115 volts 60 cycle source is connected to series CKT, consisting of a fixed resistor and an impedance coil if the resistors and coil voltage drops are 55.4 and 80 volts, respectively under which conditions the current is 1.69 AMP, calculate the resistance and inductance of the impedance coil. solve for power factor solve for L coil Solve for R coil

115 volts 60 cycle source is connected to series CKT, consisting of a fixed resistor and an impedance coil if the resistors and coil voltage drops are 55.4 and 80 volts, respectively under which conditions the current is 1.69 AMP, calculate the resistance and inductance of the impedance coil. solve for power factor solve for L coil Solve for R coil

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.16P: A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and...

See similar textbooks

Similar questions

A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and L=40mH. (a) Determine the power factor of the circuit and state whether it is lagging or leading. (b) Determine the real and reactive power absorbed by the load. (c) Calculate the peak magnetic energy Wint stored in the inductor by using the expression Wint=L(Irms)2 and check whether the reactive power Q=Wint is satisfied. (Note: The instantaneous magnetic energy storage fluctuates between zero and the peak energy. This energy must be sent twice each cycle to the load from the source by means of reactive power flows.)
A 15kVA, 440V, single-phase alternator draws a field current of 5A at rated load. With the same field current, the open circuit emf and short-circuit current are 100V and 80A respectively. The ohmic resistance of the armature between terminals is 0.12 ohm. The ratio of effective to ohmic resistance maybe taken as 1.1. Determine the voltage regulation (in %) when the load is purely resistive.
A 3Ø, Y-connected alternator is rated at 1,600KVA, 13.5KV. The armature effective AC resistance per phase is 1.5Ω. The percentage regulation for a load of 1,280kW at unity power factor is 3.5%. Determine:(a) synchronous reactance of the alternator(b) %VR at full-load 0.8pf leading(c) What is the effect on %VR value if taken at half-load lagging pf? Justify andexplain briefly your answer on one(1) sentence.
A single-phase alternator connected to 6,600-V bus-bars has a synchronous impedance of 10Ω and a resistance of 1 Ω. If its excitation is such that on open circuit the p.d. would be 5000 V, calculate the maximum load the machine can supply to the external circuit before dropping out of step and the corresponding armature current and p.f. [2864 kW, 787 A, 0.551]
A 400-V, 3-phase induction motor load takes 900 kVA at a power factor of 0.707. Calculate the KVA rating of the capacitor bank to raise the resultant power factor of the installation of 0.866 lagging. Find also the resultant power factor when the capacitors are in circuit and the motor load has fallen to 300 kVA at 0.5 power factor.
A 4MVA, 13.3kV, 60Hz, 3-phase, wye-connected alternator has an effective resistance of 5.2 ohm per phase and a combined armature reactance of 10.4 ohm per phase. Determine the full load Voltage regulation (in %) at unity pf.
The following data were obtained from a short-circuit test performed upon a 50 kVA, 2300/115 V, 60 Hz transformer: Esc = 87 V, Isc = 21.75 A, Psc = 590 W. Calculate (a) equivalent resistance, reactance and impedance referred to the primary, and (b) voltage regulation at a power factor of 0.866 lagging. Subject: Electrical Apparatus and Devices
When an impedance coil is connected to a 114 volt 60 cps source, the current is 3 A. If the current rises to 4 A when a 116 volt 25 cps is is impressed across the coil, determine the values of the resistance and inductance of the coil.
When using left hand rule for a coil, the fingers point in the direction of ____. a) electron flow, B) line of flux, C) polarity, D) none. Upon what does the strength of an air-cored coil depend? a) amount of current flow, B) number of turns, C) both a and b, d) none Transformers are rated in kilovoltamperes so the sizing of same is independent of the load power factor. A) false, B) true
A 50 kVA, 500 V, single phase alternator gives 700 V on open circuit at the field current of 15 A. While on short circuit a short current of 375 flows for the same field current. Assuming the armature resistance of 0.8 ohm, calculate (1) Synchronous impedance and (2) synchronous reactance
A 3-phase, 400-V, Y-connected synchronous motor has an equivalent reactance of 1 ohm per phase. The exciting current is adjusted to such value that a generated emf per phase is 260 V. Find the power factor at which the motor would operate when taking 40 kW from the supply.
Electromechanical energy conversion (One AC induction motor and one AC synchronous motor were operated connected to an infinite bus of 600V. Power factor of the induction motor is 0,7 (lagging) and consumes 400 W from the bus. Synchronous motor consumes 300 W from the bus. If the power factor of the synchronous motor is 0,9 (lagging) find the line current from the bus, for the total of two motors (IL total 1) of the line that connects the motors with the bus and find the total appearent power (SL total 1) of the motors consumed from the bus. When the induction motor has the same conditions, if the power factor of the synchronous motor is 0,9 (leading) find the line current from the bus, for the total of two motors (IL total 2) of the line that connects the motors with the bus and find the total appearent power (SL total 2) of the motors consumed from the bus.