Answered: :. Dimensions of the resistance in an…

:. Dimensions of the resistance in an electrical circuit in terms of dimension of mass M, length L, time T and current I, are (a) [ML T-A-1] (c) [ML?T-'A-'j (b) [MLT-2] (d) [ML?T -³A-2]

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 66P: A short circuit in a 120-V appliance cord has a0.500- resistance. Calculate the temperature rise of...

See similar textbooks

Related questions

Q: The combined electrical resistance R of the resistances R, and R, connected in parallel , is given…

Q: A circuit has a battory with an oloctromotivo force of 10.0 V and a negligible intornal resistance…

Q: A student performs an experiment to determine the resistance of a resistor. She takes voltage versus…

A: Slope of best line, R1 = 15.2Ω Slope of worst line, R2 = 14.2Ω

Q: Suppose the voltage in an electrical circuit varies with time according to the formula V(t) = 100…

A: V(t)=100 sin (t)V(t)=1π∫0πV(t)dtV(t)=1π∫0π100 sin (t)dt

Q: An electric current in a conductor varies with time according to the expression I(t) = 100 sin…

Q: The speed of propagation of the action potential (anelectrical signal) in a nerve cell depends…

A: Given: distance,d = 1.1 m speed, v = 18 m/s

Q: I. PURPOSE: Is cakutate the Specific chaige8 Coper Tas wbich is the amantf dhange curtird bya mit…

A: If you plot the graph between Mcu and It then it looks like below

Q: What is the fractional change in the resistance of an iron filament when its temperature changes…

Q: If two resistors with resistances R, and R, are connected in parallel, as shown in the figure, then…

Q: An electric current in a conductor varies with time according to the expression I(t) = 84 sin…

Q: An electric current in a conductor varies with time according to the expression I(t) = 94 sin…

A: Given that,An electric current in a conductor varies with time according to the expression I(t) = 94…

Q: Calculate B(0) values for current 1A and discuss the results (equation 2 fror presentation will be…

A: The magentic field inside the coil is given by: B =μ0nI2R for n loops : B = nμ0I2R μ0 = 4π x10-7 I…

Q: During an experiment to verify Ohm's law, the voltage supplied and the current through a circuit are…

A: Given : current, I = 28 ± 0.1 A Voltage, V = 18 ± 0.4 V

Q: An electric current in a conductor varies with time according to the expression I(t) = 110 sin…

A: I(t)=110sin90πttime, is from 0 to 1/180 sec.

Q: What do you think will happen to a load that was rated at 1.8v, 35mA if it was connected on a 5v…

Q: Q-2-3 in the circuit shown in the figure, the S switch is closed at t=0 and the capasitors, which…

Q: Your lab partner builds a circuit consisting of a power supply, voltage probe, current probe, and…

Q: A 12.0 (V) battery is connected to a resistor network as shown below in fig (i). What's the…

Q: An electric current in a conductor varies with time according to the expression I(t) = 110 sin…

A: Solution:-current in conductor is given by It=110 sin90πtwe have to find total charge…

Q: Two cities separated by 10,000 ft is connected by telephone wires whose thermal coefficient of…

Q: Given a capacitor with capacitance 10.0 ± 0.1 µF and a resistor with resistance 10.0 ± 0.2 MΩ. What…

Q: If 1.85 miles of 24-gauge copper wire has a resistance of 1.47 kΩ and the resistivity of copper is…

A: Given Data: The length of the copper wire is, L=1.85 miles The resistivity of the copper is,…

Q: By measuring the currents and times and then draw the current vs time graph using the measurement at…

A: SOlution: Given that ε =8 V, R=1M Ω and C=4.7μF. What is the current at t=12 s?

Q: Calculate B(0). Draw B (measured values)- n curve for current 1A B(0) (mT) I (mm) R (mm) Measured…

A: All the required data is given . To find = Calculated magnetic field

Q: If two resistors with resistances R, and R, are connected in parallel, as in the figure below, then…

Q: Suppose the current in a conductor decreases exponentially with time according to the equation I(t)…

A: Write the expression for the electric current, and solve for the expression for the amount of charge…

Q: The formula for the power output P of a battery is P- VI - RI“, where V is the electromotive force…

A: (1) Given : P = VI -RI2 R = 0.5 ohm V = 10 volts At maximum value of power…

Q: The voltage V (volts), current I (amperes), andresistance R (ohms) of an electric circuitare related…

A: Given:- Suppose a circuit having the voltage V (Volts), current I (Amperes), and resistance R (Ohms)…

Q: I. PURPOSE: Is calkutate thr Specitic charge8 Coper Tas waich is the amant of dhange curriedd bya…

A: We plot the graph between Mcu and It in the excel sheet and it looks like below:

Q: A rosistanca R dissipatos a powor P when connectod in sorios with a battory with an oloctromotivo…

A: Potential , V = 15 V To find = Power dissipated by the second resistor

Q: Q.1: Calculate the value of Vbase for circuit in figure (1) when the inputs VA = VB = 15V. Q.2: Draw…

A: Value of Vbase for circuit in figure (1)? when the inputs VA = VB = 15V.

Q: What is the emfx of a cell being measured in a potentiometer, if the standard cell’s emf is 12.0 V…

Q: If R is the total resistance of three resistors, connected in parallel, with resistances R,, R2, R3,…

Q: If the charging current when measured was 0.35 Ampere at t = 2.5r, where t is the time constant,…

A: We know thatI=I0e-(t?)HereI=Current at time tI0=Intial current?=time constantt=time

Q: Find the magnitude of I, and Iz in electrical circuit?

A: The equivalent resistance of these two parallel resistors are Since R1 and the 3Ω resistor are in…

Q: Given the equation, V – Voe-(2.6x10-3)t, at what time will | %3D oe the voltage drop by its original…

A: According to guidelines we need to solve only first question kindly repost other questions in the…

Q: An electric current in a conductor varies with time according to the expression I(t) = 106 sin…

A: Given: The current variation in conductor is I=106sin180πt

Q: 1. The electrical resistance of a piece of wire of length L and diameter d is given by R = 4PL nd²…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: The voltage V (volts), current I (amperes), andresistance R (ohms) of an electric circuitare related…

A: Given: Voltage= V current =I Resistance = R dVdt=1 Volt/secondsdIdt=-13 Amp/seconds

Q: Time left 1:11:5 The current in a wire varies with time t according to the relation: I(t) = 3+3t2.…

Q: During an experiment to verify Ohm's law, the voltage supplied and the current through a circuit are…

Q: The PLA device is the programmable array of AND gates feeding a fixed array of OR gates. Select one:…

A: PLA ( programmable logic array ) has programmable connection for both AND and OR gates . so this…

Q: The conductance G of an object is defined as the reciprocal of the resistance R; that is, G = 1/R.…

A: Given data: Magnitude of current drawn is, I=440 mA=440×10-3 A. Voltage supply is, V'=3.0 V.

Question

I need the answer as soon as possible

3. Dimensions of the resistance in an electrical circuit in
terms of dimension of mass M, length L, time T and
current I, are
(a) [ML T-3A-']
(c) [ML?T-'A-1j
(b) [ML?T-2]
(d) [ML?T -3A-2]

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Image_1

VIEW

Step 2 Image_2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

If two 20uf capacitors in series were connected to two 1 k ohm resistors in parallel… what would the time constant of this circuit be?
The formula to calculate impendence in an RL circuit is: calculate the resistance.
For a LR circuit, the current increased from 0 to 65% of it's max. value in 3.2 ms. -What's the time constant of this circuit (answer in ms)? -If L is 28mH, calculate the resistance R (answer in Ω) ?
For a parallel circuit, the power storage voltage is 6 V. The nominal resistance for R1 and R2 is 150 ohms and 220 ohms, respectively. If 1/Rt = R2 +R2/R1*R2, then Rt R1*R2/R2+R1 =1 From the attached, so as to understand conceptually, can you explain and describe from the nominal resistance for R1 and R2 given, the general nature of a parallel circuit in terms of the columns given specified in the variables and the relationship, such a V to V1 and V2; I to I1 and I2, then I1 +I2?
The power dissipated in a resistor is given by P = V2/R, which means power decreases if resistance increases. Yet this power is also given by P = I2R, which means power increases if resistance increases. Explain why there is no contradiction here.
Using the results of the above example on Example 20.3, find the drift velocity in a copper wire of twice the diameter and carrying 20.0A.
A short circuit in a 120-V appliance cord has a0.500- resistance. Calculate the temperature rise of the2.00 g of surrounding materials, assuming their specific heat capacity is 0.200cal/gC and that it takes 0.0500 sfor a circuit breaker to interrupt the current. Is this likely to be damaging?
Review. When a straight wire is warmed, its resistance is given by R = R0,[1 + a(T T0)] according to Equation 27.20, where a is the temperature coefficient of resistivity. This expression needs to be modified if we include the change in dimensions of the wire due to thermal expansion. For a copper wire of radius 0.100 0 mm and length 2.000 m, find its resistance at 100.0C, including the effects of both thermal expansion and temperature variation of resistivity. Assume the coefficients are known to four significant figures.
Show that the power dissipated by the load resistor is maximum when the resistance of the load resistor is equal to the internal resistance of the battery.
Integrated Concepts Use the ECG in Figure 20.34 to determine the heart rate in beats per minute assuming a constant time between beats. Figure 20.34 A lead II ECG with corresponding arterial blood pressure. The QRS complex is created by the depolarization and contraction of the ventricles and is followed shortly by the maximum or systolic blood pressure. See text for further description.
An electronic apparatus may have large capacitors at high voltage in the power supply section, presenting a shock hazard even when the apparatus is switched off. A “bleeder resistor" is therefore placed across such a capacitor, as shown schematically in Figure 21.50, to bleed the charge from it after the apparatus is off. Why must the bleeder resistance be much greater than the effective resistance of the rest of the circuit? How does this affect the time constant for discharging the capacitor?
If a potentiometer is used to measure cell emfs on the order of a few volts, why is it most accurate for the standard emfs to be the same order of magnitude and the resistances to be in the range of a few ohms?