23.solve Select one:O a. Vx: 31.3, Vy:21.3O b. Vx: 21.3, Vy:16.6O C. Vx: 14.8, Vy:16.4O d. Vx: 18.1, Vy:15.211 is the current flowing in the left mesh. 12 is the current flowing in the right mesh and 13 is the current flowing in the top mesh. If all three currents are flowing in the clockwisedirection, find the value of 11, 12 and 13.2A2 ohm1 ohm12V8V3ASelect one:O a. 10.67A, 7.67A, 2AO b. 3.67A, 6.67A, 2AO c. 7.67A, 10.67A, 2AO d. 7.67A, 8.67A, 2ANodal analysis is generally used to determine.Select one:a. ResistanceO b. CurrentO c. Voltage228 PM6/10/2021AGD ENGd Power

In the circuit, 3 loops are consist. 3 currents are flowing in the clock wise direction. Find the…

11 is the current flowing in the left mesh. 12 is the current flowing in the right mesh and 13 is the current flowing in the top mesh. If all three currents are flowing in the clockwis direction, find the value of 11, 12 and 13. 2A 2 ohm 1 ohm 12V 8V 3A Select one: O a. 10.67A, 7.67A, 2A O b. 3.67A, 6.67A, 2A O c. 7.67A, 10.67A, 2A O d. 7.67A, 8.67A, 2A

11 is the current flowing in the left mesh. 12 is the current flowing in the right mesh and 13 is the current flowing in the top mesh. If all three currents are flowing in the clockwis direction, find the value of 11, 12 and 13. 2A 2 ohm 1 ohm 12V 8V 3A Select one: O a. 10.67A, 7.67A, 2A O b. 3.67A, 6.67A, 2A O c. 7.67A, 10.67A, 2A O d. 7.67A, 8.67A, 2A

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.14P

See similar textbooks

Similar questions

Find the following: the power drawn by the 100ohm variable resistor If the variable resistor is set to 200-ohms, instead of 100-ohms, What is the power drawn by the 200-ohms resistor? total current of the system Is the circuit inductive, capacitive, or neither (resistive)? NOTE: Polar form for Voltage & Current. Rectangular form for Impedance
Given the circuit shown below, if Zx = 100/0 o determine the current in each branch by: a) Nodal Methodb) Maxwell’sMethod
Solve the power triangle at Z6 using the following network laws below.1.) Kirchoff's Law2.) Maxwell Equation3.) Nodal Analysis Given:V1, V2, and V3 = 220∠0° V, 50 HzZ1 = 7+j8 ohmsZ2 = 6+j3 ohmsZ3 = 5+j5 ohmsZ4 = 2+j3 ohmsZ5 = 8+j4 ohmsZ6 = 1+j9 ohms
Solve the power triangle at Z2 using the following network law below.2.) Maxwell EquationGiven:V1, V2, and V3 = 200∠0° V, 50 HzZ1 = 3+j6 ohmsZ2 = 5+j8 ohmsZ3 = 2+j3 ohmsZ4 = 8+j10 ohmsZ5 = 8+j4 ohms
8/ The shape of the conductor sag in a span is a semi-circle. Select one: True False
In the circuit in the figure, there is a load formed by connecting the resistor R0 between the terminals a and b and the inductance L0 in series. The amplitude of the voltage Vs (t) is √2 150 volts, the phase angle θs = 0 degrees, the period is T = 200π microseconds. Since R = 300OHM and C = 1 microFa) If the load phase angle is constant θL = 60 degrees, find the values of R0 and L0 that enable the load to draw the maximum average power from the circuit.b) Calculate the average power on the load.
. A system consists of two plants connected by a tie and a load is located at plant two. When 100MW are transmitted from plant one a loss of 10MW takes place on the T-line . Determine the generating schedule at both the plant and the power received by the load when λ for the system is GHC 25 per megawatt hour and the incremental fuel cost are given by the equation dF1dP1=0.031P1 + 17 GHC/ MWh ; dF2dP2=0.06P2 + 19 GHC/MWh
what is the mutual inductance in ohms (or the mutual inductive reactance ) between the two mutually-coupled inductors? if circuit to the left of load Z is converted into its Thevenin's equivalent, what would be the magnitude of ZTh in ohms? what is the phase angle of ZTh in degrees? what would be the phase angle of VTh in degrees? what would be the magnitude of VTh in volts if E = 120 V?
Compute for Vout and show complete solution.
1.1 We have two loads in delta and another in star in parallel, the impedances of the branches of the delta are equal and we have that RΔ=1p.u. and XΔ=0.75 p.u., while in the star we have equal values of the branches, but formed by admittances where we have the conductance in parallel GY=0.64 p.u. and inductive susceptance of BY=-j0.48 p.u. If the loads are being supplied by a positive sequence balanced three-phase source with line-to-line voltage of phases a and b of Vab=1∠ 30º, if the base values are line-to-line base voltage of 1kV and three-phase base power of 100kW. DetermineA) Line and phase voltages, line and phase currents of the load in delta, line and phase voltages of the star, line and phase currents of the star.B) Obtain separately the phasor diagram of the delta and star load with the values obtained in A), indicate on the scale that these are 1 p.u.=5cm for example.C) obtain the power triangle and the power factor separately for each load. D) Obtain the power…
Find the general flow pattern of network shown in figure. Assuming that all flows are non-negative, what is largest possible value for x3. where n=9.
Solve the power triangle at Z3 using the following network law below. Thanks in advance!!!2.) Maxwell EquationGiven:V1, V2, and V3 = 200∠0° V, 60 HzZ1 = 3+j5 ohmsZ2 = 4+j7 ohmsZ3 = 8+j6 ohmsZ4 = 5+j10 ohmsZ5 = 7+j8 ohms