11 - Four resistors, one uncharged capacitor and two inductors are arranged as shown in the figure. Then a potential difference eo is applied across the circuit as shown. Just after Sis closed, what is the current through resistor R3 ? R2 R, a www R3 C °3 L1 L2 ll R4

11 - Four resistors, one uncharged capacitor and two inductors are arranged as shown in the figure. Then a potential difference eo is applied across the circuit as shown. Just after Sis closed, what is the current through resistor R3 ? R2 R, a www R3 C °3 L1 L2 ll R4

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter23: Electromagnetic Induction, Ac Circuits, And Electrical Technologies

Section: Chapter Questions

Problem 60PE: Camera flashes charge a capacitor to high voltage by switching the current through an inductor on...

See similar textbooks

Related questions

Q: Chapter 31, Problem 065 Your answer is partially correct. Try again. n ac generator provides emf to…

Q: 6. When a camera uses a flash, a fully charged capacitor discharges through an inductor. Inwhat time…

Q: 1. The number of turns on the primary and secondary windings of a 1-0 transformer are 350 and 35…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: 16. Which of the following is the circuit symbol for an inductor? a) b) w c) d) tt

Q: Question 11 of 15 High An inductor with inductance L has a current of 2 A flowing through it. The…

Q: In the circuit, the capacitor is fully charged when switch ?S is closed. Calculate the time needed…

Q: 86. A 50.0-0 resistor is connected in series with a 20-mH inductor. What is the time constant?

Q: Problem 23.63 An engineer proposes to store 80 kJ of energy by flowing 1.2 kA of current through a…

A: Given : U = 80 kJ = 80 × 103 J I = 1.2 kA = 1.2 × 103 A r = 1.2 m n = 3 turns/m

Q: Problem 8: Suppose a large power plant generates electricity at 12.0 kV. Its old transformer once…

A: Part (a)Find the relation between current, power and voltage.

Q: #71. At fixed length h of the coil, find the the self-inductance L when N and cross-sectional area A…

A: The self-inductance for a coil is given as: L=μ0N2Ah Where: μ0 is the Permeability of Free…

Q: What happen when you reverse the direction of the battery? What happen when you change the current…

A: a) It is known that a battery in a circuit provides the potential difference and due to this current…

Q: 8- However, even when the field current is zero, some amount of emf is generated (represented by…

A: Given .... Fill in the blanks... Load voltage, v = 120 V Induced open current voltage, V = 127 Volt…

Q: A constant voltage of 5.00 V has been observed over a certain time interval across a 2.20 H…

Q: 5. For the following pair of voltage and current, indicate whether the element involved is a…

A: Solution to ur question is as follows. Hope this will be helpful for you.

Q: 59. Starting with emf2 = -M- ΔΙ show that the units of Δι inductance are (V · s)/A = 2 · s.

A: Here, in the equation M is a mutual inductance, which has the same unit as inductance Emf unit is V…

Q: Electrosurgical units (ESUS) supply high-frequency electricity from resonant RLC circuits to cut,…

Q: 7 In the arrangement shown in figure there are two coils wound on a non- conducting cylindrical rod.…

A: 7.Switch is ON then OFF

Q: voltage equal to the emf

Q: A swith controls the current in a circuit that has large inductance. If the switch is open but near…

A: Inductor doesn’t allow sudden change in current. When the switch is initially closed, current is…

Q: circuits

A: Ohm's law is one of the fundamental relationships that is found in maximum electronic circuits.…

Q: 6. A constant inductance of one henry and a variable resistance R are connected in series with a…

Q: Suppose there is a steady current in an inductor. If you attempt to reduce the current to zero…

A: The current voltage relationship for an inductor is given by the following equation. Here, L is the…

Q: Inductance• Calculate the inductance of an inductor.• Calculate the energy stored in an inductor.•…

Q: | 2. An inductor has an inductance of 5 milliHenrys. A voltage of 5 V is suddenly applied |across…

A: Given,

Q: Calculate the peak voltage of a generator that rotates its 220–turn, 0.100 m diameter coil

Q: r 2 inductors La and Le with values 150µH and 200µH.Calculate (3M) Total inductance when La and LB…

Q: 2. Now consider an instant when the current is momentarily zero. Describe the magnitude of the…

A: Explanation and solution shown in the picture below ?

Q: 8. Calculate the inductance of a solepoid hat is 1.5 cm long and 3.0 mm in diameter, with 300 turns…

A: Let the number of turns of the solenoid is denoted by n, the area of the coil is A and the length of…

Q: 25-16. A transformer draws power P and delivers a current I, in its secondary coil. (a) What is the…

A: Power = potential×current P=V×I

Q: 5. Determine the current as a function of time for the following circuit: (20 pt) E=10 volt and is…

Q: In need of help... A V = 86-V source is connected in series with an R = 1.8-kΩ resistor and an L =…

A: V = 86-V L = 28-H R = 1.8-kΩ

Q: y B X X X X X X X X XX X X XX X X X X X X X X X X \X__X X a

Q: 85. The emf induced in an 80-mH inductor is -0.72 V when the current through th inductor increases…

Q: 17) What will be value of inductive reactance, X. and capacitive reactive Xc in a DC circuit?

A: The inductive reactance is measure of opposition of changing in current flow. Formula of inductive…

Q: 5. What is the inductance in Henry of an inductor whose reactance is 15.6 2 at 73.0 Hz? Round-off to…

Q: 4. The RLC circuit in the figure below contains two identical capacitors and two switches. The emf…

A: 4) When both the switches were closed, the capacitor and resistor on the left and right side get…

Q: 6. Give one condition for resonance to occur in a series RLC circuit.

Q: 5. In the circuit below, a battery supplies a constant voltage of 40 V, the inductance is 2 H, the…

A: (a) The given circuit is an LR series circuit. The current in an LR series circuit is given by,…

Q: Calculate the reactance of a 5.0-mH inductor at (a) 60 Hz, (b) 600 Hz, and (c) 6000 Hz.

Q: Continued question An R = 220-Ω resistor, an L = 1.95-mH inductor, and a V = 10.5-V source are…

A: (e) The current reaches the particular time is, It=I01-1e The current across the RL circuit is,…

Q: 78. * A student in a physics lab investigates the opera- tion of an AC generator. She collects data…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

11 - Four resistors, one uncharged capacitor and two
inductors are arranged as shown in the figure. Then
a potential difference eo is applied across the circuit
as shown. Just after S is closed, what is the current
through resistor R3 ?
R2
R,
a
R3
LI
L2
R
4.
а)
R1+R2+R3+RĄ
E0
b)
R1+R4
E0
c)
R3
e) O
R1+R2+R3
Boş bırak

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

If the capacitors in Figure 23.55 are replaced by inductors, which acts as a low-frequency fitter and which as a high-frequency fitter?
Why is the power dissipated by a closed switch, such as in Figure 21.43, small?
Would you use a large inductance or a large capacitance in series with a system to filter out low frequencies, such as the 100 Hz hum in a sound system? Explain.
Suppose you have a motor with a power factor significantly less than 1. Explain why it would be better to improve the power factor as a method at improving the motor's output, rather than to increase the voltage input.
High-frequency noise in AC power can damage computers. Does the plug-in unit designed to prevent this damage use a large inductance or a large capacitance (in series with the computer) to filter out such high frequencies? Explain.
Suppose you have a supply of inductors ranging from 1.00 nH to 10.0 H, and registers ranging from 0.100 (to 1.00 M What is the range of characteristic RL time constants you can produce by connecting a single resistor to a single inductor?
Does inductance depend on current, frequency, or both? What about inductive reactance?
What value of inductance should be used if a 20.0 k(reactance is needed at a frequency of 500 Hz?
Construct Your Own Problem Consider a double transformer to be used to create very large voltages. The device consists of two stages. The first is a transformer that produces a much larger output voltage than its input. The Output of the first transformer is used as input to a second transformer that further increases the voltage. Construct a problem in which you calculate the output voltage of the final stage based on the input voltage of the first Stage and the number of turns or loops in bath parts of both transformers (four coils in all). Also calculate the maximum output current of the final stage based on the input current. Discuss the possibility of power losses in the devices and the effect on the output current and power.
Why must pan of the circuit be moving relative to other parts, to have usable motional emf? Consider, for example, that the rails in Figure 23.11 are stationary relative to the magnetic field, while the rod moves.
Before World War II, some radios got power through a “resistance cord" that had a significant resistance. Such a resistance cord reduces the voltage to a desired level for the radio’s tubes and the like, and it saves the expense of a transformer. Explain why resistance cords become warm and waste energy when the radio is on.
(a) Use the exact exponential treatment to find how much time is required to bring the current through an 80.0 mH inductor in series with a 15.0 (resistor to 99.0% of its final value, starting from zero. (b) Compare your answer to the approximate treatment using integral numbers of (c) Discuss how significant the difference is.