You are studying the fluid flow inside a pipe that is so wide and so short that its boundary layer remains very thin in comparison to its diameter. Which one of the principle or equations listed below would you use to calculate the flow speed from knowing the pressure at its inlet and outlet? A) Pascal’s principle B) Bernoulli’s equation C) The Hagen-Poiseuille equation D) The Darcy-Weisbach equation E) The capillary height equation

Q: A cylindrical container with a cross-sectional area of 69.2 cm? holds a fluid of density 776 kg/m3.…

A: Data Given ,  Cylindrical Cross-sectional area ( A ) =  69.2 cm2 = 69.2 × 10-4 m2  Fluid density ( ρ…

Q: The Venturi tube shown in the figure below may be used as a fluid flowmeter. Suppose the device is…

A: ρ = 711 kg/m3 r1 = 2 cm = 0.02 m r2 = 1 cm = 0.01 m P1 - P2 = 1380 Pa v1 = ?

Q: Suppose you have a wind speed gauge like the pitot tube shown in Figure 14.32. By what factor must…

A: The speed is directly proportional to the square root of the h,

Q: The inside diameters of the larger portions of the horizontal pipe are 2.50 cm. Water flows to the…

A: Let d1 be the inner diameter of the cross-section of the larger horizontal pipe, and R be the flow…

Q: A simple water tank with a cross-sectional area of 1.0 m² is known. The liquid in the tank is pumped…

A: Discharge is defined as the ratio of volume of the flow per unit time. It is denoted by Q. Discharge…

Q: 9.10 please answer part b, other parts are answered. The hints for part b are: (1) Bernoulli's…

A: Given:- A sump pump (used to drain water from the basement of houses built below the water table) is…

Q: Gasoline is piped underground from refineries to major users. The flow rate is 3.00 X 10-2 m3/s…

A: Given data: The flow rate of the gasoline is Q=3.00x10-2 m3/s. The viscosity of the gasoline is…

Q: Does the pressure double when the density of the fluid doubles? Why or why not? Explain the

A:

Q: ottom of a cylindrical container with a cross-sectional area of 45.5 cm2 and holding a fluid of…

A: We  know that We have given that The pressure at the bottom of a cylindrical container is 115 kPa…

Q: Question 4. A horizontal pipe which has a cross-section area of 10 cm? is connected to another…

A: To determine,Part athe speed(v2) of water in large pipe.part bthe pressure in the large pipe(P2)part…

Q: A fluid of specific gravity 1.0 is flowing through a horizontal conduit at a velocity 2.0 m/s before…

A:

Q: Q1: A cubical box 25.00 cm on each side is immersed in a fluid. The pressure at the top surface of…

A: SIDE OF CUBICAL BOX = 25cm = 0.25 m  pressure difference from top to bottom of box is   pressure…

Q: The pressure in the xylem near the base of a tall tree is 1.00 atm. Part 1 What is the pressure in…

A: ...

Q: Which fluid principle states that a change in pressure at any point in a confined fluid is…

A: Given  a statement that “change in pressure at any point in a confined fluid is transmitted in all…

Q: Given the depth and acceleration due to gravity, what formulas and equations are the best to use in…

A: Given : Depth=h Gravity =g

Q: A pressure gage 7.0m above the bottom of a tank containing a liquid reads 64.94 kPa; another gage at…

A: We are allowed to answer only the first question. For solutions to other questions, please re-post…

Q: Water flows smoothly through a pipe with various circular cross-sections of diameters 2D, 6D, and D,…

A:

Q: Pressure in the spinal fluid is measured as shown. If the pressure in the spinal fluid is 10.0 mmHg:…

A: Given information: Here, PHg is the pressure in the spinal cord in mmHg, h is the height and ρ is…

Q: Water flows in the horizontal pipe shown in the figure.  At A the diameter is 5.00 cm and at B the…

A: Diameter of the section A is d1 = 5 cm = 0.05 m Diameter of section B is d2 = 4 cm = 0.04 m Density…

Q: The horizontal constricted pipe illustrated in Figure below, known as a Venturi tube, can be used to…

A:

Q: The cross-section area of Piston A1 is 0.000400m2 The cross-section area of Piston A2 is 0.000800m2…

A: Given data: Cross-section area of  Piston 1 (A1) = 0.000400 m2 Cross-section area of Piston 2 (A2) =…

Q: An ideal fluid, of density 0.90 x 103 kg/m3, flows at 6.0m/s through a level pipe with radius of…

A:

Q: Water flows through a water hose at a rate of Q1 = 580 cm3/s, the diameter of the hose is d1 = 1.99…

A: Given ,  flow rate ,Q1 = 580 cm3/sdiameter , d1 = 1.99 cmvelocity , v2 = 11.2 m/s Area = πD22 =πD24…

Q: 1. Which of the following is NOT a unit of pressure? A.Atm        C. Pascal B.N/m2      D.…

A: There are three different questions. According to guideline I solve only first one. Please post…

Q: A pipe of cross sectional area 2.34 m2 narrows while splitting into three pipes, each of…

A:

Q: Blood flows through a pipe, passing from the wide section with cross-sectional area A1, as shown…

A:

Q: Suppose that two tanks, 1 and 2, each with a large opening at the top, contain different liquids. A…

A:

Q: A fluid of a constant density flows through a reduction in a pipe. Find an equation for the change…

A: According to the Bernoulli's principle . Total energy of a ideal fluid is constant . and given that…

Q: A liquid of density 800 kg/m³ flows through a horizontal pipe that has a cross- sectional area of…

A:

Q: Fluid flows in a pipe of different radii: point A - 3 cm; point B – 1 cm; point C - 5 cm. If the…

A: the equation of continuity says,A1v1=A2v2where, A1=cross-sectional area of region 1 v1=flow velocity…

Q: A hypodermic needle is 3.00 cm in length and 0.300 mm in diameter. What pressure difference between…

A: Write the formula for the radius of the needle.

Q: Both a gage and a manometer are attached to a gas tank to measure its pressure. If the reading on…

A: Given:  P = 80 kPa d (mercury) = 13600 kg/m3 d (water) = 1000 kg/m3

Q: please answer part b, other parts are answered. The hints for part b are: (1) Bernoulli's equation…

A: Given:- The discharge rate of charge Q= 0.75 L /m3 = 0.75 x 10-3 L/m3 The output pressure P1=1.5 x…

Q: The equation v,A, = V2A2 for points 1 and 2 along a streamline of a flowing fluid is called %3D the…

A: Given: The equation is A1v1=A2v2.

Q: 1. What is the ratio of the cross-sectional area at point 1 to the cross-sectional area at point 2?…

A:

Q: A manometer using oil (density 0.900 g/cm3) as a fluid is connected to an air tank. Suddenly the…

A: Density of oil = 0.900g/cm3 = 900kg/m3 Density of mercury = 13.6g/cm3 = 13600 kg/m3 Change in…

Q: The pressure at the bottom of a cylindrical container with a cross-sectional area of 49.0 cm? and…

A:

Q: What is the flow rate of water (in m3/s) hose that can fill 1.75 L bottle in 5 seconds? Group of…

A: Given, Volume of water = 1.75 L = 1.75×10-3 m3 Time = 5s  Flow rate = Volume filledTime taken

Q: With Bernoulli's principle, is there any other reason as to why the pressure of the fluid decreases…

A: Bernoulli’s principle: it states that the static pressure and the potential energy of the fluid…

Q: Water flows through a water hose at a rate of Q1 = 640 cm3/s, the diameter of the hose is d1 = 2.2…

A: