You make a circuit with a 15.4 V battery, a 27.0 kQ resistor, and a 693 µF capacitor in series. If the capacitor is initially uncharged, what will bethe current in the circuit in milli amps (mA) at a time 11.1 seconds after you connect the circuit to the battery? (Enter answer as a number with 3digits right of the decimal. Do not enter unit.)Question 1 of 2 > >A Moving to another question will save this response.

Answered: Image /qna-images/answer/79dbe18e-930d-440e-9903-3eee011aa9d5.jpg

Answered: You make a circuit with a 15.4 V…

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter29: Direct Current (dc) Circuits

Section29.5: Resistors In Parallel

Problem 29.7CE

See similar textbooks

Similar questions

A 160F capacitor charged to 450 V is dischargedthrough a 31.2k resistor, (a) Find the time constant.(b)Calculate the temperature increase of the resistor, given that its mass is 2.50 g and its specific heat is 1.67kJ/kg °C,noting that most of the thermal energy is retained in the short time of the discharge, (c) Calculate the new resistance, assuming it is pure carbon. (d) Does this change in resistance seem significant?
Ralph has three resistors, R1, R2, and R3, connected in series. When connected to an ideal emf source E1, current I1 flows through the resistors. a. If the resistors are instead connected to a second source with E2=2E1, what is the new current through the resistors in terms of the first current? b. Show that, if each resistance is doubled and the resistors are connected in series to the second emf source, the current through the resistors is equal to I1.
A 12-volt battery of internal resistance r of 0.05 ohm is to be recharged by a 50-volt dcsource at the rate of 8 amperes.a. What resistance R is to be connected in series with the circuit? ANSWER:_________b. What is the terminal voltage of the battery? ANSWER:_________c. How much energy in joules is dissipated in the resistor in one hour ?ANSWER:_________
What voltage will produce 0.2 AA of current through a 4800-ΩΩ resistor? Express your answer to two significant figures and include the appropriate units. V=
In the circuit below, the capacitor starts out uncharged. The resistance is R = 118 Ω, capacitance is C = 0.0647 F, and the battery emf is 16.7 V. What is the charge (Q) on the capacitor at a time of t = 3.72 seconds after the switch is closed?
1. 9. In the circuit shown in the figure above, a power supplier of 50 V is connectedacross a resistance network. If R1 = 20 Ω, R2 = 10 Ω, R3 = 10 Ω, and R4 = 40 Ω. Whatis the equivalent resistor of the circuit? 2. 10. What is the current flowing through the R4 resistor in the circuit shown in Problem 9? 3. 11. What is the voltage across the R1 resistor in the circuit shown in Problem 9? 3.
In the circuit shown in figure 1, all the resistors are rated a maximum power of 1.00 W. What is the maximum emf epsilon that the battery can have without burning up any of the resistors?
In the circuit shown, two identical 1.5 V batteries (with the positive or high potential ends colored orange) are connected to three identical bulbs, A, B, and C. The current in bulb A is I0.A. What is the current in bulb B? Express your answer as a number multiplied by I0, and enter that number here: _____ × I0B. What is the current in bulb C? Express your answer as a number multiplied by I0, and enter that number here: _____× I0Suppose that each of the bulbs has a resistance of 50 Ω.C. Calculate I0, the current in bulb A.I0 = _______ amps
How much current flows thru a 6 Ω resistor in 4 minutes if it is connected to a 9V battery ?
A constant current transfers 10*10^14 electrons onto one plate of a capacitor in 3 minutes [min]. (a) What is the current, in units of amperes [A]? Express the answer using an appropriate SI prefix such that there are only 1, 2, or 3 digits shown to the left of the decimal. (b) If the capacitor has a capacitance of microfarads [F], what is the voltage in units of volts [V] across the capacitor?
Answer the following 1. A voltage of 120V generates an IR drop across two resistors connected in series. If the voltage drop across R1 is 30V, what is the voltage drop across R2, in Volts? a) 80 b) 40 c) 100 d) 90 2. Three resistors R1, R2 and R3 of 20, 40 and 60 ohms are connected in parallel through the 120 V power line. What is the total current in the power line? a) 10A b) 12A c) 11A d) 15A 3. Resistors in a circuit are generally used to: a) increase the flow of the current b) decrease the flow of current c) avoid overvoltage d) decrease the power in the circuit
In the circuit below, if the battery in the circuit below is 5.9V, resistor R1=76.03ΩΩ, and resistor R2=77.61ΩΩ, what is the magnitude of the current that passes through R1? Give your answer in units of milli-Amps (mA).

SEE MORE QUESTIONS

Recommended textbooks for you

Physics for Scientists and Engineers: Foundations…

Physics

ISBN:

9781133939146

Author:

Katz, Debora M.

Publisher:

Cengage Learning

University Physics Volume 2

Physics

ISBN:

9781938168161

Author:

OpenStax

Publisher:

OpenStax

Physics for Scientists and Engineers: Foundations…

Physics

ISBN:

9781133939146

Author:

Katz, Debora M.

Publisher:

Cengage Learning

University Physics Volume 2

Physics

ISBN:

9781938168161

Author:

OpenStax

Publisher:

OpenStax

SEE MORE TEXTBOOKS