(Z): 2X + 3Y :X + 2Y ≤ 300 5X + Y ≥ 150 4Y = 120 X. Y> 0

Q: In a C.I. engine working on the dual combustion cycle the compression ratio is 12.5:1. Air at…

A:

Q: Determine the velocity of block A if end B of the rope is pulled down with a speed of 9.0 m/s.…

A: Given that: Velocity at B is 9 m/s. It is required to determine the velocity of the block A.

Q: Find the natural frequency of the system shown in Fig. 2.55 with and without the springs k₁ and k₂…

A: Solution: Given Data:   To Find: (a) Find the natural frequency when both the springs are present.…

Q: A vehicle collides with an immoveable concrete embankment. Estimate the number of 'gs' the occupant…

A:

Q: The tailgate of a car is supported by the hydraulic lift BC. If the lift exerts a 128-lb force…

A:

Q: a su spectral nemispherical emissivity figure below m). 's law is = C, here C = 2898 μmk and…

A: Given:Wien's law,λmT=CC=2898 μmKFind,Temperature at which hemispherical emissivity will be highest?

Q: crude oil having kinematic viscosity of 0.4×10-4 m2 per second is flowing through a pipe having…

A: Given:Kinematic viscosity, ϑ=0.4×10-4 m2/sDiameter of pipe, d=0.3 mDischarge=300 liter/s=0.3…

Q: draw the shear and moment diagram A 3' 10 k 5' 10 k 8' B

A:

Q: Calculate the largest weight W that can be supported by two wires. The stress in either wire is not…

A: Givenσ=7.6 MPaAAB=150 mm2AAC=250 mm2

Q: 1.3. 10. A polytropic process of air from 150 psia, 300°F, and 1 ft occurs to p2= 20 psia in…

A: GivenPolytropic processP1=150 psia=150×144=21600 psfT1=300oF=(300°F − 32) × 5/9 + 273.15 =…

Q: ▼ Part A Determine the magnitude of the resultant force acting at A.(Figure 1) Express your answer…

A:

Q: A hollow circular tube with a 2.3-cm I.D. and 2.5-cm O.D. is rigidly supported at its ends. A 2.5…

A:

Q: Parallel plates form a solar collector that covers a roof, as shown in the figure. The plates are…

A:

Q: A 1D two-node bar element as shown below is considered. The displacement of node 1 is q₁=0.002 mm,…

A: q1 = 0.002 mm qp = 0.013 mm let take, X1 = 10 mm Xp = 15 mm X2 = 35 mm   To find out:- Displacement…

Q: Explain the relationships between system constants for a perfect gas

A: Boyle’s, Charles’s, and Avogadro’s laws give the general derivation formula of the ideal or perfect…

Q: 18 A weightless plate is moving upward in a space as shown in Figure P1.18. The plate has a constant…

A:

Q: 2. Assume that axial deformation of Member EF is caused mainly by its reaction to external forces on…

A:

Q: 3. Determine: (a) The equivalent length in meters of pipe that would have the same loss as a fully…

A: As per the rules, only the first three sub-parts will be answered. For the commercial steel pipe,…

Q: A block-and-tackle pulley hoist is suspended in a warehouse by ropes of lengths 2 m and 3 m. The…

A:

Q: 4. Three pounds of a perfect gas with R = 38 ft.lby/lb.R and k = 1.667 have 300 Btu of heat added…

A:

Q: Q2: A: For the tanks-system shown below, write the equations (only) of the flow in each tank. Assume…

A: Given: For the tank1: Incoming flow rate=5 gal/min Outgoing flow rate=2+3=5 gal/min Concentration of…

Q: 5. A large stationary Brayton cycle gas-turbine power plant delivers a power output of 100 MW to an…

A:

Q: Q4/Thin rod positioned between two walls that are held at constant temperatures. Heat flows through…

A:

Q: helical compression spring subjected to compressive load. The maximum shear stress induced in the…

A: Given:τmax=24 MPaFind,The maximum shear stress induced in the cross-section of the wire?

Q: The compound bar is composed of brass and copper. It supports the axial loads shown below. Determine…

A:

Q: The motor at C' pulls in the cable with an acceleration ac = (31²) m/s², where t is in seconds. The…

A:

Q: As shown in the figure, Refrigerant 22 enters the compressor of an air conditioning unit operating…

A:

Q: four pounds of air gain 0.491 Btu/degree Rankine of entropy during a nonflow isothermal process. if…

A: Given that: Mass of air is 4 lbm. Air gains 0.491 Btu/R entropy during a non flow isothermal…

Q: :) Determine the equivalent mass of the system shown in Figure Q.A3c. X m 2r Figure Q.A3c. r = 10 cm…

A: Given mass and moment of inertia.  Required: Equivalent mass.

Q: The actual sales of car manufacturer in January is 120 units but the car manufacturer underestimated…

A: Given data: ▪︎The actual sales in the month of January: DJan. = 120 units ▪︎The car manufacturer…

Q: A two-dimensional fluid element rotates like a rigid body. At a point within the element, the…

A: Given:2-D fluid element,Pressure=1 unit,Find,radius of the mohr's circle?

Q: Three forces act on the gusset plate as shown in (Figure 1). Figure F₁ = 650 N 0- 100- 00 45° F₂750…

A:

Q: Two hard rubber blocks are used in an anti-vibration mount to support a small machine as -140 lb…

A: According to the given data P=140lb δ=0.23 in a=0.50im b=0.95in and  c=2.70in We need to find…

Q: Consider the steady-state model of the universe. In this model, the universe is made up of matter…

A: The rate of creation of matter per unit volume can be calculated using the equation: MV=ρ(1+3Ht)…

Q: A furnace is required to sinter powder-metal parts. It operates continuously at 650 °C while the…

A: Given That: Temperature = 650oC maximum thickness x = 0.2 m The material index, also known as the…

Q: Rods are mass produced by a machine. The specification required the length of each rod to be between…

A: To find: (a) The percentage of rods produced which would be rejected if the mean length of the rods…

Q: The aircraft A with radar detection equipment is flying horizontally at an altitude of 12.2 km and…

A:

Q: ith the aid of diagrams the operational sequence of four stroke spark ignition and four  stroke…

A: Motorbikes and cars both employ the Otto Cycle, often known as the Spark-Ignition Cycle. Compression…

Q: Qs A wall separated hot water from cold air in order to increase the heat transfer rate a number of…

A: Heat transfer coefficient on water = 255 w/mk hair =57 w/mk K= 3 w/mk A= (3×0.6) m2 length of…

Q: A tank contains 100 gallons of brine. Three gallons of brine, each containing 2 pounds of dissolved…

A: Given flow rate at exit and inlet.  Required: Initial concentration.

Q: A 5-mm thick hollow steel has an allowable stress limited to 200 MPa. Determine the inside and…

A: According to the question data F=100kN Do-Di =2t=10mm Do=Di+10 ----------(1) σallow=200MPa We need…

Q: 8-hour time-weighted average (TWA) noise exposure for 80.5 dba

A: Given data: Noise Exposure = 80.5dba Time of exposure = 8 hrs To find: TWA

Q: Referring to the reversible heat pump cycle shown in the figure, p₁ = 14.7 lby/in². pa=34.7 lb/in².…

A:

Q: n a power plant operating with water and steam, the following measurements and observations were…

A:

Q: 0.4 m = 0.5 m A B C P 20-mm diameter 60-mm diameter Fig. P2.19 and P2.20 2.20 The rod ABC is made of…

A: Given Data- A stepped rod subjected to forces given We have to find deflection of point A and B…

Q: At the instant shown, the bar AB has a velocity of 4.8 rad/s clockwise. If a = 0.22 m, b = 0.33 m,0…

A:

Q: CALCULATE ROTARY MECHANICAL POWEA Calculate the power in Hp at a gear shaft given the following…

A:

Q: The aircraft A with radar detection equipment is flying horizontally at an altitude of 12.2 km and…

A:

Q: 5-4 Composite A-36 steel bar shown made from two segments AB and BD. Area AAB = 600 mm2 and ABD =…

A:

Q: rom the turbine the heat loss per kg of steam flow rate is 5 kW. Find the power developed in kW by…

A: Given:Heat loss, Q=-5 kWFor inlet steam, h1=3250 kJ/kgvelocity, v1=180 m/sFor exit steam,h2=2360…

Moment of Inertia

Inertia can be termed as a resistance offered by a body to change its state. A rigid body initially at rest will apply resistance when acted by an external force that tends to change its state of rest or velocity, or a body initially at motion will provide resistance in changing its state of velocity or motion for coming to a state of rest. In other words, Newton's first law of motion describes the law of inertia of a rigid body.