Please show complete written solution and answers must be expressed in engineering notation with 2 decimal places. You need a 45 Q resistor, but the stockroom has only 20 Q and 50 Q resistors. How can thedesired resistance be achieved under these circumstances? What can you do if you need a 35 0resistor?

Answered: Image /qna-images/answer/fc8b78d1-6ca4-4765-8693-84f8f375550e.jpg

Answered: You need a 45 Q resistor, but the…

You need a 45 Q resistor, but the stockroom has only 20 0 and 50 Q resistors. How can the desired resistance be achieved under these circumstances? What can you do if you need a 35 0 resistor?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 46P: An electronic device designed to operate at any temperature in the range from 10.0C to 55.0C...

See similar textbooks

Related questions

Q: x - coordinate: x = -5.00sinwt, where w is constant, x is meters, and t is seconds y - coordinate: y…

Q: 12. Which position or positions? B Has maximum velocity? B. SMaximum + force? Acceleration = 0?…

Q: maximum wavelength of incident light that releases photoelectrons from the surface of a platinum…

Q: The captain of a ship views the top of a lighthouse at an angle of 60" with the horizontal at an…

Q: A mass of 0.340kg oscillates up and down on a spring with a spring constant 45.0 N/m. What is the…

A: Given Mass = 0.340 kg Spring constant = 45 N/m To find out Angular Frequency of the motion

Q: What is the ideal banking angle of a road having a ferrari car running through it with an angular…

Q: A magnetic field of strength 0.29 T is directed perpendicular to a plane circular loop of wire of…

Q: A uniform magnetic field is perpendicular to the plane of a circular loop of diameter 10 cm formed…

Q: A sample of ideal gas is allowed to expand isobarically from 1.74m to 3.26m³. Its initial…

Q: Problem 2: Find the current through and the potential difference across each resistor in the given…

Q: Caleb left home and traveled toward the city A at an average speed of 61.1 km/h. Some time later,…

Q: A rigid steel plate is supported by three posts of high-strength concrete each having an effective…

A: Given Cross sectional area = 40000 mm2 Length = 2 m s = 1mm Stress in the concrete = 20 MPa E of the…

Q: Find the compoent of gravity down the slope in the diagram. 20 kg 40

A: Given Data: The mass of the slope is: m=20 kg The angle of slope is: θ=40°

Q: If an electron has an uncertainty in its velocity of 4.10 m/s, what is the uncertainty (in meters)…

Q: An object attached to a horizontal spring and somewhere along its motion has a kinetic and potential…

Q: The slope of the tangent line at a point in a position versus time graph is equivalent to the O…

A: We are taking slope in a position vs time graph.

Q: In the figure below, the coefficient of sliding friction for all contact surfaces is 0.20. When the…

Q: Compare the forces the water exerts on the bottoms of the tanks. Is FAFA larger than, smaller than,…

A: Pressure is defined as force/area. If an enclosed area has higher pressure than the area around it,…

Q: A ball is thrown vertically up with a velocity of 34.3m/s at the edge of a 57.2-m cliff. Calculate…

Q: Upon freezing, water becomes more orderly and its entropy decreases. Explain why this process does…

Q: Find the x- and y-coordinates of the center of gravity of a 4.00 ft by 8.00 ft uniform sheet of…

A: The value of x is 3.63 ft and y is 1.77 ft.

Q: Twenty amps of current flows through a square loop where each side is 20 cm in length. At each…

Q: Predict how the efficiency of a gasoline engine will change when the temperature outside decreases…

A: The efficiency of a Carnot cycle is determined by η = (Th - Tc)/Th where, η = efficiency Tc =…

Q: A particle undergoes uniformly accelerated motion. Its velocity at an nstant is 10. m/s. After 3.0…

Q: What is the frequency (in Hz) at which he bounces, given that his mass plus the mass of his…

Q: RANGE Use this value of initial velocity: 18 m/s What is the slope of the trendline equation of…

Q: For the RL circuit shown in the figure below, let the inductance be 2.75 H, the resistance 7.15 N,…

Q: The graph below represents the relationship between the current in a metallic conductor and the…

A: Given data: From the graph At V = 4.0 V, the current (I) = 2.0 A Required: Resistance (R)

Q: Which of the following is a future consequence of the use of wind energy on the environment? a) It…

Q: 2. What are the conditions for an RLC-circuit to be (I) overdamped, (II) crit- icalıy damped, (III)…

Q: A 6kg ball moving east at a speed of 5m/s strikes a 2kg ball at rest. Calculate the final velocities…

Q: A 55.0 kg boy runs at a speed of 16.0m/s and jumps onto a cart that is initially at rest. The boy…

A: Given that The mass of the boy is (m) = 55.0kg Speed of the boy is (v1…

Q: 3. Two identical resistors connected in parallel have an equivalent resistance of 40. ohms. What is…

Q: 5. The diagram below represents an electric circuit consisting of a 12-volt battery, a 3.0-ohm…

A: Given data: Two resistors are connected in series combination R1 = 3.0 Ω and R2 = ? Battery…

Q: Water flows at 1 m/s from a hot water heater, through a 45o kPa pressure regulator. The pressure in…

A: According to Bernoulli's theorem P + hρg + (1/2) ρv2 = constant we can apply Bernaulli's theorem…

Q: lack Sparrow sees a Royal Navy ship around 500 meters away and wants t sunk immediately. You, as his…

A: Given : Distance from the ship (S) = 500 m . Speed of cannon ball (V) = 100 m/s.

Q: What is the pressure at the bottom of a 4.30m deep pool filled with water if the atmospheric…

A: Given data: Atmospheric pressure (Patm) = 1.013×105 Pa Height (h) = 4.30 m Required: The absolute…

Q: 7. A small metal ball of mass 3 grams is charged with-10 uC. A constant uniform electric field is…

A: Given Datam=3 gram=0.003 kgq=-10μC=-1×10-5Cg=9.81 takenTo FindE=?

Q: 1. Which combination of resistors has the smallest equivalent resistance?

A: Introduction :- Here in the given four combinations, we have to find the combination for which…

Q: A particle has a rest mass of 6.35 × 10-27 kg and a momentum of 4.71 x 10-18 kg-m/s. Determine the…

Q: Part A The emf phasor in (Figure 1) is shown at t = 1.7 ms. What is the angular frequency w? Assume…

A: In this question we have to find the angular frequency and the peak value of the emf. Please give…

Q: A dragster starts from rest and travels O.95 mi in 9.14s with constant acceleration. What is its…

Q: A meter stick (center of mass = 50cm mark, mass = 150g) has a hanging mass attached at the 20cm…

Q: Measuring distance with high precision is a critical goal in engineering. Numerous devices exist to…

A: Given Beam one wave length = 1064 nm Beam two wave length = 1113 nm Device should move 5.155 cm…

Q: A speeder traveling at 2.86 m/s passes a motorcycle policeman at rest at the side of the road. The…

A: Given : Velocity (V) = 2.86 m/s Acceleration (a) = 1.23 m/s2

Q: Vector A has magnitude 11.89 m and vector B has magnitude 13.89 m. The magnitude of the cross…

A: Given Magnitude of the two vectors are given as A→=11.89 m and B→=13.89 m Magnitude of the cross…

Q: 12-turn coil 10 cm in diameter has its axis parallel to a magnetic field of 0.5 T which is produced…

Q: Which of the following describes safeguards used in nuclear power plants to protect the environment?…

A: To keep the safety measurements in a nuclear power plant is most essential thing .

Q: Vector A represents the displacement of a car that has travelled 46.23 m, 73.71 degrees west of…

Q: component of vector A in the figure above is 3 cm and the y component of A is 4 cm

A: Given X component of vector A is Ax= 3 cm Y component of vector A is Ay= 4 cm

Concept explainers

Ohm's law

Ohm’s law is a prominent concept in physics and electronics. It gives the relation between the current and the voltage. It is used to analyze and construct electrical circuits. Ohm's law states that the voltage across a conductor is directly proportional to the current flowing through it.

Path of Least Resistance

In a series of alternate pathways, the direction of least resistance is the actual or metaphorical route that offers the least resistance to forwarding motion by a given individual or body.

Question

100%

Please show complete written solution and answers must be expressed in engineering notation with 2 decimal places.

You need a 45 Q resistor, but the stockroom has only 20 Q and 50 Q resistors. How can the
desired resistance be achieved under these circumstances? What can you do if you need a 35 0
resistor?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Consider a power plant is located 60 km away from a residential area uses Q-gauge (A=42.40mm2) wire ofcopper to transmit power at a current of I = 100.00 A.How much more power is dissipated in the copper wires than it would be in superconducting wires?
Resistors are commonly rated at 18W,14W,12W ,1 W and 2 W for use in electrical circuits. If a current of1 = 2.00 A is accidentally passed through a R=1.00 resistor rated at 1 W, what would be the most probable outcome? Is there anything that can be done to prevent such an accident?
Check Your Understanding Copper wires use routinely used for extension cords and house wiring for several reasons. Copper has the highest electrical conductivity rating, and therefore the lowest resistivity rating, of all nonprecious metals. Also important is the tensile strength, where the tensile strength is a measure of the force required to pull an object to the point where it breaks. The tensile strength of a material is the maximumamount of tensile stress it can take before breaking. Copper has a high tensile strength, 2108Nm2 A thirdimportant characteristic is ductility. Ductility is a measure of a material’s ability to be drawn into wires and a measure of the flexibility of the material, and copper has a high ductility. Summarizing, for a conductor to be a suitable candidate for making wire, there are at least three important characteristics: low resistivity, high tensile strength, and high ductility. What other materials are used for wiring and what are the advantages and disadvantages?
How does the resistance for copper and for silicon change with temperature? Why are the behaviors of these two materials different?
A 0.50-W, 220- resistor carries the maximumcurrent possible without damaging the resistor. If the current were reduced to half the value, what would be the power consumed?
An electronic device designed to operate at any temperature in the range from 10.0C to 55.0C contains pure carbon resistors. By what factor does their resistance increase over this range?
How can we analyze complex resistors?
Two 3.8microF capacitors, two 2.2kohms resistors and a 16.0V source are connected in series. Starting from the uncharged state, how long does it take for the current to drop from its initial value to 1.50 mA
Two 6.0 µF capacitors, two 2.2 kΩ resistors, and a 12.5 V source are connected in series. Starting from the uncharged state, how long does it take for the current to drop from its initial value to 1.30 mA?
Find the equivalent resistance of the network in the circuit and the current in eachresistor. The source of emf has negligible internal resistance. R1= 4 Ω, R2= 6 Ω, and R3= 3 Ω. Round off in nearest hundredths.1. RT = ________2. IT = ________ 3. I1 = ________ 4. I2 = ________ 5. I3 = ________ 6. V1 = ________7. V2 = ________ 8. V3 = ________
How many different resistance valuescan be created by combining three unequal resistors? (Don’t count possibilities in which not allthe resistors are used, i.e., ones in which there iszero current in one or more of them.)
What resistance values can be createdby combining a 1 kΩ resistor and a 10 kΩ resistor?