Please help, thank you!!! 3. Your laboratory uses an analytical instrument for lead (Pb) thatrequires calibration with four standard solutions of lead to bedissolved in 5% HNO3. To prepare one standard solution of 50.0µg/ml, you mixed 5.0 ml of a sample with 95.0 mL of diluent(solvent). What was the concentration of manufacturer's solutionin mg/dL before dilution?

Solution - According to the question - Given - M2 = 50 µg/ml V2 = 95 ml + 5 ml = 100 ml V1 = 5 ml…

Your laboratory uses an analytical instrument for lead (Pb) that requires calibration with four standard solutions of lead to be dissolved in 5% HNO,. To prepare one standard solution of 50.0 ug/ml, you mixed 5.0 ml of a sample with 95.0 mL of diluent (solvent). What was the concentration of manufacturer's solution in mg/dl before dilution?

Your laboratory uses an analytical instrument for lead (Pb) that requires calibration with four standard solutions of lead to be dissolved in 5% HNO,. To prepare one standard solution of 50.0 ug/ml, you mixed 5.0 ml of a sample with 95.0 mL of diluent (solvent). What was the concentration of manufacturer's solution in mg/dl before dilution?

Chemistry for Engineering Students

4th Edition

ISBN:9781337398909

Author:Lawrence S. Brown, Tom Holme

Publisher:Lawrence S. Brown, Tom Holme

Chapter3: Molecules, Moles, And Chemical Equations

Section: Chapter Questions

Problem 3.66PAE

See similar textbooks

Similar questions

What mass of HCl is contained in 45.0 mL of an aqueous HCl solution that has a density of 1.19 g cm-3 and contains 37.21% HCl by mass?
D5W is a solution used as an intravenous fluid. It is a 5.0% by mass solution of dextrose (C6H12O6) in water. If the density of D5W is 1.029 g/mL, calculate the molarity of dextrose in the solution.
On Easter Sunday, April 3, 1983, nitric acid spilled from a tank car near downtown Denver, Colorado. The spill was neutralized with sodium carbonate: 2HNO3(aq)+Na2CO3(aq)2NaNO3(aq)+H2O(l)+CO2(g) a. Calculate H for this reaction. Approximately 2.0 104 gal nitric acid was spilled. Assume that the acid was an aqueous solution containing 70.0% HNO3 by mass with a density of 1.42 glcm3. What mass of sodium carbonate was required for complete neutralization of the spill, and what quantity of heat was evolved? (Hf for NaNO3(aq) = 467 kJ/mol) b. According to The Denver Post for April 4, 1983, authorities feared that dangerous air pollution might occur during the neutralization. Considering the magnitude of H, what was their major concern?
Molarity is a conversion factor relating moles of solute in solution to the volume of the solution. How does one use molarity as a conversion factor to convert from moles of solute to volume of solution, and from volume of solution to moles of solute present?
In most of its ionic compounds, cobalt is either Co(II) or Co(III). One such compound, containing chloride ion and waters of hydration, was analyzed, and the following results were obtained. A 0.256-g sample of the compound was dissolved in water, and excess silver nitrate was added. The silver chloride was filtered, dried, and weighed, and it bad a mass of 0.308 g. A second sample of 0.416 g of the compound was dissolved in water, and an excess of sodium hydroxide was added. The hydroxide salt was filtered and heated in a flame, forming cobalt(III) oxide. The mass of cobalt(III) oxide formed was 0.145 g. a. What is the percent composition, by mass, of the compound? b. Assuming the compound contains one cobalt ion per formula unit, what is the formula? c. Write balanced equations for the three reactions described.