. Kpl = 4.4 x 10-31 at 25 °C and AH° = 180.5 kJ/mol for this reaction. Calculate Kp2 at 2400. K. N2(g) + O2(g) → 2NO(g) K2 ΔΗ° In (²/²) = 4/1² (²1/12 - 11/12) K1 R T1 T2 R = 8.314 J/mol K

Q: When an acid meets your skin, you should immediately wash it with what?

A: When acid meets your skin you should immediately wash it with cold water for 15 - 20 minutes. If it…

Q: 2. Determine the titer value of the following compounds: Volume of Titrant Iml Iml Iml Iml Iml 3…

A: The titer value is explained as the volume of the titrant which is required to titrate the definite…

Q: Problem 2: A metal rod 0.4 m long & 0.04 m in diameter has one end at 373 K & another end at 273 K.…

A: Given Lenght of metal L = 0.4 meter Diameter D = 0.04 meter Thermal conductivity K = 385 J/ m s oC…

Q: Find the solution of following ODE by Laplace transform of the function x( t) and Ca(t) that…

A:

Q: Please show your complete solution and show units when solving thanks. Given the figure below, It…

A:

Q: The lowest temperature at which auto-ignition of the joil vapor occurs above the heated oil sample…

A: Cloud point is the temperature at which the solution forms an emulsion by liquid-liquid phase…

Q: The time it takes to bake a bread at 120°C is 25 min. The same bread can be baked only in 360 s in…

A:

Q: 7. Show the step-by-step process. Do not use shortcut methods. Make it as detailed as it can be.…

A: Given that- Temperature of space, Ts=-300C Initial temperature of water TA=200 C The air contains…

Q: A. What will the average value of energy that anthracite coal can give for values of H=0.2%, O 2%,…

A:

Q: 1.2048 g of impure Na₂CO3 is dissolved and allowed to react with a solution of CaCh. The resulting…

A:

Q: Given the figure below, If the barometric pressure is 1.07 bar and the gauge pressure at the bottom…

A: Given data: Barometric pressure = 1.07 bar Gauge pressure at the bottom of tank = 138.52 kPa…

Q: What is the volume (m³) of 595 lbmol of this mixture

A:

Q: AH in f298 Estimate ΔΗ. mol for 1,3-Butadiene as a liquid.

A: First write the heat of formation reaction of 1,3 butadiene. And then, Write the combustion…

Q: A 600-m3 house contains air at 17ºCand 1 atm. If the air pressure remains at 1 atm, how many moles…

A:

Q: Water at 60°F is to flow from reservoir A to reservoir B through a pipe of length 1700 ft and…

A:

Q: A sample of nitrogen at 23°C is allowed to expand reversibly and adiabatically from 400 cm³ to 3600…

A:

Q: A gas mixture consists of 218mg of ethane, 190 mg of argon and 347 mg of neon. The partial pressure…

A:

Q: A fuel containing 80% CH4 and 20% C2H6 is burned with dry air. Sixty percent of the carbon burned…

A: Given 100 moles of Fuel 80 mole % CH4 and 20 % C2H6 so 80 moles of CH4 and 20 moles of C2H6 will be…

Q: A vegetable after drying to moisture content of 5% dry basis (weight basis) is to be packaged…

A: Given data: Initial moisture content of vegetable = 5 % dy basis Final moisture content of vegetable…

Q: For ammonia at 310 K, estimate the density of the saturated liquid using the Rackett method

A: Given that- For saturated liquid ammonia, Temperature, T=310 K Molecular weight of ammonia= 17 g/mol…

Q: 1.6 1.2 + 0.8 0.4+ O -0.4 -0.8 -1.2 - -2 Fe3+ 2 1 4 Fe²+ 0 3 Fe(s) 4 Fe₂O3(s) 5 FeOH+ Fe3O4(s)…

A:

Q: FR&B 3.66. A thermostat control with dial markings from 0 to 100 is used to regulate the temperature…

A:

Q: 2) A cylinder holds 200 kg of water at 120 °C at a pressure of 20 MPa. The temperature is increased…

A:

Q: N₂O, decomposes into NO₂ and NO3 with a rate constant of 1.96 X 10¹4 exp [-10,660/T]s At t= 0, pure…

A:

Q: Which is more volatile ? the compound with less or higher boiling point?

A: T, x-y diagram of a binary mixture represents the composition of species in vapor and liquid phase…

Q: The salinity of Mono Lake in Mono County is about 80 g/l. Assume that all of this salinity is due to…

A:

Q: *9.36. Biodiesel fuel-a sustainable alternative to petroleum diesel as a transportation fuel-is…

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: A group of students are doing an analysis of copper in 1-peso coin. They were tasked to prepare…

A: Types of errors.... 1. Determinate error – also known as systemic error, causes the mean of a data…

Q: Given that the vapor pressure of n-butane at 350 K is 9.4573 bar, find the molar volumes of (a)…

A: The critical properties of the compound are considered which are critical temperature, critical…

Q: 5. The tank in Example 3.8 has a leak that admits air at the rate. 0.0005lbm (Poutside - Piank) min…

A:

Q: A large deep lake, which initially had a uniform oxygen concentration of 1 kg/m3, has its surface…

A:

Q: The pressure in a car tire depends on the air temperature in the tyre. At 25°C air temperature, a…

A: Given: Initial temperature is 25°C Initial pressure is 210 kPa Volume is 25 L Atmospheric air…

Q: The wall of a drying oven is constructed by sandwiching an insulation material W k = 0.1- between…

A:

Q: 3. What is the Molarity of a solution prepared by dissolving 8.050g Ba(OH)2(MW=171.34)in 1500ml of…

A: • Molarity :-           Molarity is defined as the amount of moles of a compound dissolved in an…

Q: Write the steady state mole balance equation for component

A:

Q: Given: Mass of 1-peso coins collected from Experiment 1. Sample No. Sample No. 1 6 2 7 3 8 4 5…

A:

Q: At 25°C, what is the pH of the solution produced when 0.0700 mL of 36.0 wt % HCI is diluted to 500…

A: Calculating the normality (or the [H+]) concentration first for calculating the pH, N1V1=N2V2N1 =…

Q: Consider a 100 mol mixture that is 71.0% methane (CH4) and 29.0% ethane (C₂H). To this mixture is…

A: Given that, The number of moles of fuel mixture = 100 mol The number of moles of methane in the…

Q: Under constant pressure P = 1 atm an ideal gas of 1.5 mol undergoes heating from 28°C to 128.0°C,…

A: Given Details: At constant Pressure , Gas is being heated P=1 atm no. of moles of gas ,n=1.5 mol…

Q: One mole of gas in a closed system undergoes a four-step thermodynamic cycle. Use the data given in…

A:

Q: Solid calcium fluoride (CaF2) reacts with sulfuric acid (H2SO4) to form solid calcium sulfate…

A: It is given that Fluorite ore is having 96.0 wt% CaF2 and 4.0 wt% SiO2. This calcium fluoride (CaF2)…

Q: A homeowner uses 2471 m3 of natural gas in a year to heat a home. Assume that natural gas is all…

A: Given that, Volume of methane CH4 V = 2471 m3 Pressure P = 1.3 atm Temperature T = 25.2oC = 25.2 +…

Q: What are homologous structures? Give an example. Is it necessary that homologous structures always…

A:

Q: Please read the problem. Show complete solution and answer.  The following questions are connected…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Problem 3 Consider a 700 mol/h feed entering a flash distillation unit or still under isothermal…

A: Given, The feed rate, F = 700 mol/h The mole fraction of benzene, z = 0.45 The operating pressure, P…

Q: Under constant pressure P = 1 atm an ideal gas of 1.5 mol undergoes cooling from 120°C to 30.0°C, =…

A: Given Details: At constant Pressure , Gas is being cooled P=1 atm no. of moles of gas ,n=1.5 mol…

Q: A saturated solution containing 1000 kg of potassium chloride at 360 K is cooled in an open tank to…

A: Given: At T = 360 K, a saturated solution containing 1000 kg of potassium chloride is cooled in a…

Q: Take the wholesale price of refined sugar (containing 0.1% water) to be 42 cents/lbm. Assume that…

A: For a detailed solution, please see the attached files.

Q: 4. The heat capacity of a substance in Cp 8.41 +2.4346 × 10-5T where T = temperature in K (Kelvin).…

A: Note: We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: and CH

A: please find answer attached below