You wish to invent a sparker for lightning gas burners. A 1.5-A current from a battery runs through a primary coil. When the switch in this circuit is opened, the current decreases to zero in 0.60 ms, thus inducing a voltage in a secondary coil that causes a spark across a 0.50 mm gap. What must the mutual inductance be between the coils if the dielectric strength of the fumes between the gap is 2.4 x10 ^ V/m?

Q: 1. A vector à has a magnitude of 54.0 m and points in a direction 26.0° above the positive x axis. A…

A:

Q: What is the direction of the magnetic field B at a point above the wire carrying a current as shown?…

A: Given: The direction of the current is in the left direction. The position of the point is above the…

Q: The cheetah is the world’s fastest land mammal and can accelerate from rest to 26.3 m/s in 28.1 s.…

A:

Q: In the diagram below, the vertical heights holl and hwater are 3.00 cm and 3.00 cm. The diameter of…

A:

Q: A thin metal disk with mass 2.00 × 10−3 ?? and radius 2.20 cm is attached at its center to a long…

A:

Q: A circular coil of 0.30-m diameter with 25 loops rests between the poles of a large electromagnet.…

A:

Q: Determine length CE for the similar triangles shown in Figure 1. E 25 m D A 10 m FIGURE 1 B 16 m

A: For similar triangles, corresponding sides are in the same ratio.

Q: states that "the pressure of a fluid (liquid or gas) decreases as the speed of the fluid increases."…

A: Given 1st question: Pressure of a fluid decreases as the speed of fluid increases  We have to choose…

Q: For items 29 - 31 Carlo used a ramp in training for the skateboard competition. The ramp is 4 feet…

A:

Q: A car drives around a circular track of diameter 156 m at a constant speed of 33.0 m/s. During the…

A:

Q: FM radio station KRTH in Los Angeles broadcasts on an assigned frequency of 101 MHz with a power of…

A:

Q: An electric eel develops a potential difference of 500 V, driving a current of 0.80 A for a 1.0 ms…

A: Potential difference, V = 500 V Current, I = 0.80 A Time, t = 1 ms = 10-3 s Power, P = ?  Energy, E…

Q: km As you do your regular morning walk at1.4 with an average room temperature, you can etect a…

A:

Q: A constant force of F=(2i+3j – k) moves an object from position  a=(i – j + 4k)  to  b=(2i+2j -3k)…

A:

Q: -60° B A 60°- C W₁ W₂

A:

Q: Two transverse sinusoidal waves combining in a medium are described Y₁ = 5.00 sin z(x + 0.900t) Y₂ =…

A: Standing waves A sinusoidal transverse wave with angular frequency  Given  Y1=5.00 sin…

Q: Consider a mass spectrometer used to separate the two isotopes hydrogen and deuterium. The isotope…

A:

Q: Consider the two vectors, A= 17x+11.5y, B= 4.5x-3.5y a. What is the magnitude of the vector 3A+B?…

A:

Q: Find the value of work done Force=0.011 N Displacement 0.2 m

A: Given data : Force=F Displacement=d   To find : Work done

Q: (B) Cylindrical Water cans (diameter 6.5cm and length 15cm) are to be cooled from initial…

A: Given Diameter, D=6.5cm Length, L=15cm Initial Temperature, Ti=200.C Ambient Temperature, 10 c…

Q: Questions 1. What is the conversion factor between kg/m' and g/cm"? Express your experimental values…

A: Given a) convert kgm3 into gcm3b)mass density of mercury=13,6gcm3diameter(containig mercury)…

Q: Time = 5.25 fone = 32 N "Cubulete the Impulse

A:

Q: 1. (I) An ideal gas expands isothermally, performing 4.30 x 10³ J of work in the process. Calculate…

A: Given  Work  done on expanding ideal gas isothermally W = 4.30 × 103 J a) To find The change in…

Q: below? 10 mH mmmm (a) 7.4 × 10-⁹ rad/s (b) 2.0 × 10-4 rad/s (c) 4.4 × 10³ rad/s (d) 5.0 x 10³ rad/s…

A:

Q: The current through a 2.0 μF capacitor when connected to a 20V generator is 0.16 A. Determine the…

A:

Q: A circular steel wire 2.00 m long must stretch no more than 0.25 cm when a tensile force of 400 N is…

A:

Q: Value of source luminosity is 600 Cd. What intensity of illumination will be on working table at…

A: Write the expression of intensity of illumination at point B. I=LIr2cosθ  lx

Q: Analysis of an accident a was traveling at a velocity of 73.5 mph (32, 0m / s) along the positive at…

A: Given: The initial velocity of the car is 32 m/s. The distance traveled by car is 114 m. The final…

Q: using Gauss’s Law please  find the electric field due to an infinite line of charge with constant…

A:

Q: A student is able to isolate a single charged oil drop while performing a Millikan oil drop…

A:

Q: Scientists recognize that light sometimes behaves as a particle. What other term describes its…

A: D. transverse wave Because Light and other types of electromagnetic radiation are transverse waves.

Q: A 0.544-kg ball, initially moving with a speed of 2.54 m/s, bounces off a wall and then moves with a…

A:

Q: The voltage across the terminals of an AC Generator varies with time according to the equation v=30…

A: Given: Voltage across the terminals of an AC generator varies with time. According to the equation…

Q: The car of a roller coaster starts from rest at a height of 10 m above the ground. If there is no…

A: Given  h = 10 m  Let mass of car is ' m ' . When car will reach at the ground all potential energy…

Q: What current is needed to generate the magnetic field strength of 5.0 x 10-5 T at a point 2.0 cm…

A:

Q: A car travels 340 km in 8 hours. What is the average speed of the car in km/h?

A: Introduction :  In this question we are provided with value of distance and time.with these data we…

Q: A 0.018-kg bullet is fired into a stationary block of wood of mass of 5.1 kg. The relative speed of…

A:

Q: Two point charges +0.08 µC and +0.32 µC are 20 cm apart in air.  (a) What is the potential energy of…

A:

Q: What is the work done (Nm) to a system with a mass of 20kg by lifting it using 2000N of force and…

A:

Q: A ball is thrown vertically upward from a platform that is 60 feet high with an initial velocity of…

A:

Q: A nylon rope used by mountaineers elongates 1.10 m under the weight of a 65.0-kg climber. If the…

A:

Q: A magnet's North pole attracts an iron nail. What will happen if the magnet's South pole is brought…

A: If an iron nail is attracted towards a north pole of the magnet and sticks to it then the magnetic…

Q: The sound waves travel with speed of 450 m/s. If is wavelength is 6 m. Calculate the frequency of…

A:

Q: Find time Speed=32.5 m/s Distance 120 m

A: Given data : Speed=S Distance=d   Required : Time

Q: A 0.030-kg bullet is fired vertically at 600 m/s into a 0.15-kg baseball that is initially at rest.…

A:

Q: A 2.25 kg stone, moves from a height of 220 cm with a velocity of 1.65 m/s, what is its mechanical…

A:

Q: A physics book slides off a horizontal tabletoo witha speed of 1.60 m/s. It strikes the floor in…

A:

Q: A horizontal force of 220 N is applied to move a 46 kg television set across a 12 m level surface.…

A: Introduction :  In this question we are provided with value of force applied and displacement of…

Q: The string shown in the figure is driven at a frequency of 5.00 Hz. The amplitude of the motion is A…

A: We need to calculate the angular frequency, wave number, equation of the wave and the maximum…

Q: 5 Half Life The half life of a substance is the time required for half the nuclei to undergo…

A: Given: The half-life of Tritium: T1/2 = 12.33 years.   To find the percentage of tritium nuclei in…

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.