem: . A 0.3516 g sample of commercial phosphate detergent was ignited at a red heat to…

A: Given : Mass of sample = 0.3516 g Mass of residue i.e Mg2P2O7 =0.2161 g

Q: Indicate whether the pair of structures shown represent stereoisomers, constitutional isomers,…

Q: Give the systematic name of the compound: O -CH₂CH₂CH₂CH

A: Give the systematic name of the given compound?

Q: A carbohydrate has the molecular formula C6H12O6 and has three chiral carbons. Is this a ketohexose,…

Q: If you assume that there is 5% acetic acid in vinegar, how much vinegar should you weigh out so that…

A: Molar mass of acetic acid - 60.052 g/mol Given, Vinegar contains 5 % acetic acid Base required to…

Q: Draw all of the isomers of C4H8. Name each isomer

A: The isomer is the compound having same molecular formula but different structure.

Q: The compound Fe(OH)3 3 would be called:

A: Given: The objective is to find the name of the compound Fe(OH)3

Q: You are to prepare each of the following 100–mL Test Reagents in the Laboratory with concentrations…

A: Given, To prepare 5% (w/v) Sodium hydroxide solution with density 2.35 g/mL. The molality, molarity…

Q: 1. Write the equation of the reaction of oxidative deamination of alanine (in vitro). Specify the…

Q: explain further

Q: A solution is prepared by condensing 3.89 L of a gas, measured at 28.1°C and 727 mmHg pressure, into…

Q: Chemical equilibrium and common ion effect complete notes summary without calculations

A: We have to elaborate chemical equilibrium and common ion effect.

Q: Given the AH for the following reactions, P4(s) +6C12(g) →→ 4PC13 (8) AH = -2439 kJ 4PC15(g) → P4(s)…

Q: How many grams of Fe are produced from 678 g of Fe₂O3 according to the following reaction? Fe₂O3+3CO…

Q: Draw the structure of the following tripepide(one-letter abbreviation is given) at a pH 7.0. F - E…

A: The tripeptide is F-E-M, where F is Phenylalanine, E is Glutamic acid, and M is Methionine.

Q: For each of the following acid-base reactions, calculate how many grams of each acid are necessary…

Q: 2. Add 1-2 mL (20-40 drops) of 1.0 M silver nitrate solution to a test tube. CAUTION: Silver nitrate…

A: In In organic Chemistry, there are four main types of reactions. Combination reaction in which two…

Q: At a certain temperature this reaction follows second-order kinetics with a rate constant of…

Q: Module 1: You have been linked to a version of you where you have hotdogs for fingers, fearing that…

A: Given : Amount of energy = 12 eV Conversion factor : 1 eV = 1.6 x 10-19 J 1 J = 5 aken 1 aken =…

Q: Write the cell notation for the galvanic cell that incorporates each of the following redox…

Q: Calculate the pH of 1.00 L of a 0.269 M hypochlorous acid solution before and after the addition of…

A: Given, Molarity of HClO = 0.269 M Volume of HClO in L = 1.00 L Moles of KClO = 0.247 mole Find…

Q: What is the percent, by mass, of oxygen in NiSO4.7H₂O? O 49.531% O 62.661% O 39.875% O 14.846 % O…

A: Given chemical formula of the compound NiSO4.7H2O. The percent by mass of oxygen in NiSO4.7H2O is

Q: Among the following molecules, identify the one that corresponds to the IR spectrum presented below.…

A: We have to determine the compound from the given infrared (IR) spectrum.

Q: 3-chloro-6,7-dimethyloct-1-ene and (E)-1-chloro-5,6-dimethylhept-2-ene are primary and secondary…

A: Unimolecular nucleophilic substitution reaction (SN1): This reaction proceeds in two steps. The…

Q: One of the commercial uses of sulfuric acid is in the production of calcium sulfate and phosphoric…

Q: 11 g of CaCl₂ are dissolved in 125 g of water. The calorimeter indicates a temperature change of…

A: Given the mass of water taken, m = 125 g Temperature change of water, ∆T = 2.5 oC

Q: For NH4Cl and NaCH3COO, perform the following calculations: 1. Calculate [H3O+] using the equation…

Q: 4 1. Which of the following are considered organic compounds? Circle all that apply. A. CO₂ F.…

A: 1) organic compound are those compounds which are made up of carbon and hydrogen or some hteroatom…

Q: Which are true about p-nitroacetophenone and p-methoxyacetophenone? Select the correct response(s):…

Concept explainers

Potentiometric Titrations

Potentiometric titration is one of the important titration methods and is mainly carried out to characterize acid solutions. It follows a method similar to that of the normal titration technique, but the main difference is that there is no indicator used in the potentiometric titrations. Instead of using an indicator, electrodes are employed for monitoring the whole titration process. A scientist named Robert Behrend did the potentiometric titration for the first time, and it was done using the mercurous solution and potassium chloride.

Question

write true if the statement if correct and change the bold word/phrase to make it correct

in nelson's assay, addiion of arsenomolybdic acid to Cu2O will "reduce" copper to Cu2+ ion

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

At a pH of 10 what is the fraction of EDTA that is in the form Y4-? I got 0.30 but I believe that is wrong.
For each of the following statements, answer True or False and explain your answer briefly. It is preferred to apply colour tests, as a screening test, over microcrystalline tests in drug analysis.
The stock erythrosine B solution is 8.5 × 10-5 M. Calculate the volume of this solution that you must pipet into a 50-mL volumetric flask, which, when diluted to mark with deionized water, will give a final concentration of 1.7 × 10-5 M. Show your calculation setup.
Explain what happened to the salt (the inorganic impurity) during the extraction process. Where does it go and why?
What is the purpose of an auxiliary complexing agent?
Will the UV-Vis spectrometer be able to measure concentrations of 1.3 mg/L and less as per the action level of Cu2+ set by the EPA’s Lead and Copper Rule?
Identify major sources of error in this experiment. Explain how the magnesium: oxygen ratio would be affected by each error you identify. https://youtu.be/R9bUO70UfN8
If an analytical method relies on a measurable property of an analyte that can be correlated with the amount of the said analyte, what type of analytical method is it? Oxidative methods Instrumental methods Blank Correction methods Classical methods
Can electrogravimetry give total copper concentration and determine the concentration of specific species of either Cu(II) or Cu (I)? Why? And does it require a standard calibration curve? If not, how can the amount of analyte be determined?What about Polarography?
When using ion-selective electrodes, to comensate for a complex or unknown matrix, the __________ method can be used to determine the analyte concentration. a) least-squares analysis b) standardization c)standard addition d)dilution e)calibration curve
Based on the data, calculate the concentration of analyte in the ORIGINAL sample in ppm. Report to 1 decimal place Sample: A 10.00 mL aliquot of the unknown was placed in a 100.0 mL volumetric flask and made up to the mark will distilled water. The absorbance of this solution is 0.185. Sample + Spike: A 10.00 mL aliquot of the unknown and a 13.00 mL aliquot of the 46.00 ppm stock were both placed in the same 100.0 mL volumetric flask and diluted to the mark with water. The absorbance of this solution is 0.326. ( Please type answer note write by hend)
please help with 1 and 2, all information given Calculate the number of moles of Zn2+ in the 20 mL aliquot (show workings) 1.050/65.38= 0.016mol (0.016x20)/250= 0.00128mol Calculate the number of moles of EDTA in the average titre (show workings) Mol EDTA= 0.00122 Volume of EDTA consumed= 0.02106L 0.00122mol/0.02106L=0.0579mol 1. Calculate the concentration of the EDTA solution (show workings) 2. Calculate the concentration of the DILUTED EDTA solution (show workings) Sample No. 1 2 3 4 Final Burette reading (mL) 20.25 42.75 22.90 44.50 Initial Burette reading (mL) 0.05 20.25 1.50 22.90 Final-Initial Titre (mL) 20.20 22.50 21.40 21.60