Titration

Sort By:
Page 1 of 50 - About 500 essays
  • Better Essays

    would changed colours from colourless to pink indication when enough KOH(aq) was added. The purpose of numerous trials was to use the average volume of the 3 trials with similar measurements. Purpose The purpose of this lab was to use process titration to find concentration of an aqueous solution of Hcl(aq) , using KOH(aq) as the titrant. Results Table 1.0: Information gathered during the trial: The volume of KOH(aq),titrant, used in different trial. Trial 1 2

    • 825 Words
    • 4 Pages
    Better Essays
  • Decent Essays

    acid-base titration. In part A of this experiment, the molarity of an assigned concentration which was 0.040, was found using formulas that represent molarity. Part B of this experiment, which was titration of an acid and base, was found by a series of steps that involved dropping Sodium Hydroxide from a buret into vinegar, until the perfect shade of pale pink occurred. With the Phenolphthalein, too much acid causes the base to turn a dark pink. The molarity was then found of the titration. So the

    • 970 Words
    • 4 Pages
    Decent Essays
  • Decent Essays

    Titration Lab

    • 407 Words
    • 2 Pages

    Titration is a technique that is used to determine and analyze the concentration of a substance. It is based off of mole ratios between the two substances taking part in the lab. Burets are used in the titration of substances, which are large glass tubes with a valve attached to the bottom to allow the specially measured amount of substance into another. The amount of each substance must be very precise and be recorded properly. The analysis of these reactions are usually simplified to a 1:1

    • 407 Words
    • 2 Pages
    Decent Essays
  • Better Essays

    Titration Laboratory

    • 2081 Words
    • 9 Pages

    Laboratory: Titration of an Acid with a Base Tristian Pérez Rivera 12-136 AP Chemistry Professor Judith Martínez PhD Objective * The purpose of this laboratory is to recreate and understand what titration is. Hypothesis * If the experiment works correctly, we should determine the amount of a substance by adding a carefully measured volume of a solution with known concentration until the reaction of both is complete. Materials * Computer Pre-lab 1. How will you know when your titration is finished

    • 2081 Words
    • 9 Pages
    Better Essays
  • Decent Essays

    Titration Lab

    • 669 Words
    • 3 Pages

    Titration can be used to standardize a solution. In this experiment, sodium hydroxide was used to titrate KHP solution. Using the results of the titration, the exact concentration of NaOH was calculated to three significant figures. As see in data table A.1, the volume of NaOH used in trial one is 25.95 mL, and moles of KHP is 0.003501 mol. Using this information, the molarity of NaOH was found by using the formula, Mass of sample x (1 mole/ atomic mass), in Table A.2. After plugging in the appropriate

    • 669 Words
    • 3 Pages
    Decent Essays
  • Good Essays

    Titration Lab

    • 1667 Words
    • 7 Pages

    found through titration. A titration is where a substance with a known concentration is tested with a substance that has an unknown concentration to find that concentration (What Is a Titration). Titrations are very important in the food industry. It is important to know the concentration of an ingredient or chemical especially when it comes to nutrition facts and labels for a particular product. Scientists use titrations to figure out the nutrients that are in food items. Titrations can determine

    • 1667 Words
    • 7 Pages
    Good Essays
  • Decent Essays

    Titration Lab

    • 466 Words
    • 2 Pages

    Titration is the slow adding of one solution of a known concentration (called a titrant) to a known volume of another solution of unknown concentration until the reaction reaches neutralization which is indicated by color change (1). We take the solution of known concentration and carefully mix it with unknown concentration until the solution is concentrated. The main goal of this experiment was to prepare a standard solution of oxalic acid and use it to standardize an unknown sodium hydroxide solution

    • 466 Words
    • 2 Pages
    Decent Essays
  • Decent Essays

    Oxidation Titration

    • 1475 Words
    • 6 Pages

    oxidizing agent. In this lab, a solution of KMnO4, an oxidizing agent, will be standardized by titration with a solution containing a known concentration of iron (II) ions, (Fe+). The concentration of oxalic acid solution will be determined by titration with the MnO4- solution that had been standardized first. The purpose of this lab is to standardize a solution of potassium permanganate by redox titration with a standard solution of

    • 1475 Words
    • 6 Pages
    Decent Essays
  • Decent Essays

    Titration Lab

    • 454 Words
    • 2 Pages

    of a titration is to discover the concentration of the unknown acid or base. In this case, the experiment uses a strong base to titrate the unknown acid. Once the titration is complete, the data is plotted to create a graph that shows the equivalence point as well as the change in pH with each volumetric addition of NaOH. The equivalence point in the graph is the point where the moles of acid equal the moles of base added, which can be expressed as the equation MaVa = MbVb. On any titration graph

    • 454 Words
    • 2 Pages
    Decent Essays
  • Decent Essays

    Today, in the real world, titration is used in the medical field to find the concentration of blood and urine. It is also used to find a certain amount of a chemical in a food. A titration is a way to the concentration of an unknown solution by using a solution with a known concentration. The unknown solution is called an "analyte", while the known solution is called the "Titrant". The glassware used in order to preform titrations is a buret or "burette". A burette is a glass cylinder with a tap

    • 394 Words
    • 2 Pages
    Decent Essays
Previous
Page12345678950