18 and 19 only please elei is Köt between the poles.b. The conductor is moving too slowly.c. The conductor is not cutting field lines.d. The poles are too close together.onduirmovementof conductor18. For an a.c generator of maximum value 100 volt, the average e.m.f value within aquarter or a half cycle equal .. Volt..a. 50b. 63.6C. 70.7d. zero19. For an a.c generator of maximum value 100 volt, the average e.m.f value within acomplete cycle equal .Volt.a. 50b. 63.6C. 70.7d. Zero20. For direct current generator, the ratio between the number of coils to the numberof commutator segments is ...b. 2:1a. 1:2с. 1:4d. 4:121. Which parts of an a.c. generator slide past each other when the generator is workinga. brushes and coilb. coil and magnetstimec. magnets and slip ringsd. slip rings and brushes

Answered: Image /qna-images/answer/aa11b056-ebf8-4471-83f3-d4761ae26241.jpg

18. För an a.c generator of maximum value 100 volt, the av quarter or a half cycle equal .. Volt.. a. 50 b. 63.6 C. 70.7 19. For an a.c generator of maximum value 100 volt, the a complete cycle equal Volt.

18. För an a.c generator of maximum value 100 volt, the av quarter or a half cycle equal .. Volt.. a. 50 b. 63.6 C. 70.7 19. For an a.c generator of maximum value 100 volt, the a complete cycle equal Volt.

Physics for Scientists and Engineers

10th Edition

ISBN:9781337553278

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter31: Inductance

Section: Chapter Questions

Problem 40AP: At the moment t = 0, a 24.0-V battery is connected to a 5.00-mH coil and a 6.00- resistor. (a)...

See similar textbooks

Similar questions

Some surgery is performed with high-voltage electricity passing from a metal scalpel through the tissue being cut. Considering the nature of electric fields at the surface of conductors, why would you expect most of the current to flow from the sharp edge of the scalpel? Do you think high- or low-frequency AC is used?
(a) What is the speed of a supersonic aircraft with a 17.0-m wingspan, if it experiences a 1.60V Hall voltage between its wing lips when in level flight over the north magnetic pole, where the Earth's field strength is 8.00105T ? (b) Explain why very little current flows as a result of this Hall voltage.
Review. A novel method of storing energy has been proposed. A huge underground superconducting coil, 1.00 kin in diameter, would be fabricated. It would carry a maximum current of 50.0 kA through each winding of a 150-turn Nb3Sn solenoid. (a) If the inductance of this huge coil were 50.0 H. what would be the total energy stored? (b) What would be the compressive force per unit length acting between two adjacent windings 0.250 in apart?
(a) What current flows when a 60.0 Hz, 480 V AC source is connected to a 0.250 (F capacitor? (b) What would the current be at 25.0 kHz?
(a) An MRI technician moves his hand from a region of very low magnetic field strength into an MRI scanner's 2.00 T field with his fingers pointing in the direction of the field. Find the average emf induced in his wedding ling, given its diameter is 2.20 cm and assuming it takes 0.250 s to move it into the field. (b) Discuss whether this current would significantly change the temperature of the ring.
An induction furnace uses electromagnetic induction to produce eddy currents in a conductor, thereby raising the conductors temperature. Commercial units operate at frequencies ranging from 60 Hz to about 1 MHz and deliver powers from a few watts to several megawatts. Induction heating can be used for warming a metal pan on a kitchen stove. It can be used to avoid oxidation and contamination of the metal when welding in a vacuum enclosure. To explore induction heating, consider a flat conducting disk of radius R, thickness b, and resistivity . A sinusoidal magnetic field Bmax cos t is applied perpendicular to the disk. Assume the eddy currents occur in circles concentric with the disk. (a) Calculate the average power delivered to the disk. (b) What If? By what factor does the power change when the amplitude of the field doubles? (c) When the frequency doubles? (d) When the radius of the disk doubles?
Unreasonable Results An inventor wants to generate 120V power by moving a 1.00mlong wire perpendicular to the Earth’s 5.00105T field. (a) Find the speed with which the wire must move. (b) What is unreasonable about this result? (c) Which assumption is responsible?
A 20.0 HZ, 16.0 V source produces a 2.00 mA current when connected to a capacitor. What is the capacitance?
(a) What is the resistance of a 220-V AC short circuit that generates a peak power of 96.8 kW? (b) What would the average power be if the average power be if the voltage was 120 V AC?
Integrated Concepts One long straight wire is to be held directly above another by repulsion between 1heir currents. The lower wire carries 100 A and the wire 7.50 cm above it is 10gauge (2.588 mm diameter) copper wire. (a) What current must flow in the upper wire, neglecting the Earth’s field? (b) What is the smallest current if the Earth’s 3.00105T field is parallel to the ground and is not neglected? (c) Is the supported wire in a stable or unstable equilibrium if displaced vertically? If displaced horizontally?
Presbycusis is a hearing loss due to age that progressively affects higher frequencies. A hearing aid amplifier is designed to amplify all frequencies equally. To adjust its output for presbycusis, would you put a capacitor in series or parallel with the hearing aid's speaker? Explain.
An RLC circuit consists of a 150- resistor, a 21.0-F capacitor, and a 466-mH inductor connected in series with a 120-V, 60.0-Hz power supply. (a) What is the phase angle between the current and the applied voltage? (b) Which reaches its maximum earlier, the current or the voltage?