1. Solubility Test Table 1. Results for the solubility test. OBSERVATION* INFERENCE SAMPLE Ethyl acetate ** Нехапe Methanol Water Coconut oil Vitamin E Beef fat * Miscible (soluble) or immiscible (insoluble) polar or nonpolar Sudan IV Test Table 2. Results for Sudan IV test. OBSERVATION* INFERENCE SAMPLE ** Hexane Ethyl acetate Methanol Water

1. Solubility Test Table 1. Results for the solubility test. OBSERVATION* INFERENCE SAMPLE Ethyl acetate ** Нехапe Methanol Water Coconut oil Vitamin E Beef fat * Miscible (soluble) or immiscible (insoluble) polar or nonpolar Sudan IV Test Table 2. Results for Sudan IV test. OBSERVATION* INFERENCE SAMPLE ** Hexane Ethyl acetate Methanol Water

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter13: The Chemistry Of Solutes And Solutions

Section13.6: Expressing Solution Composition

Problem 13.9CE

See similar textbooks

Similar questions

Pre Lab Questions: (Each answer is to be written as a complete sentence) What is the reason for washing the precipitate with water in Step 9? Define precipitate. Define filtrate. In Step 2, what is the purpose for rinsing the stirring rod? read the Procedure to answer the questions Using a balance, mass between 1.50 – 2.00 grams of sodium carbonate in a pre-massed 150mL beaker. Add 20 mL of distilled water and stir thoroughly to make sure all the crystals are dissolved. Rinse the stirring rod with a little distilled water after stirring. Using a balance, mass between 1.50 – 2.00 grams of calcium chloride dihydrate in a pre-massed 50 mL beaker. Repeat Step 2 for the solution in the 50 mL beaker. Pour the calcium chloride solution into the 150mL beaker containing the sodium carbonate solution and stir. Mass a piece of filter paper. Fold the filter paper and place it into the funnel. Wet it with a little distilled water to ensure that it is stuck to the sides of the funnel. Slowly…
1. A 0.68 gram sample of a volatile liquid was heated to 358 K. The gas occupied 265 mL of space at a pressure of 0.95 atm. What is the molecular weight of this gas? PV = nRT and R = 0.082 atmL/moleK. (Make sure that all your units agree/match R)2. An aspirin sample, 0.62 grams, was titrated with 28 mL of 0.105 M NaOH solution. What is the percent purity of this aspirin sample? (MM of Aspirin = 180. g/mol)3. A sample of hydrate was heated thoroughly. How many waters of hydration are there if the anhydrous salt had a dry mass of 12 grams and a molar mass of 185 g/mol? The mass of water evaporated from the hydrate was 5.0 g.4.A sample of water (80 grams) had a temperature change of 6. ℃. What was the heat change of this sample? (q = m c ΔT, c = 4.18 J/ g ℃)5. A 6.0 gram sample of epsom salt, MgSO4 ·nH2O, was heated. After heating, 2.9 grams of anhydrous salt remained. How many waters of hydration does epsom salt contain?6. What is the theoretical yield of aspirin if you started your…
What is Grease-Spot Test, Solubility Test, and Emulsification?
The KI used in this lab has a concentration of 0.500M. In trials 1-4, 1.0 ml of this solution is combined with 4.0 ml of the H2O2. What is the concentration of the KI in this solution after mixing but before the reaction occurs. ( Enter the result in table 1 on the report sheet)
Suppose a student performed a similar standardization titration experiment. Below is the calculated concentration of NaOH from each of their titrations. Titration #1 Titration #2 Titration #3 The concentration of NaOH (M) 0.9554 0.9540 0.9551 Using the 3 concentrations, calculate the average concentration of the student's NaOH solution and calculate the ± error in parts per thousand (ppt). Show the complete calculation. Express your final answer in the form of average (with units) ± error in ppt.
Suppose a student performed a similar standardization titration experiment. Below is the calculated concentration of NaOH from each of their titrations. Titration #1 Titration #2 Titration #3 Concentration of NaOH (M) 0.9554 0.9540 0.9551 Using the 3 concentrations, calculate the average concentration of the student's NaOH solution and calculate the ± error in parts per thousand (ppt). Show the complete calculation. Express your final answer in the form of average (with units) ± error in ppt. use the right significant figures
1. The allowable concentration of arsenic in drinking water is 0.05 mg of arsenic per liter of water. 2. A 2.5 g sample of groundwater contains 5.4 g of Zn+2. 3. A solution containing 13.5 g glucose in 0.1 kg water Solution ppm Solution ppb 1. Given: Required: 2. Given: Required: 3. Given: Required:
Q11 chapter 15 titrations Solve asap hundred percent correct solution needed
Please answer as soon as possible. Thank you! A 10.000-g cocoa powder sample was dissolved in concentrated acid and then diluted to 100.00 mL using distilled water. The solution was found to contain 5.45 uM Fe. Calculate concentration of Fe (MM: 55.845) in the cocoa powder sample in parts-per-million (ppm) (weight by volume).
The following questions all are based on the data in this table: Substance Solvent Temp.,oC Solubility, g per 100 mL X heptane 20 23.5 X heptane 80 27.0 X 1-propanol 20 0.6 X 1-propanol 80 8.7 Y heptane 20 4.0 Y heptane 80 4.0 Y 1-propanol 20 22.0 Y 1-propanol 80 31.0…
please help solve Concentration of AR Stock Solution (ppmppm) 21.22 Unrounded Rounded Concentration of AR Stock Solution (μMμM) 42.7461 42.7
Why you should not start a titration with zero mL as an initial volume What is the use of white paper (or background) at the bottom of the erlenmeyer flask? How to deliver a droplet (a.k.a. partial drop or half drop) How to remove air bubbles in the buret Why remove air bubbles? Correct way to empty the contents of a volumetric pipet Arrangement of volume markings on the buret Steps to properly clean and rinse the buret With how many trials or replicates should titrations be performed? Difference between end point and equivalence point? Which hand should be holding the Erlenmeyer flask? How should the meniscus be read?