Answered: :X 32 Decoder can be constructed using…

:X 32 Decoder can be constructed using 5 .a Two 3 X 32 Decoder .b None of the choices .C Two 4 X 16 Decoder .d Two 3 X 8 Decoder .e Can't use a smaller size decoder to construct a larger decoder

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter8: Data And Network Communication Technology

Section: Chapter Questions

Problem 30VE

See similar textbooks

Related questions

Q: Both frequency and phase remain constant while the amplitude changes in a. QPSK O b. ASK O c. PSK O…

A: ASK, FSK and PSK are digital modulation technique.

Q: Q2The signal-to-noise ratio is often given in decibels. Assume that SNRAB=38 and the channel…

Q: What should be the theoretical minimum sampling frequency for the signal to be reconstructed in the…

A: Theoretical Value of sampling frequency is always equal to 2 times the signal frequency. Hence Ns…

Q: 1. WAP to generate a Fibonacci series up to n terms. Input Input number of terms: 10 Output…

A: Theory of combinatorics you need to know for Finding nCr nCr = n-1Cr-1 + n-1Cr nC0 = nCn = 1

Q: In decoding a digital signal, the receiver calculates a running average of the received signal…

A: Line coding is the process of converting digital data to digital signals. One of the characteristic…

Q: Q2. A signal travels from point X to point Y. At point X, the signal power is 100 W. At point Y, the…

A: answer is

Q: Identify the incorrect statement shown below? O a. Interference signal from one channel to another…

A: The correct option is given in step 2.

Q: 1. The source encoder is responsible for decompression. 2. The output of the channel decoder is the…

A: Note: Since the question is multiple one we are advised to do only first three question. Kindly post…

Q: Channel Capacity(C) was found to be 1.44 S/No where S represent signal power and No is the Noise…

A: Channel capacity(C) is the number of bits allowed through channel per second. For no information…

Q: In a block, the mask is 255.255.240.0; what is the length of ne Select one: O a. 20 bits O b. 28…

A: Here have to determine length netid from mask 255.255.240.0

Q: For BPSK modulator fc= 70Mhz, input bit rate 10Mbps.Determine Upper and lower frequency? baud rate?…

A: Given Data

Q: Five signal channels are sampled at the same rate and time- multiplexed. The multiplexed signal is…

Q: 03: Show the signals of the outputs fin the figure below as functions of the three inputs a, band e…

A: Introduction of Logic Gates in Digital Electronics: In digital electronics, the logic gate takes…

Q: How many 2-line-to-4-line decoders are required for a 1-line-to-16-line decoder?

A: The solution is given below:

Q: distortion is specified not to exceed 1.5% of the peak-to-peak analog signal. Q17/ The information…

A: the answer is given below:-

Q: The correct way to detect errors during data transmission process is to: a) Ask someone at the other…

A: Computer network: A group of computer system or computer nodes that are connected to each other and…

Q: Line decoder is similar to demultiplexer except that there is _____ input line. a) two b) one c)…

A: De-multiplexer Decoder Takes one input line signals and produce multiple output lines It takes n…

Q: a. Mux4*1, A,B is the selection lines b. Mux4*1, B,D is the selection lines c. Decoders 3*8

A: Below is the Solution

Q: Ramp signal are use in PWM demodulator O True O False Crosstalk is happened due to expand in filter…

A: The answers for the given questions are as follows.

Q: 1. Construct (4x 16) decoder from (3x8) decoder?

A: Please give positive ratings for my efforts. Thanks. ANSWER using two 3-8 decoder chips: You…

Q: Ten 10-kHz signal channels are sampled and and multiplexed at a rate of 25 k samples/s per channel.…

A: Ten 10-kHz signal channels are sampled and multiplexed at a rate of 25 k samples/s per channel. 25…

Q: *A common metric can either be (choose one or more correct answer) .23 hop count bandwidth Frame…

A: Hop count, bandwidth, delay, current load on the path, reliability, or a mix of two or more of these…

Q: The transition band denotes the frequency range between the passband .and the stopband true O false…

A: Yes,the transition band denotes the frequency range between the passband and the stopband.

Q: Senders A and Senders B want to send data A d = 101 and B d = 100 respectively using CDMA…

A: The timing diagram is given below as:

Q: VHDL: Four Bit Wide 2 x 1 Multiplexer What's the VHDL Code for the Four Bit Wide 2 x 1 Multiplexer?…

A: According to our guidelines we are authorized to answer only one question at a time if you want…

Q: How many 2-to-4 line decoders are required to design one 4-to-16 line decoder? Os

A: Using 2-to-4 line decoder building 4-to-16 decoder, So, we need 5 total 2-to-4 decoder to build a…

Q: Initial Values 1962, | 2952, 1047, 436, 200, Initial Values 0 0 1962, 2952, 1047, 436, 322, TO:…

A: Short for drive select, DS is a primary jumper setting used with IDE disk drives. When a computer…

Q: A 3:8 decoder is shown on the right. If the input abc = 110 and EN' = 0, %3! which output will be 1?…

A: The correct answer is "6".

Q: Compute the Huffman codes for this source. Compare between the two resu

A: Distinguished source The source of information with an alphabet or a discrete time and amplitude…

Q: What is the output signal voltage for a gain of 20 and input voltage of 20mV? O 10V O 4V O 400mV O…

A: Question. What is the output signal voltage for a gain of 20 and input voltage of 20mV? a) 10V b) 4V…

Q: The device shown here is most likely a D So EN Select one: O a multiplexer O b. comparator O c…

A: Here in this given circuit we have 1 input line D 2 Select lines S0 and S1 EN which is used to…

Q: Q1: Answer the following as true or false 7- De-multiplexer is used to connect a single source to…

A: Statements regarding digital logic device are given here, and we have asked which of them are…

Q: V For a bit stream 0 1010 10 1, sketch the waveforms for (i) NRZ-I Note: (i) For NRZ-I and…

Q: Given that A=0, B=0, C=1, what are the values of F an Y in the following circuit? Do D D2 3X8 D. Low…

A: For the below given circuit, need to find value of F and Y, when A = 0, B = 0 and C = 1. Where F…

Q: How many 2-to-4 line decoders are required to design one 4-to-16 line decoder? O 1 O 3 O 7 5

A: A 4x16 decoder has four inputs and sixteen outputs, with the outputs turning high when the input is…

Q: Build a 2-to-4 decoder with Enable and provide a picture or snapshot of the circuit here. ii)…

A: Below i have given:

Q: In CRC if the data unit is 100111001 and the divisor is 1011 then what is dividend at the receiver?…

A: Option b is the correct answer detailed explanation is in step 2

Q: 10 How many 2-to-4 line decoders are required to design one 4-to-16 line decoder? O 3 O5 07

A: to design 4 × 16 decoder using 2x4 decoder 16 output lines and 4 input lines

Q: 5: Design a 3x8 decoder using 1x2 decoder?

A: Actually, the answer has given below:

Q: 4. Given a multiplexer: Assume i3 = 0, i2 = 1, il = 1, and iO = 0. a) If s1 = 0 and s0 = 0, then y =…

A: Multiplexer: It is an electronic switch that can connect one out of 'n' inputs to output. It cannot…

Q: Which of the following best describes how to construct a 1 to 8 demultiplexer from a 3 to 8 decoder:…

A: Which of the following best describes how to construct a 1 to 8 demultiplexer from a 3 to 8 decoder?…

Q: 11 How many 2-to-4 line decoders are required to design one 4-to-16 line decoder?

A: 1) Use one 2 to 4 decoder to convert 2 inputs to 4 outputs first. 2) Then take these outputs to…

Q: MP can only respond to one signal on INTA at a time true false O

A: Microprocessor controls all functions of the CPU, or central processing unit, of a computer or other…

Q: An NRZ (Non-Return to Zero) means that no bit is encoded with Zero level volts. Select one: A. True…

A: NRZ means that signal won't return to 0.

Q: F (A, B, C, D) = A'B + C'D + AD . What is the type of the decoder? (Example. 3-8 active high…

A: Decoder is a combinational logic circuit that converts coded input to coded outputs provided both of…

Q: Question 6: The figure below shows a 2 to 4 decoder. Add to this decoder an active low enable EN'.

A: Active low encoder means When we give input 1 then Decoder will not work i.e, Decoder will give…

Q: 1.What is the function of decoder? 2.Which of the following has 4 input lines and 16 output lines ?…

A: 1. A decoder is a circuit that changes a code into a set of signals 2. 1.decoder

Question

W:51)

:X 32 Decoder can be constructed using 5
.a
Two 3 X 32 Decoder
.b
None of the choices
.C
Two 4 X 16 Decoder
.d
Two 3 X 8 Decoder
.e
Can't use a smaller size decoder to construct a
.larger decoder

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

In which modulatio technique is bit rate equal to baud rate? a. ASK b. BPSK c. all of the choices d. FSK
hand written asap plzz
Which encoding technique solves the loss of synchronization because of long 0’s and 1’s? A. Manchester B. Psuedoternary C. Polar-NRZ D. Polar-RZ
True or false, and briefly explain your responses on the following questions: When the transmitter and receiver window widths are both one, the alternating-bit protocol is equivalent to the SR protocol.
Digital logic design Company decides to monitor its employees packet data usage and decides to take action against the employees who are using more than 2GB per week. The company consists of 5 employees and employee’s data usage per week is given below E1= 1GBE2= 5GBE3= 12GBE4= 1.5GBE5=0.5GBDesign a system which works such that the output is 1 if the data usage is more than 2GB and its 0 otherwise.
What is the overall rotational delay and seek time?
Q) Can polling and DMA be used together? If yes, give an example
1. Determine whether the following statements are true or false. Transmitter converts data into signal suitable for transmission media. Answer: Flow control is a task of application layer. Answer: Amplitude shift keying is less susceptible to error than binary frequency shift keying. Answer:
1)If the probability pk of a message is 1/8 then the information in bits is ____________ 1 bit. 3 bits. 2 bits. None of them. 2) Bipolar RZ line codes ensures both zero DC, and synchronization at every bit. FALSE TRUE 3) In _______, a receiver can use an error-correcting code that automatically corrects certain errors. FEC Huffman coding ARQ Line coding 4) Coaxial cable is more susceptible to external noise than fiber optics cable. FALSE TRUE 5) Which of the following requirement must be met for fast communication? High channel capacity. High sampling rate. High transmitter power. Large signal bandwidth.
We can't transmit a digital signal straight to the available channel if it's a channel.a. low-pass b. bandpass c. low rate d. high rate a. low-pass b. bandpass c. low rate d. high rate
Quadrature amplitude modulation (QAM) is a combination of ASK and PSK explain?
ITDiscuss Multiplexing/Demultiplexing?