10 µF In the circuit shown, what is the charge on the 10µF сараcitor? 15 µF 5 µF 10V • The two 5µF capacitors are in parallel • Replace by 10µF • Then, we have two 10µF capacitors in series • So, there is 5V across the 10µF capacitor of interest • Hence, Q = (10µF )(5V) = 50µC 10 µF 10 µF, 10V

10 µF In the circuit shown, what is the charge on the 10µF сараcitor? 15 µF 5 µF 10V • The two 5µF capacitors are in parallel • Replace by 10µF • Then, we have two 10µF capacitors in series • So, there is 5V across the 10µF capacitor of interest • Hence, Q = (10µF )(5V) = 50µC 10 µF 10 µF, 10V

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

the voltage across a 3.71uf capacitor in a tv circuit is 4.54 mV. Find the voltage after 0.563ms if a current is given below (in uA) further changes the capacitor. i= (1+6t)^(1/3) The voltage at t = 0.563 ms is _________ mV. I have no clue on the steps to solve such a problem help would be greatly appreciated
Suppose one wished to capture the picture of a bullet (moving at 5.0 X 102 m/s) that was passing through an apple. The duration of the flash is related to the RC time constant, τ . What size capacitor would one need in the RC circuit to succeed, if the resistance of the flash tube was 10.0 Ω ? Assume the apple is a sphere with a diameter of 8.0 x 10-2 m.
The figure shows a resistor of resistance R = 6.32 connected to an ideal battery of emf 8 = 14.0 V by means of two copper wires. Each wire has length 22.0 cm and radius 2.30 mm. In dealing with such circuits in this chapter, we generally neglect the potential differences along the wires and the transfer of energy to thermal energy in them. Check the validity of this neglect for the circuit of the figure below. What is the potential difference across (a) the resistor and (b) each of the two sections of wire? At what rate is energy lost to thermal energy in (c) the resistor and (d) each section of wire?
The capacitance in the curcuit is C = 0.3μF, the total resistance is R=20kQ and the battery emf is 12 V. Determine the time is takes for the charge the capacitor could acquire, to reach 99% of max value.
Integrated ConceptsIf you wish to take a picture of a bullet traveling at 500 m/s, then a very brief flash of light produced by an RC discharge through a flash tube can limit blurring. Assuming 1.00 mm of motion during one RC constant is acceptable, and given that the flash is driven by a 600-μF capacitor, what is the resistance in the flash tube?
Using the exact exponential treatment, find how much time is required to charge an initially uncharged 132 pF capacitor through a 73 MΩ resistor to 90% of its final voltage.
Three capacitors, C1 = 4.77E-5 F, C2 = 3.36E-5 F, and C3 = 5.66E-5 F are connected by ideal metal wires, as shown in the figure. Consider the same three-capacitor circuit in the previous question. If the voltage difference between points a and b is measured to be 8.51 V, what is the voltage difference between points b and d (in V)?
800 ideal capacitors are connected in parallel to an ideal voltagesource, forming an ideal circuit. The first capacitor has a capacitance of3.52 μF. If the capacitors are arranged such that every capacitor, starting from the second one, has a capacitance that is 1/3 that of the neighbor-ing capacitor on its left (C2 = C1/6, C3 = C2/6, C4 = C3/6, · · ·), the equivalent capacitance of the parallel connection is most nearly
Suppose we have a circuit with two capacitors with C1 = 5.2µF and C2 = 11.5µF that are connected in series withan external voltage of 6.2V. What are the voltage drops across each of the capacitors?
Using the exact exponential treatment, find how much time is required to charge an initially uncharged 100-pF capacitor through a 75.0-M Ω resistor to 90.0% of its final voltage.
Imagine that we had a RC circuit with a 19.2 kilo-ohm resistor connected in parallel with a 16 kilo-ohm resistor and they were connected to two capacitors (404.2 uF, 350.1 uF) that are in series. What is the time constant of this circuit?
A Christmas light is made to flash via the discharge of a capacitor. The effective duration of the flash is 0.21 s (which you can assume is the time constant of the capacitor), during which it produces an average 35 mW from an average voltage of 2.85 V. What is the resistance, in ohms, of the light?