asap correctly if incorrect i will report 120. What will be the transport number of ions in an aqua solution of 0.050 M HCI using themoving boundary method, with CdCl2 as the indicator electrode? Here, the boundary movesby 7.5 cm in a tube of cross sectional area of 2.5 cm², upon flowing of 1.1 x 10³ faraday ofelectricity in the circuit.

Transport number is a concept in electrochemistry that refers to the fraction of the total current…

0.What will be the transport number of ions in an aqua solution of 0.050 M HCI using the moving boundary method, with CdCl₂ as the indicator electrode? Here, the boundary moves by 7.5 cm in a tube of cross sectional area of 2.5 cm², upon flowing of 1.1 x 10˚³ faraday of electricity in the circuit.

0.What will be the transport number of ions in an aqua solution of 0.050 M HCI using the moving boundary method, with CdCl₂ as the indicator electrode? Here, the boundary moves by 7.5 cm in a tube of cross sectional area of 2.5 cm², upon flowing of 1.1 x 10˚³ faraday of electricity in the circuit.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter18: Introduction To Electrochemistry

Section: Chapter Questions

Problem 18.6QAP

See similar textbooks

Similar questions

Halide ions can he deposited at a silver anode, the reaction being Ag(s) + X- AgX(s) +e- Suppose that a cell was formed by immersing a silver anode in an analyte solution that was 0.0250 M Cl-,Br-, and I -ions and connecting the half-cell to a saturated calomel cathode via a salt bridge. (a) Which halide would form first and at what potential? Is the cell galvanic or electrolytic? (b) Could I- and Br- be separated quantitatively? (Take 1.00 l0-5 M as the criterion for quantitative removal of an ion.) If a separation is feasible, what range of cell potential could he used? (c) Repeat part (b) for I- and Cl-. (d) Repeat part (b) for Br- and Cl-.
The measurement of pH using a glass electrode obeys the Nernst equation. The typical response of a pH meter at 25 00C is given by the equation where contains the potential of the reference electrode and all other potentials that arise in the cell that are not related to the hydrogen ion concentration. Assume that = 0.250 V and that a. What is the uncertainty in the values of pH and [H+] if the uncertainty in the measured potential is 1 m V ( 0.001 V)? b. To what precision must the potential be measured for the uncertainty in pH to be 0.02 pH unit?
In some old European churches, the stained-glass windowshave so darkened from corrosion and age that hardly anylight comes through. Microprobe analysis showed that tinycracks anddefects on the glass surface were enriched ininsoluble Mn(III) and Mn(IV) compounds. From AppendixE, suggest a reducing agent and conditions that might successfullyconvert thesecompounds to soluble Mn(II) withoutsimultaneously reducing Fe(III) (which gives the glassits colors) to Fe(II). Take MnO2 as representative of theinsoluble Mn(III) and Mn(IV) compounds.
Using data from Table 17-1, place the following in order of increasing strength as reducing agents (all under standard conditions). Cu+,F,H,H2O,I2,K
A 0.0712-g sample of a purified organic acid was dissolved in an alcohol-water mixture and titrated with coulometrically generated hydroxide ions. With a current of 0.0392 A, 241 s was required to reach aphenolphthalein end point. Calculate the equivalent mass of the acid.
An aqueous solution of an unknown salt of vanadium is electrolyzed by a current of 2.50 amps for 1.90 hours. The electroplating is carried out with an efficiency of 95.0%, resulting in a deposit of 2.850 g of vanadium. a How many faradays are required to deposit the vanadium? b What is the charge on the vanadium ions (based on your calculations)?
Atomic masses can be determined by electrolysis. In one hour, a current of 0.600 A deposits 2.42 g of a certain metal, M, which is present in solution as M+ ions. What is the atomic mass of the metal?