An R-L series circuit contains a resistor and an inductor. The resistor has a value of 6.5 V. The circuit is connected to 120 V and has a current flow of 12 A. What is the inductive reactance of this circuit?

An R-L series circuit contains a resistor and an inductor. The resistor has a value of 6.5 V. The circuit is connected to 120 V and has a current flow of 12 A. What is the inductive reactance of this circuit?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 16PP: An R-L series circuit contains two resistors and two inductors. The resistors are 86 k and 68 k ....

See similar textbooks

Related questions

Q: 4. This circuit is shown in the figure, Please find out the output voltage under the following…

Q: Refer the following figure. The resistance, looking in at the base, is approximately equal to--- +20…

Q: In Series -Parallel find the resistance, voltage and Current Resistance Voltage Current C

Q: For the circuit in Figure 4 the switch is in the closed position for several minutes: (a) Find the…

A: 1. Assume the switch is closed for a long time, hence the inductor will be fully charged and behave…

Q: Initially a 10 V battery is in series with a 100 ohm resistor and a 2 mH inductor. After a long…

Q: Vcc = 20 V %3D RL = Rc = %3D RB I dc 82 C; Co V, Figure 6-5

Q: A certain circuit is in steady state. It is composed of a resistor R = 40kN in series with an…

A: Given data, R=40KΩL=1 mHV=24V Initially the circuit is in steady state so, the inductor assumed to…

Q: Which option is correct for the state equation of the circuit in the figure

Q: Find the current through the resistor at t=0+, and at t=1.25s. The switch is closec at t=0 *

Q: Describe in detail the voltages Vi and Vo over time for the following circuit

A: Given the circuit, as shown below: We need to find Vo.

Q: Find the current through the resistor in the circuitshown in Figure

A: Given, Angular frequency

Q: Find the equivalent circuit of the circuitshown in the figure below, to the left of the terminals…

Q: Compute for the following values and show compelete solutions. Find the following: A.) isc B.) iN…

Q: 23. In a series RL circuit; L = 4 H, R = 100 ohms and E = 200 V. Find the values of current as a…

A: In a series RL circuit; L = 4 H, R = 100 ohms and E = 200 V. Find the values of current as a…

Q: Q8. For the circuit in Figure Q8, use KCL to find the branch currents I¡ to I4. 2A 7A 3A ||4A Figure…

A: Junction law or KCL Can be used at junction Add all incoming currents Add all outgoing currents…

Q: A resistor and capacitor are connected in series to an a.c. supply of 50 V and 50 Hz. The current is…

A: Impedance is represented as Z=R+jX where R represent resistance , and X represent reactance . The…

Q: Q4. The series RL circuit of Figure Q4 is subject to a unit step voltage input of height 5 volts at…

A: Given circuit is step input given to series R-L circuit. The current through the inductor when step…

Q: A load is composed of a 4 ohm resistance connected in series with a 3 ohm inductive resistance. The…

Q: 10.0 V, R1 1.00 Ω. Τhe In the figureε - 4.00 Ω, and R 1.00 Ω. The inductor is ideal. If the switch…

A: Inductor is passive element that store energy in magnetic field. Inductance is denoted by L and its…

Q: An inductive load connected to a 120V, 60Hz source produces a current of 8A. The current produced…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: A circuit consists of a pure resistance and a coil in series. The power dissipated in the resistance…

A: Given, Pure Resistance is in series with coil. They have given Some values. We have to find the…

Q: A resistor of 12ohms and an inductance of 0.025H are connected in series across a 50Hz supply. What…

Q: R2 50 Ω -ww- R13 + R3 C2 C1 V1 ?For the circuit shown above, what is the voltage across the…

Q: Q3] Design a circuit to produce an average voltage of 27V across a 102 load resistor from a 70V ms…

Q: A DC source has an open circuit voltage of 30 V and an internal resistance of 1.5 ohm. A resistive…

A: Given, A dc source has open circuit voltage, Vs=Vth=30 V Internal resistance, Rs=1.5 Ω

Q: a) Inductance is a measure of how much opposition a loop offers to a change in the current in the…

A: (a) Inductance is the property of the material which opposes the change in current it also generate…

Q: The current flowing in resistor R in the circuit shown in figure is 12- 1.

Q: An R-L series circuit contains two resistors and two inductors. Th resistors are 68 ohms and 124…

Q: A circuit consists of a pure resistance and a coil in series. The power dissipated in the resistance…

A: Current flowing through circuitP=VII=PV=500100=1 APower across coo.1 (complex)S=VI=50X5=250VA

Q: Design an inverting linear summer circuit to perform function as Vo = -4V1 -10V2 + 5 V3 + 15 V4. Do…

Q: An inductive coil takes a current of 2 A and consumes 160 W when connected to a 240 V AC supply. A…

Q: A resistor and capacitor are connected in series to an a.c. supply of 50 V and 50 Hz. The current is…

A: Impedance is represented as Z=R+jX where R represent resistance , and X represent reactance . The…

Q: Example #1 When the system shown in Figure 5-56(a) is subjected to a unit-step input, the system…

Q: Find for maximum power transfer and the maximum power that can be transferred to the load in the…

A: According to the question we need to calculate the value of RL and PL.

Q: A current source with parallel resistance can be convert voltage source with ---- resistance. series…

Q: Initially a 10 V battery is in series with a 100 ohm resistor and a 2 mH inductor. After a long…

A: Inductor doesn't allow sudden change of current.

Q: 2- Describe the series-parallel combination between points A and D in Figure R2 R3 R1 Ao W R4 R6 R5…

A: Detail solutions in the image

Q: 30. The waveforms in Figure 6-81 are observed on the inputs of a 74HC151 8-input multiplexer. Sketch…

A: When enable(bar) input is low then the multiplexer works. If enable(bar) input is high then the…

Q: series circuit consists of a resistance of 10 ohms and a reactance of 5 ohms. Find the equivalent…

A: We need to find out conductance and susceptance

Q: Q3. (a) Find the equivalent resistance between A and B in the circuit in Figure below. A - 42 62 B.

A: This is combination of the series parallel resistance. Find the equivalent resistance across A and B…

Q: A coil and resistor each have a 160-V voltage across them when connected in series to 240v, 60 Hz…

Q: 1. An example of a series connection we- problems with your Christmas lights like busted bulb a. Why…

A: a) For the supply of 220 or 110 v ,we have the rating of each light is very small compared to the…

Q: Write the formula for the combination of the capaictor in the series and the parallel connection

Q: 20. Circuits that have more than one path for current flow are _____ circuits. Select one: A.…

Q: Q2: The equivalent Thevenin's circuit for the following figure is: R2 R6n E1 R20 R 30 -8 V

A: The given circuit is,

Q: Find V, in the figure

Q: 8: The switch has been in position "a" for a 5E long time. At t=0, the switch moves to "b". Detemine…

Q: The figure is a graph of ... 5 (5 Points) Current Voltage the current across a voltage as a function…

A: The figure of a graph

Q: Draw a easy parallel circuit, using Voltage Source E with 3 resistors. Each resistor has its own…

Q: An inductive coil takes a current of 2 A and consumes 160 W when connected to a 240 V AC supply. A…

Q: how many ways can five resistors and four inductors be arranged in a series connection if the…

A: First find the equivalent of all the series resistance. Let's say R Then just using simple…

Q: 5. A RL series circuit of R = 50, L = 100mH is connected across a 50V dc source. What is the rate of…

A: Given: For the given RL series circuit, R=5 Ω,L=100 mH=0.1 H,Vs=50 V. The equation of current in an…

Question

100%

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

7. The resistor in an R-L series circuit has a voltage drop of 53 V, and the inductor has a voltage drop of 28 V. What is the applied voltage of the circuit?
An R-L series circuit contains two resistors and two inductors. The resistors are 86 k and 68 k . The inductors have inductive reactances of 24 k and 56 k . The total voltage is 480 volts. Find the voltage drop across the 56-k inductor.
An R-L series circuit contains two resistors and two inductors. The resistors dissipate powers of 96 watts and 125 watts. The inductors have reactive powers of 100 VARs and 78 VARs. What is the power factor?
Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
A resistor and capacitor are connected in parallel to a 277-V, 60-Hz power source. The resisitor has a value of 50Ω and the capacitor has a value of 40uF. What is the circuit power factor? Show your work.
A circuit consists of a pure resistance and a coil in series. The power dissipated in the resistance is 500 W and the drop across it is 100 V. The power dissipated in the coil is 100 Vand the drop across it is 50 v. Find the reactance and resistance of the coil and the supply voltage.
Urgent. In the circuit shown in the figure, the RL load is connected to a 20V source when switch K is in position 1; Explain the effect of inductance in the circuit.
A dc generator and a battery are connected to a resistive load RL in the figure below. For each, determine the value of RL for maximum power transfer to RL. Next is to determine RL to 75% efficiency
A resistor and a capacitor are connected in series across a supply of 250 V. When the supply frequency is 50 Hz the current in the circuit is 5 A. When the supply frequency is 60 Hz, the current is 5.8 A. Find the value of the resistance.
A 1 ohm resistor is connected in series with a 2mH inductor. If a 12V dc source is suddenly connected across its terminals, how long it will take, such that the voltageacross the resistor will be twice as that of the inductor.
An inductor and resistor are connected in parallel to a 120v, 60 Hz line. The resistor has a resistance of 40 ohms, and the inductor has an inductance of 0.2 H. What is the total current flow through the circuit?
A resistor of 5 ohms is connected in parallel with an inductive reactance of 10 ohms, then connected in series with a capacitive reactance of 5 ohms. If the entire combination is connected across a 100 V, 60 Hz ac source, find the voltage across the resistor.