100. Two sinusoidal equations are given as:e, = Asin ot +eg = Bsin ot-6.andThe phase difference between the two quantitiesis

we need to find out phase difference between e1 and e2.

Answered: 100. Two sinusoidal equations are given…

100. Two sinusoidal equations are given as: Asin cot + e, = Asin ot + %3D = Bsin ot- TC and 6, The phase difference between the two quantities is

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.9MCQ

See similar textbooks

Related questions

Q: Find the total impedance ZT in polar form b. Draw the impedance diagram c. Find the current I and…

Q: H.W E = 12 V For the network determine the sinusoidal Expression for the voltage V; using…

Q: What is the phasor expression for the impedance in polar form for the circuit below? 56 N Xc 100 N O…

A: Given circuit:

Q: Consider two sinusoidal voltages V1 and V2: v, (t) = 60v2 sin ( 140nt + v2(t) = 80v2 sin (140nt 3.…

A: Given that v1t=602sin140πt4+5π6v2t=802sin140πt4-π3 write v1 and v2 into polar form…

Q: Find the phase relation for the following pairs of sinusoids, (which leads and lags which by how…

Q: A sinusoidal voltage source is represented by the vector pointing to 6 + j4 on the complex plane. It…

Q: stion : What is the sinusoidal transSier function GJ@) of your open-loop system? (Hint: Replace s…

Q: The in-phase sinusoidal currents in the parallel branches of a circuit have the following equation:…

A: Given , i1=17 sin 377t Amp i2=22.6 sin 377tAmp

Q: The dissipation wave is connected to the characteristic impedance Ro = 50(0) which leads to the net…

Q: theo Ch2: Sinusoidal Steady-State Analysis Sinusoids OExample: Calculate the phase angle between vi…

Q: Example-Series-1: For the RL circuit, find (1) w, T, L, ZT (2) I†, VR, V L (3) Average power of each…

Q: Given v1 = 20 sin (ωt + 60˚)V and v2 = 60 cos (ωt - 10˚)V, determine the phase angle between the two…

Q: Three branches having impedances of 3+j4 Ω, 16−j12 Ω, and−j4 Ω, respectively, are connected in…

A: Given data: Impedance Z1 = 3+j4 Ω Impedance Z2 = 16-j12 Ω Impedance Z3 = -j4 Ω The admittance of the…

Q: Load 1 V1 sine (A Load 2 Load 3 60 Hz Given: • V1 = 195 Vrms S_load1 = 1,087 VA @ 45 degrees •…

A: Given data: V1=195 V(rms) S for loading 1=1,087 VA at 45o P for load 2: 521 W Q for load 2: 755 VAR…

Q: Q2. A series of motor (Load 1) and lighting (load 2) are connected to an AC source as shown in…

Q: (d) Calculate the steady-state current i, by using phasor method. (e) Calculate the voltage across…

A: In this question, We need to determine the current I1 as shown in the circuit. I= V/Z Voltage V=…

Q: 19.22 72mH V, Z V, -

A: we need to find out phasor V1 . Given:: the load is connected to 100V (rms) and dissipates 1kW at…

Q: I, = 2 A Z 0° %3D IR YT 20 XL 50 E ll +

A: We need to find out admittance and current and power factor for given circuit

Q: Ex. 681. Given a sinusoidal voltage source in series with R,L, and C. The sinusoidal frequency is…

A: In this question series RLC circuit is given....we have to find current and voltage across R,L,C...

Q: If a current 5.0 A lags the applied voltage 230 V by an angle ϕ, it can be resolved into two…

A: Need to find reactance and current

Q: Q2: For the circuit in the figure, find: R = 41 16mH 265LF ll + UL - + UR - Da e = 70.7 sin 377t a)…

Q: = 2. Express y - ₁ + y₂ as a single sinusoidal function if y₁ and Y₂ = 40 cos(wt+ 60°) A) Solve by…

Q: 1. The single phase ac voltage source is v = 141.4cos(377t)V, the load can be modeled as a 16mH…

A: In the question, Voltage given v=141.1cos(377t)V Resistance R=8 ohm inductance L= 16mH…

Q: Problem: Obtain the overall impedance for the following cases P = 1500 W, Q = 2000 VAR (inductive),…

A: Given, Active power, P = 1500 W Reactive power, Q = 2000 VAR (inductive) RMS current, Irms=12 A…

Q: The signal V1=100 cos(500t - 30°) and the signal V2=20 sin (500t +45°) compared in phase would be

A: The solution can be achieved as follows.

Q: An electromagnet is modeled as L=0.3H and R=200 in series, and connected to a 120V(rms) sinusoidal…

A: Solve the above questions

Q: Problem 1: Given v(1)=70.71sin (@1+45°) and i(t)=28.28 co a) Maximum voltage and current b) RMS…

A: ELECTRICAL NETWORK: When addressing a circuit problem or constructing a balanced circuit, the word…

Q: Unless given, use the: POLAR FORM for voltage and current, RECTANGULAR FORM for impedance. (30pts)…

Q: For the given circuit (A) Find the TOTAL IMPEDANCE Zr in polar form, the CURRENT I and the…

A: Power Factor- Power factor is defined as the ratio of active power to apparent power.…

Q: Q2. A series of motor (Load 1) and lighting (load 2) are connected to an AC source as shown in…

A: In this question, Find the total impedance Z = R+jX Current in the circuit I. Write the waveform…

Q: Q2. A series of motor (Load 1) and lighting (load 2) are connected to an AC source as show in Figure…

Q: 1 In the circuit of Figure. Z, = 60Z– 30°N · and· Z, = 40Z45°Q. %3D (1)-Find the phasors İ,,İ‚‚İ¸.…

A: Given circuit,

Q: Q2. A series of motor (Load 1) and lighting (load 2) are connected to an AC source as shown in…

A: In this question, we need to determine the total impedance, current I, frequency domain waveform…

Q: 2. A voltage waveform, v(t) = 200 V sin ( 250 rad/s t ), is connected across a series combination…

A: In this question series RL circuit is given...We have to find out total impedance , source current ,…

Q: Unless given, use the: POLAR FORM for voltage and current, RECTANGULAR FORM for impedance. Consider…

A: As per the guidelines of Bartleby we supposed to answer first three subpart only for solution of…

Q: Which component of impedance is not dependent on the frequency of the source of voltage? A.…

Q: If a current 5.0 A lags the applied voltage 230 V by an angle o, it can be resolved into two…

Q: Problem 1: Given v(t)=70.71 sin (@t+45°) and i(t)=28.28 cos(mt-15") ; determine the following a)…

A: Given : The supply voltage v(t)=70.71 sin (wt+45°) The supply current i(t)=28.28 cos(wt-15°)…

Q: VBR VRY VYB Figure Q1 (a) Q1 (a) Calculate the percent voltage unbalance for the phasor form in…

A: symmetrical components is analysis power in unbalanced system . symmetrical components is used in…

Q: Solution in phasor domain representation is a method that can both consider the steady state and…

A: A phasor is represented only for steady state Two waves are said to be in phase if the phase…

Q: Unless given, use the: POLAR FORM for voltage and current, RECTANGULAR FORM for impedance. Consider…

Q: If y1=20 cos (ωt − 30°) and y2=40 cos (ωt + 60°), express y=y1 + y2 as asingle sinusoidal…

Q: Find the phase inductance of the three-phase circuit shown in the figure, if the separation between…

A: Given:S=45cm=0.45md=2.1793cm = 0.021793mr=0.0108965m Formula to calculate phase inductance is:…

Q: Use the phasor analysis method to solve for the AC steady-state mesh currents, and then express each…

Q: R1 3002 V1 |120Vrms C1 60HZ 8.84uF 0°

Q: the phase relation for the following pairs of sinusoids, (which leads and lags which by how much).…

A: In this question we will write phase relationship between two given voltages...

Q: Q2: For the circuit in the figure, find: R = 40 16mH 265LF + UR - - la + Da 70.7 sin 377 a) Find the…

A: This is RLC series circuit. Find the current in the circuit and total impedance? Overall power…

Q: The following phasor diagram is: a. The phasor diagram of SG when it is running at lagging power…

A: The given phasor diagram Choose correct option. We are assuming standard parameter in the phasor…

Q: 3. Determine the sinusoidal steady state current i (t) using phasor methods. i(1) 1 kN 1.5 kN v,(t)…

A: Let, R1=1000 ΩR2=1500 ΩC=16 μFL=13 HVst=40sin3000t V

Concept explainers

Fourier Series

Most of the incidents studied in the field of Engineering and Science as a function of time. For example, current and voltage are in the alternating current circuit. These occasional activities can be analyzed in the activity components (fundamental frequency and harmonics) through a process called Fourier analysis.

Question

100%

100. Two sinusoidal equations are given as:
e, = Asin ot +
eg = Bsin ot-
6.
and
The phase difference between the two quantities
is

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
The power factor for a capacitive circuit (R-C load), in which the current leads the voltage, is said to be (a) Lagging (b) Leading (c) One
The power factor for an inductive circuit (R-L load), in which the current lags the voltage, is said to be (a) Lagging (b) Leading (c) Zero
An industrial load consisting of a bank of induction motors consumes 50 kW at a power factor of 0.8 lagging from a 220-V,60-Hz, single-phase source. By placing a bank of capacitors in parallel with the load, the resultant power factor is to be raised to 0.95 lagging. Find the net capacitance of the capacitor bank in F that is required.
Relative to the reference sinusoid, what is the phase angle of i, vR and vL in degrees?
Find the phase relation for the following pairs of sinusoids, (which leads and lags which by how much). Draw the phasor diagram e1= -20sqrt2 sin(377t + 200°) V e2 = -10sqrt2 sin(377t - 285°) V
Find the phase relationship and sketch the pair of sinusoids v = 2cos(wt - 30°)V ; i = 10sin(wt + 30°) A
Given v1 = 25 sin (ωt - 30˚)V and v2 = 25 cos (ωt + 15˚)V, determine the phase angle between the two sinusoids and which one is lagging. [
A sinusoidal signal of 20V peak at 50 Hz is applied across a series combination of a resistor and inductor. If the impedance of the combination is Z = (10 + 5.03j)Ω, the power factor of this arrangement
Between i1 = -30cos(ωt + 50°) and v1 = 24sin(ωt - 10°), calculate the phase angle. Sketch and state which sinusoid is leading.
For the pair of waveforms (input and output) captured in that picture, write the mathematicalexpression for Vout(t), using the phase of Vin(t) as the reference. Also, write the phasor expressions forVout and Vin. Vin = Yellow line Vout = Blue line Vin max = 2V Vout max = 440.0 mV phase = -78.7483
Find a value of inductance less than 100 Henries, which ensures that the current, IS(t), is in phase with the source voltage, VS(t) = 12 cos (2000t-45°).