12-203. Determine the time needed for the load at B to attain a speed of 10 m/s, starting from rest, if the cable is drawn into the motor with an acceleration of 3 m/s?. *12-204. The cable at A is being drawn toward the motor at va = 8 m/s. Determine the velocity of the block. B.

12-203. Determine the time needed for the load at B to attain a speed of 10 m/s, starting from rest, if the cable is drawn into the motor with an acceleration of 3 m/s?. *12-204. The cable at A is being drawn toward the motor at va = 8 m/s. Determine the velocity of the block. B.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter15: Oscillations

Section: Chapter Questions

Problem 64AP: A 2.00-kg object hangs, at rest, on a 1.00-m-long string attached to the ceiling. A 100-g mass is...

See similar textbooks

Related questions

Q: 5-75. If the cable can be subjected to a maximum tension of 300 Ib, determine the maximum force F…

Q: One end of a steel wire of length 0.2 m and radius 2 x 10-m is fixed. If the work done in wisting…

Q: A flexible cable as shown in the figure which supports the 100-kg load passed over a fixed circular…

Q: Four balls of equal radii form a pyramid supported by a smooth horizontal plane surface. The three…

A: Solution

Q: Can the conservation of energy be used to solve problems involving elastic impact, which assumes…

A: Suppose the collision between two blocks (rigid) is to be studied. let ,the first block is moving…

Q: Figure 20.32 i) What is the direction of the friction force on the block B? lii) Draw clear diagrams…

A: Given- Mass of A (ma) = 3 Kg Mass of B (mb) = 4 Kg Mass of C (mc) = 5 Kg

Q: Figure 9–38 shows a cone. Explain how to lay it on a flattable so that it is in (a) stable…

A: Answer: The concept of the each position is defined below with sketches: (a) Stable Equilibrium:…

Q: A bullet of mass 0.0395 kg is fired toward board with a thickness of 0.0295 m. Its speed is 355 m/s…

Q: Data has been gathered from a lifting system used to trans port engine parts. The sys tem cons is ts…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: e bones of the forearm about 2.15 cm beyond the joint. Assume the forearm has a mass of 2.45 kg and…

A: Given values:- Biceps muscle connects to the bones of the forearm,(r0)=2.15 cm=0.0215 m -----(1)…

Q: MA = 10 kg and MB = 20 kg are connected by a rigid bar of negligible mass. Find the acceleration of…

Q: 6. Plot the shear and moment diagrams for the beam loaded with both the distributed and concentrated…

Q: The bones of the forearm (radius and ulna) are hinged to the humerus at the elbow. The biceps muscle…

Q: The resultant force acting, of the uniformly distributed loading, is dependent on: a) Area b)…

A: NOTE : As you have requested answers without any explanation

Q: The patellar tendon attaches to the tibia at the tibial tuberosity at a perpendicular distance of…

A: According to the condition of equilibrium, the total torque or moment about the pivot point is zero.…

Q: 1) m, = 5 kg m, = 10 kg e = 30° Hx = 0.3 HK m, Two masses are connected via a tensile string over a…

Q: *12-200. Determine the constant speed at which the cable at A must be drawn in by the motor in order…

A: Height (distance) h = 6 m Time t = 1.5 s Speed = ?

Q: 2. Determine the length b of the triangular load and its position a on the beam such that the…

A: Cantilever beams are overhanging parts in a structure. It is only attached to one side so it poses a…

Q: 14-75. The assembly consists of two blocks A and B, which have a mass of 20 kg and 30 kg,…

A: Given:Mass of block (MA) = 20kgMass of block (MB) = 30kgVelocity of block A (VA) = 3 m/sec

Q: A string is wound around a uniform disc ofradius 0.49 m and mass 2.2 kg. The disc isreleased from…

A: The angular velocity of the uniform disc is

Q: Three identical rods are each acted on by two or more forces, all perpendicular to the rod and equal…

A: Your answer is (b) only 3

Q: Determine the vertical rise h of the load W during 10 seconds if the hoisting drum draws in cable at…

Q: 7. Find the magnitude and direction of F3 in Fig. 2.7 for the given system to be in equilibrium.…

A: Given data: The magnitude of the first force, F1=30 N. The magnitude of the second force, F2=15 N.…

Q: Bar AB of Fig. with weight W and length L has a uniform cross section. Rotation of the bar is…

Q: 13-11. Determine the time needed to pull the cord at B down 4 ft starting from rest when a force of…

A: Referring to fig 1, Applying newton's second law of motion. Fy= mAay 40-20= (20/32.2)*aA aA= 32.2…

Q: A body of mass 8-30ku kiciced and a speed 1of L60ms lohat are the Initial honzontal andverncal…

Q: 17-51. The pipe has a mass of 800 kg and is being towed behind the truck. If the acceleration of the…

A: Given data: The mass of the pipe is M=800 kg. The acceleration of the truck is at=0.5 m/s2. The…

Q: 4-33. The pipe assembly is subjected to the force c F = {600i + 800j – 500k} N. Determine the moment…

A: If a force F acted on a body of mass m , then the acted moment of force of the body about a point…

Q: Determine the magnitude and direction of the force P which keeps the concurrent force system in…

A: The angle is θ=45o. The net forces along horizontal and vertical direction is zero. The net…

Q: An elastic string of cross-sectional area 4 mm equires a force of 2.8 N to increase its length my…

A: Area = 4 mm2 = 4x10-6 m2 force applied = 2.8 N STRESS = F/A = 2.8 / 4X10-6 = 7 X105 N/m2…

Q: 12-95. The basketball passed through the hoop even though it barely cleared the hands of the player…

Q: *15-132. Sand is deposited from a chute onto a conveyor belt which is moving at 0.5 m/s. If the sand…

Q: You are hanging a heavy picture on a wall, using a wire attached to the top corners of the picture.…

A: Tension is a force applied on an wire or a string by an object when the object is placed over the…

Q: 14-66. The girl has a mass of 40 kg and center of mass at G. If she is swinging to a maximum height…

A: Using conservation of energy, 12mv2=mghv=2gh=2gl-lcosθ=29.8 m/s22 m1-cos60o=4.43 m/s

Q: The bones of the forearm (radius and ulna) are hinged to the humerus at the elbow. The biceps muscle…

A: The joint at the elbow has a turning effect when mass is placed at the hand. The biceps muscle…

Q: An oxygen cylinder of mass 13.0 kg is pulled up a mountain side at a constant speed of 1.2 m/s by a…

Q: 12-138. The motorcycle is traveling at 40 m/s when it is at A. If the speed is then decreased at v =…

A: Initial speed=40 m/s Angle, θ=60° Calculate the speed relation for car travelled in a curved path,…

Q: *15-36. The 50-kg boy jumps on the 5-kg skateboard with a horizontal velocity of 5 m/s. Determine…

A: Given: The mass of the boy is 50 kg. The mass of the skateboard is 5 kg. The horizontal velocity of…

Q: 144.12. A flexible rope, 80 ft long and weighing 0.5 lb/ft, passes over two smooth pegs as shown in…

Q: 12-91. The ball at A is kicked with a speed va = 80 ft/s and at an angle 6, = 30°. Determine the…

A: *We'll answer only the first question since the question to be answered was not specified. Please…

Q: Figure 12.17 shows a claw hammer being used to pull a nail out a horizontal board. The mass of the…

A: Given that: The mass of the hammer, M=1.00 kg The horizontal force applied on it, F=150 N Distance…

Q: 12-13. Tests reveal that a normal driver takes about 0.75 s before he or she can react to a…

A: This question is based on Motion in a straight line topic. Equations of motion can be used to solve…

Q: Data has been gathered from a lifting sys tem us ed to trans port engine parts. The sys tem consis…

A: ACCELERATION Because it has both magnitude and direction, acceleration is a vector quantity. It is…

Q: 12.122 In the_ braking test of a sports car its velocity is reduced from 70 mi/h to zero in a…

A: Scenario - Car reduced its speed from certain speed to rest by using breaks and friction. Given :…

Q: he elastic limit of Al is 1.8 X 10^8 Pa. Find the minimum radius (meter) of an Al wire that could…

A: Elastic limit is B=1.8×108 Pa Mass of the wire is m = 10.0 kg Suppose that, minimum radius is r

Q: A large water tower holds 3 million gallons of water, which has a mass of about 11 million…

Question

12-203. Determine the time needed for the load at B to
attain a speed of 10 m/s, starting from rest, if the cable is
drawn into the motor with an acceleration of 3 m/s?.
*12-204. The cable at A is being drawn toward the motor
at va = 8 m/s. Determine the velocity of the block.
B.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

In Fig. 12-31 show that, if the ball is to swing completely around the fixed peg, then d > 3L/5. (Hint: The ball must be moving at the top of its swing; otherwise the string will collapse.)
A rope of negligible mass is stretched horizontally between two supports that are 3.44 m apart.When an object of weight 3160 N is hung at the center of the rope, the rope is observed to sag by 35.0 cm.What is the tension in the rope?
A bullet of mass 0.0395 kg is fired toward board with a thickness of 0.0295 m. Its speed is 355 m/s before making contact with the board and it passes through the board. The average force exerted on the bullet by the board has a magnitude of 732 N. What is the speed of the bullet, in m/s, after passing through the board? (The weight of the bullet is negligible relative to the force exerted by the board. Assume the force exerted by the board is constant.)
A 2.00-kg object hangs, at rest, on a 1.00-m-long string attached to the ceiling. A 100-g mass is fired with a speed of 20 m/s at the 2.00-kg mass, and the 100.00-g mass collides perfectly elastically with the 2.00-kg mass. Write an equation for the motion of the hanging mass after the collision. Assume air resistance is negligible.
When tightening a bolt, you push perpendicularly on a wrench with a force of 165N at a distance of 0.140m from the center of the bolt. How much torque are you exerting relative to the center of the bolt?
Note: Unless stated otherwise, the weights of the wires, rods, and other elements are assumed to be negligible. Elastic moduli of selected materials are given In Table 12.1 13.Why can a squirrel jump from a tree branch to the ground and run away undamaged, while a human could break a bone In such a fall?
Can the conservation of energy be used to solve problems involving elastic impact, which assumes that the body is rigid?
A pendulum consists of a 2.0 m long steel wire supporting a lentil of mass 20 kg. If the pendulum is released from a position where it makes an angle of 60 with the vertical, find the difference in length of the wire when the bob is in the initial position and when it passes through its lowest position.
A 25-g rifle bullet traveling 240 m/sm/s embeds itself in a 3.4-kg pendulum hanging on a 2.7-m-long string, which makes the pendulum swing upward in an arc. - Determine the vertical component of the pendulum's maximum displacement. (Change in y max).
A string is wound around a uniform disc ofradius 0.49 m and mass 2.2 kg. The disc isreleased from rest with the string vertical andits top end tied to a fixed support.Calculate the speed of the center of masswhen, after starting from rest, the center ofmass has fallen 3.1 m. The acceleration ofgravity is 9.8 m/s^2. Answer in units of m/s.
A bungee jumper momentarily comes to rest at the bottomof the dive before he springs back upward. At that moment,is the bungee jumper in equilibrium? Explain.
The forearm of length Larm=35.4 cm shown in the figure is positioned at an angle θ with respect to the upper arm, and a 5.30-kg ball is held in the hand. The total mass ?totalmtotal of the forearm and hand is 3.00 kg, and their center of mass is located at LCM=14.6 cm from the elbow. The biceps muscle attaches to the forearm at a distanceLbiceps=3.5 cm from the elbow. What is the magnitude of the force Fbiceps that the biceps muscle exerts on the forearm for ?=49∘? What is the magnitude of the force Fjoint that the forearm exerts on the elbow joint for ?=49∘?