1. Which IC that outputs 1 when both inputs are 1? 2. What is the output of 7432IC if one of the inputs is 1? 3. Which IC outputs 1 if inputs are complemented? 4. What IC is the complement of an OR gate?
Q: A differential amplifier has a common-mode gain of 0.2 and a common-mode rejection ratio of 3250.…
A: Given, Common mode gain Ac = 0.2, Common Mode Rejection Ratio = 3250 Input Voltage Vi = 7 mVrms, To…
Q: EXAMPLE: Given a bridge rectifier has an AC source V=100V at 50Hz, and R-L load with R=10ohm, L=10mH…
A: given that Vm=100VR=10ΩL=10mH In case of diode bridge rectifier average output voltage…
Q: 9. A variable-speed drive system uses a d.c. motor which is supplied from a variable voltage source.…
A: Given: A variable-speed drive system uses a DC motor which is supplied from a variable voltage…
Q: The Thevenin impedance of a source is ZTh = 120+ j 590, while the Thevenin voltage is VTh=327 + j265…
A: Maximum power: It states that maximum power transfer only possible when the load resistance is equal…
Q: 53 1.9.3 Obtain the state-space model of the single-input- single-output network system of Figure…
A: State space model: It is a mathematical model for representing the physical system. The physical…
Q: A 4-pole, lap-connected d.c. motor has 576 conductors and draws an armature current of 10 A. If the…
A:
Q: Give the value of the following resistors: with solutions (Must write final value to short notation…
A:
Q: Derive the formula for the energy stored in a capacitor.
A: Note : According to guidelines of the company if the questions are of different then we supposed…
Q: (b) Figure A1 shows a diagram of the measured &" of ice at different frequencies as a function of…
A: To show a diagram and temperature dependence is consistent with τ=τ0expT0TLet The Molecular model of…
Q: Describe how digital signals are transmitted over a telephone line or TV cable
A: Digital signals can be transmitted over the transmission line using either serial or parallel…
Q: A single phase transmission line is delivering 460 kVA load at 11 kV. Its resistance is 6.5 Q and…
A: Given: A single phase transmission line is delivering power to load SL=460 kVAVL=11 kV…
Q: Enlist the layers encapsulated solar cells? please solve proper
A: A solar cell, also known as a photovoltaic cell, is an electrical device that uses the photovoltaic…
Q: In the Y-A system shown in figure below, the source is a positive sequence with Van = 24020° V and…
A:
Q: I need ASAP. Thank you! Find the band pass phase angle (degree) of F1(Hz), F2(Hz), F3(Hz) using the…
A: Given data, f1=77.61 Hz, f2=81.59 Hz, f3=79.57 Hz Circuit diagram is given as,
Q: 4. Length of Director, L 5. Length of Reflector, LR 6. Spacing from Director to Driven Element, S…
A: As per the guidelines, in the following section, first 3 sub-parts will be solved.
Q: Find the equivalent G(s) = C(s)/R(s) for the system shown below. R(s) C(s) 20 10 s+12 10 Find the…
A: Since you have asked multiple questions in a single request, we will be answering only the first…
Q: W R₁
A: The given differential op-amp is shown below: Since the op-amp is ideal, the voltage at the…
Q: Solve by superposition and do power balance
A: Superposition theorem states that in a linear bilateral network containing more than one independent…
Q: Q7) A single-phase full wave rectifier is a a. single pulse rectifier b. multiple pulse rectifier c.…
A: Full wave rectifier:- Rectifiers function is to convert the AC to DC and full wave rectifier is used…
Q: 6. Draw the output Q for JK F.F if the input as below ск Об Ь J K- С PA
A: Draw the output waveform of JK flip flop if input as given below : Let initially output Q=0. In…
Q: 6. Consider a three-wire Y-A circuit. The voltages of the Y-connected source are V = (208/√3)2 - 30°…
A: Given, A three wire Y-∆ circuit. Y connected sources are, Va=208/3∠-30° VVb=208/3∠-150°…
Q: Draw a schematic diagram of a full-wave bridge power supply.
A: Full wave bridge convert Alternating input to DC output which is used as the input source for…
Q: R₂ www w www
A:
Q: Draw a schematic diagram of a switching transistor
A: A transistor is a three-terminal semiconductor device, which can be used as an amplifier , as a…
Q: .Design equation F(A,B,C,D)=E(1,2,3,6,8,10,12,13,15) using a 4x1 Mux?
A: Follow the Boolean laws provided Compare the obtained F with standard multiplexer notations and…
Q: 0.05x+0.10(150,000-x)=10,000 Solve
A: Given An equation involving a single variable,we need to solve for X value. Please find the below…
Q: Find the values of M and fv so that the response has an overshoot of 17 percent and a settling time…
A: It is given that: %Mp=17%Ts=10 secK=1ft=ut
Q: Question 3 A 30, Y-A system with a negative phase sequence and Vbc = 320 L 25° V at 60 Hz, has the…
A:
Q: A capacitor with a capacitance of 3.6360426666667E-10 pF is a parallel plate capacitor. Each plate…
A:
Q: motor connected to a 220-V supply line from the power company has a current of 7.6 A. Both the…
A: In this question RMS voltage and current given....We have to find out apparent , reactive power ,…
Q: 5 cos 400t A V1 2 5 mH 1/800 F -(¹/8)U1
A: Average power: Average power is the total useful power of the circuit that is utilized by the ac…
Q: 9. The current I (in amperes) through a section of wire varies with time t (in seconds) given by the…
A: In this question , current through wire is given....We have to find out charge.....
Q: What is the voltage across the power supply in the circuit below? R9 8 Ω ww + V3 unknown R7 202…
A: The objective is to determine the voltage across the power source.
Q: 1. Describe the constructional features and characteristics, of a induction motor that would be used…
A: Late machine: This is used to cut the extra workpiece from the material by rotating the tools…
Q: A capacitor made of 130 plates in parallel is separated by a 0.0297 m thick of insulator with a…
A:
Q: Give the value of the following resistors: (Must write final value to short notation using KOhms,…
A: The objective is to determine the color code.
Q: in a series Ri circuit voltage across the resistor is 100 V and the voltage across inductor is 50 v.…
A: Given, VR = 100 V , VL = 50 V, To calculate the power factor of the circuit.
Q: The diodes are ideal, zero cut in volts, zero forward resistance and infinite reverse resistance.…
A:
Q: What is the capacitance of a capacitor with 4.9 m² plates cross-sectional area and 0.07 m apart in…
A: Brief description: In the above given question they have mentioned area of the plates and distance…
Q: What is the high pass filter cutoff frequency of the circuit R1= 54 0, R2 = 2610, RF = 332 0, RG =…
A: High pass filter is a filter which allows only higher frequency to pass through and blocks low…
Q: التاريخ: Q/ Find R. for the following network: R₁=3R Rs R₂=3R ли =3√2² Rum =352 R3 MA الموضوع : .…
A: Given figure, Now, we have to calculate the value RT,
Q: Two different loads A and B are connected across a balanced 230 V, 3-phase lines. Load A is a…
A: Here we understand about 3phase power power related concept. Load A :- 3phase Delta connected,…
Q: 7. Convolve a signal with values x = [3,5,-2] with a system that has the following impulse response…
A:
Q: Derive the operating point ,Q-pt., of the BJT voltage-divider bias circuit shown using Approximate…
A: It is given that: Required: Q-point or Operating point.
Q: Question 3 Consider the magnetic circuit of the following figure, Let the cross-section Area Ac…
A:
Q: Circuit Diagram R1 L1 50Q 10mH V1 220 Vrms C1 10uF ~60 Hz 0° Computed Values Compute the expected…
A: Capacitor: This is an energy storage device that store the energy in the form of the electric field.…
Q: The manufacturer of a selected diode gives the rate of fall of the diode current di/dt = 20A/µs, and…
A: Given data, Diode specifications didt=20 A/μstrr=5 μs
Q: Find the equivalent resistance for the circuit in the figure below. R R R www w R R Vemf +
A: given here a electrical network and asked to determine the equivalent resistance of the circuit.
Q: - The Diod (semiconductor) has Is (saturation) Current = 0.01 [A] and VD = 100 find the ID Wehen the…
A: The diode current varies with the temperature given by the expression as shown below:…
Q: A multiloop circuit of resistors, capacitors, and batteries is switched on at t = 0, at which time…
A: It is given that: At t=0, a multi-loop of resistors, capacitors, & batteries is turned on, with…
Step by step
Solved in 2 steps
- Please answer these questions for me to understand our lesson better. Thank you!1. Which IC that outputs 1 when both inputs are 1? 2. What is the output of 7432IC if one of the inputs is 1? 3. Which IC outputs 1 if inputs are complemented? 4. What IC is the complement of an OR gate?draw and identify or explainMake na input circuit using a switch and an external pull-up resistor.What are the logic states of the microcontoller if the switch is open?What are the logic states of the microcontoller if the switch is off?A 5-bit ADC has the following reference values Vref = -2V and 12 V. What is the voltage represented by the output sequence 01010?
- 1- What does the VOH parameter of a logic IC refer to? a) The highest permissible output voltage. b) The lowest output voltage recognized as logic 1. c) The highest output voltage recognized as logic 1. d) The highest output voltage recognized as logic 0. 2- Which of the following refers to the noise margin of a logic gate? a) The difference between VIH and VOL b) The difference between VOH and VOL c) The difference between VOH and VIH d) The difference between VIH and VIL 3- How many 74LS00 NAND gate inputs can be driven by a 74LS00 NAND gate outputs Refer to data sheet of 74LS00, the maximum values of IOH = 0.4 mA, IOL = 8 mA, IH = 20 μA, and IL = 0.4 mA. 4- The data sheet of a quad two-input NAND gate specifies the following parameters: IOH (max.) 0.4 mA, VOH (min.) 2.7 V, VIH (min.) =2V, VIL (max.) 0.8 V, VOL (max.) 0.4 V, IOL (max.) 8 mA, IL (max.)=0.4 mA, IIH (max.)-20µA, ICCH (max.) 1.6 mA, ICCL (max.) 4.4 mA, tpLH =pHL=15 ns and a supply voltage range of 5…choose the correct answer If a two-input logic gate produces a output of logic HIGH, only if both inputs are different, then the logic gate is? a. IC 7400 b. IC 7486 c. IC 7408 d. IC 74321. Show how to implement 32K× 16 EPROM using two 32K×8 EPROM?2. List the pins related to the interrupts
- Given a 5-bit ADC with the following reference values Vref= -2V and 12V, what is the voltage represented by the output sequence 01010?A)What will be the frequency at C if the clock is 320 kHz? B) What is the modulo of the circuit? C) What is the output (in binary) after 737 pulses?Explain what the circuit does and how it works. (Hint: This circuit is called a 2-bit synchronous binary up-down counter.)
- The circuit can operate as a4-to-16 decoder. Terminal EN denotes the enableinput. Describe the operation of the 4-to-16 decoder.What is the role of logic variable A?What type of electronic device would be used to convert binary numbers to decimal numbers? In this experiment a IDGH voltage (near + 5 V) stood for ( 0 , 1) The 7442 IC has active _____ (HIGH, LOW) inputs. The "bubbles" at the outputs of the 7442 decoder mean this IC has active _____ (HIGH, LOW) outputs. If the binary input to the 7442 decoder is 0110, then output _____ (decimal number) is activated. If the binary input to the 7442 decoder is 0111, then output pin number _____ of the IC will become active and go ____ (HlGH,LOW)Q1: Design and implement an asynchronous counter that counts from 0000 up to 1100 (modulus 13). Use OR gate, and show in the drawing how the OR gate is connected to truncate the state 1101.