Given the depth and acceleration due to gravity, what formulas and equations are the best to use in computing for the fluid pressure at the depth?

Q: Set up an integral for fluid force against the vertical plate submerged in a fluid with weight…

A:

Q: The piston of a hydraulic automobile lift is 0.30 mm in diameter. Part A What gauge…

A: diameter (d) = 0.3 mMass of car (m) = 1200 kg

Q: A cylindrical container with a cross-sectional area of 69.2 cm? holds a fluid of density 776 kg/m3.…

A: Data Given ,  Cylindrical Cross-sectional area ( A ) =  69.2 cm2 = 69.2 × 10-4 m2  Fluid density ( ρ…

Q: The water pipe show below reduces from an 8.00cm diameter to a 6.000cm diameter. The pressure in the…

A:

Q: The density ρ of a fluid changes proportionally with depth from the surface h according to the…

A:

Q: The Venturi tube shown in the figure below may be used as a fluid flowmeter. Suppose the device is…

A: ρ = 711 kg/m3 r1 = 2 cm = 0.02 m r2 = 1 cm = 0.01 m P1 - P2 = 1380 Pa v1 = ?

Q: A fluid of a constant density flows through a reduction in a pipe. Find an equation for the change…

A: Given a fluid a constant density flows through a reduction in a pipe we have to find the an equation…

Q: A hydraulic press for compacting powdered samples has a large cylinder with a diameter of 10.0 cm…

A: Given Diameter of the large cylinder is d1=10.0 cm=0.100 m Diameter of the small cylinder is d2=2.0…

Q: A non-viscous fluid with density ρ = 0.810 g/cm3 is flowing in a horizontal direction as shown in…

A: Write a given values of this question. ρ=0.810g/cm3=0.810×10-310-6kg/m3=0.810×103…

Q: The liquid of density p in a horizontal pipe with a cross-section being a square with the side a…

A:

Q: A fluid sits in a tank whose top is open to atmosphere . This fluid has a density that increases…

A: Given: The density of the fluid is ρo+αy.

Q: Water is flowing in a pipe with a varyingcross-sectional area, and at all point the water completely…

A: Given data: The cross sectional area of the pipe, A1=0.070 m2 Magnitude of the velocity, v1=3.50 m/s…

Q: ottom of a cylindrical container with a cross-sectional area of 45.5 cm2 and holding a fluid of…

A: We  know that We have given that The pressure at the bottom of a cylindrical container is 115 kPa…

Q: What is the pressure 90 m underwater? Assume the water surface is at atmospheric pressure (1 atm…

A: Given Depth d = 90 m We have to find out pressure at depth d.

Q: Which fluid principle states that a change in pressure at any point in a confined fluid is…

A: Given  a statement that “change in pressure at any point in a confined fluid is transmitted in all…

Q: The Venturi tube shown in the figure below may be used as a fluid flowmeter. Suppose the device is…

A:

Q: Vy, Az Pz Consider the steady flow of an ideal incompressible fluid in a tube. Denote the fluid…

A:

Q: Water is flowing in a pipe of varying cross-sectional area, and at all points the water completely…

A:

Q: All of the following are properties of fluid pressure except? (A) The forces exerted by a fluid on…

A: Given Fluid exert pressure We have to choose the correct option from given options for properties…

Q: Fluid originally flows through a tube at a rate of 130 cm3/s. To illustrate the sensitivity of flow…

A:

Q: The radius of a given capillary 0.0123 dm. A liquid whose density is 0.800 g/cc rises in this…

A:

Q: Water is flowing in a pipe if varying cross-sectional area, and at all points the water completely…

A:

Q: A square metal sheet 2.9 cm on a side and of negligible thickness is attached to a balance and…

A:

Q: A solid cube 25.0 cm on each side is immersed in a fluid. The pressure at the top surface of the box…

A:

Q: A vertical rectangular plate a units long by b units wide is submerged in a fluid of weight-density…

A:

Q: Which of the following is the correct comparison of the specific gravity of the fluids indicated in…

A:

Q: 1. Which of the following is NOT a unit of pressure? A.Atm        C. Pascal B.N/m2      D.…

A: There are three different questions. According to guideline I solve only first one. Please post…

Q: Compute for the surface tension of a force of 3.65 x 10⁷ dyne acting on 7 m². Determine all in the…

A: In this question we have to compute for the surface tension of a force of 3.65 x 10⁷ dyne acting on…

Q: Is it possible for a fluid in a tube to flow in the direction from low pressure to high pressure? If…

A: Yes it is possible.

Q: Which of the following statements does not describe a property of an ideal fluid? a. The flow rate…

A: Properties of ideal fluid.

Q: Scientist found evidence that mars may once have had an ocean that is 0.500 km deep. The…

A: Consider a fluid as shown below:     The fluid pressure increases with the depth of the fluid. Point…

Q: Calculate the Reynolds numbers for the flow of water through the following situations. You may…

A: Flow Rate (Q) = 0.5 L/s = 0.0005 m3/sViscosity (η) = 0.001005 Nm2-s

Q: For what type of situations can you use the Hagen-Poiseuille equation? A) In very narrow pipes…

A: Introduction: Hagen-Poiseuille equation is an equation that gives pressure drop in an incompressible…

Q: Two hoses are connected to the same outlet using a Y-connector, as the drawing shows. The hoses A…

A:

Q: A fluid of a constant density flows through a reduction in a pipe. Find an equation for the change…

A: According to the Bernoulli's principle . Total energy of a ideal fluid is constant . and given that…

Q: Both a gage and a manometer are attached to a gas tank to measure its pressure. If the reading on…

A: Given:  P = 80 kPa d (mercury) = 13600 kg/m3 d (water) = 1000 kg/m3

Q: When the fluid is said to be incompressible, which of the following parameters of the fluid remains…

A: Answer Option ( D - density ) If the fluid is incompressible, then it density will be constant.

Q: A square metal sheet 2.8 cm on a side and of negligible thickness is attached to a balance and…

A:

Q: You are studying the fluid flow inside a pipe that is so wide and so short that its boundary layer…

A: To determine: The correct option.

Q: The pressure at the bottom of a cylindrical container with a cross-sectional area of 49.0 cm? and…

A:

Q: What is the flow rate of water (in m3/s) hose that can fill 1.75 L bottle in 5 seconds? Group of…

A: Given, Volume of water = 1.75 L = 1.75×10-3 m3 Time = 5s  Flow rate = Volume filledTime taken

Q: With Bernoulli's principle, is there any other reason as to why the pressure of the fluid decreases…

A: Bernoulli’s principle: it states that the static pressure and the potential energy of the fluid…

Q: Consider a fluid with uniform density 2300 kg/m3 within a large container. At a distance of 20…

A: Given data: The uniform density of the fluid is ρ=2300 kg/m3. The position of the surface below the…

Q: What will happen to the calculated buoyant force if the object had internal cavities? What will…

A: In this question we have to answer What will happen to the calculated buoyant force if the object…

Density of Solids

The density of a substance refers to how much matter is present in a given amount of space. It is expressed as the ratio of the mass of the substance to its volume.