xplain the different types of electrical loads in detail with at least one practical example for each load.

Q: Three resistors are connected in series across a 12-volt battery course. It has found to be that the…

A: Given, three resistors are connected in series across a 12-volt battery, Let, R1​, R2​ and R3​ be…

Q: . Why do we use voltage dividers in an electric circuit? (at least two reasons)

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: If the cross sectional area of a conductor is doubled, then the resistance of the conductor remains…

A:

Q: Could several panels be placed in parallel in order to increase the power of the system? What…

A: Yes, if numerous panels are connected in parallel, the system's power is increased. When solar…

Q: What are the application of subtractor

A: The explanation is as follows.

Q: Shown below is a DC circuit that contains a number of switches. The resistance of each switch is…

A: We have to rank as per ammeter reading from highest to lowest.     Let we consider,  R= 1 ohm and…

Q: Shown here is a simplified representation of an electrical power plant and a house, with the source…

A: Power transmission : transmission of electricity from generating site to home is known as power…

Q: Explain why hydropower generation is said to be according to sizes.Give at least three examples.

A: Hydropower generation is said to be according to size because 1) The capacity of the Hydropower…

Q: a.a. Which of the following statements about grounding electrode conductors is true? A. They…

A: a.a. The grounding electrode must be connected to earth and electrical equipment in such a way that…

Q: 2. In Figure, the battery voltage is V = 65 volts, and the values of the resistances, in ohms, are…

A: The solution can be achieved as follows.

Q: Discuss the arcing phenomenon in a circuit breaker. Please write more answer

A: Phenomenon of Arc :- A Circuit breaker consists of two contacts namely "fixed" and "moving contacts"…

Q: Which one of the following bridges will be- used for the measurement of very low resistance ? (a)…

A: Maxwell bridge and Hay's bridge is used for the measurement of frequency of the circuit these bridge…

Q: ) - Is a resistor an ohmic or a non-ohmic conductor? Explain in detail. 2) - Why would you plot a…

A:

Q: 1.- Please explain photovoltaic-effect- and electrical model of PV panel by drawing the figure

A: Different energy sources are required in day to day life. These energy sources can be renewable or…

Q: What is the resistance of a copper bus-bar,as used in the power distribution panel of a high-rise…

A:

Q: If we want to use wind as the source of renewable energy, we must use wind turbines. List all the…

A: The wind turbine are classified on the basis of,1. Design2. Size According to design these are of…

Q: What are the different classification of fire protection systems? Tell their differences and example

A: The fire protection systems are broadly classified into five categories. These are: 1. Fires of…

Q: What are the  circuit  conditions  when  a Wheatstone bridge is “balanced”?

A: We need to tell about balanced condition for bridge .

Q: Draw the resistor schematic symbol. What is the reason of the materials resistance in the circuit?…

A: In these question we have to give resistance symbol ,reason behind resistance and it's SI unit.

Q: Discuss five (5) good practices in electrical circuiting.

A: Always use gloves while working with electrical equipment and gloves must be insulated. While…

Q: Write a story that reflects the graph. Break up the graph into 5 sections. Be as descriptive and…

A:

Q: Define Kirchoffs Voltage rule with an example.

A: According to the context of the given question, the Kirchoff's Voltage Rule (KVL) is to be explained…

Q: .Explain with neat diagram of any one solar energy thermal application.

A: Solar Energy Thermal Application:

Q: Three resistors A, B and Care connected in series to a 126-volt dc source. If the resistance at A is…

A: The solution can be achieved as follows.

Q: Explain the electrical scenarios briefly 1. Aluminum Wiring

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Explain how geothermal system is employed in HVAC application with a neat diagram.

A:

Q: The total resistance for the configuration

A:

Q: n an outdoor substation the three bus-bar conductors are supported by units of post type insulators.…

A:

Q: What will be the resistance of Ammeter in order to reduce the Loading Effect? a) Insulation b) High…

A:

Q: teach me all about electricity chapter with full explanation and concept

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: (a) If element X of the circuit is an independent current source, with the arrow pointing upward,…

A:

Q: (a) Table 1 shows the base current, base voltage and the real resistance values for the cable types…

A:

Q: Question 3: A very simple model for the distribution of electricity to a typical home is shown in…

A:

Q: Electric metal tubing (EMT) provides protection from ____. Select one: A. INADVERTENT GROUNDING B.…

A:

Q: What is the difference between active and passive loads

A:

Q: 2. In Figure, the battery voltage is V 65 volts, and the values of the resistances, in ohms, are 38,…

A:

Q: Explain V-I and PV characteristics of solar cell or PV systems

A: Solar cell converts light energy into electrical energy.

Q: List some loads that you use in your household and identify the form of output energy. (Complete…

A:

Q: Example of home assessment environment electrical related for person in wheel chair.

A: Home assessment environment- The term Home assessment environment defines a house equipped with…

Q: Q11-e) State five (5) examples of electrical hazard sources that can be found in home or office.…

A: A major workplace danger that exposes employees to burns, electrocution, shock, arc flash/arc blast,…

Q: Calculate the value of the shunt resistor, RA, to give a full-scale current reading of 100 mA.…

A: In this question we will find shunt resistance value ...

Q: A cable is tested by loss of charge Method using a Ballistic galvanometer with following results :…

A:

Q: Which of the following are used by scientist and electricians for ease of work? a. circuit diagrams…

A: The explanation is as follows.

Q: How does the concept of open circuits apply to the 120-v AC voltage from your home's power line?…

A: Open circuit voltage is the difference in the potential of two terminals of the device when the…

Q: What are the elements of Power System

A: In this questions we will write elements of power system..

Q: A) Explain earthing and its importance in electrical installation.

A: According to guidelines we need to solve only the first question. According to the question we have…

Q: The formula to calculate the load regulation is

A:

Q: Determine the power across 10 volts supply after solving the circuit by nodal analysis.

A:

Q: (A) Explain the difference between series and parallel resistor circuits in terms of (1) the…

A: Resistor: Electronic components with a constant electrical resistance are known as resistors. A…