2 atm 20 m

Q: Using Bernoulli's principle between point 1 and 2, determine the maximum height that the water can…

A:

Q: Water flows through a horizontal pipe at a rate of 2.4 gal/s. The pipe consists of two sections of…

A: Given data:Discharge of the water through a horizontal pipe is Q=2.4 gal/s Diameters of the…

Q: A 3.6 liter hot pot filled with steam at 300 pKa empties through the pour spout of the pot while…

A:

Q: A capillary tube is immersed vertically in a water container. Knowing that water starts to evaporate…

A: At the liquid side of the meniscus, the pressure P is 2 kPa. Write the expression of capillary rise…

Q: A 90° elbow in a horizontal pipe is used to direct water flow upward at a rate of 40 kg/s. The…

A:

Q: A 90° elbow in a horizontal pipe is used to direct water flow upward at a rate of 40 kg/s. The…

A: Water flow rate = 40 kg/s Diameter of pipe = 10cm Elevation difference = 50 cm Assumptions The flow…

Q: What is a manometer? What are the two types of manometers? What is a thermocouple? What is a…

A:

Q: The velocity of a fluid flowing in a pipe is to be measured by two different Pitot-type mercury…

A: we have to judge the use of these manometers in this experiment

Q: Water flowing through a pipe at a rate of 70 liter/sec having diameters 600 mm and 400 mm at the…

A:

Q: The hydraulic life in a car repair shop has an output diameter of 30 cm and is to lift cars up to…

A: Pressure in a fluid system has magnitude but not a specific direction and thus, it is a scalar…

Q: A 90° elbow in a horizontal pipe is used to direct water flow upward at a rate of 40 kg/s. The…

A: Write the assumption. The flow is steady, frictionless, incompressible, and irrotational (so that…

Q: The gage pressure of the air in the tank, as shown in the figure is measured to be 80 KPa. Determine…

A:

Q: The device that stores the potential energy of an incompressible fluid is O a. pressure absorbing…

A: Question)  The device that stores the potential energy of an incompressible fluid is .............

Q: A 22 L kerosene tank is filled with 2 cm diameter hose equipped with a 1.5 cm nozzle meter If it…

A:

Q: Helium is used in the Carnot engine where the volumes beginning with constant temperature heat…

A:

Q: The water level in a tank is 20 m above the ground. A hose is connected to the bottom of the tank,…

A: The entire mechanical energy of the flowing fluid, which includes the gravitational potential energy…

Q: 1. The compressed air tank has a volume of 0.6 m. The temperature is 15°C and the atmospheric…

A: given:volume V=0.6m3temperature T=150 catmospheric pressure P1=101.35kpagage pressure…

Q: Consider a device with one inlet and one outlet. If the volume flow rates at the inlet and at the…

A: As the system has only one inlet and outlet and the volume flow rates are considered to be same the…

Q: 200 kPa gage and a temperature of 23oC in the tires. During the long drive, the temperature of the…

A:

Q: A hair dryer is basically a duct of constant diameter in which a few layers of electric resistors…

A: Flow rate: the amount of fluid flowing through a particular cross-section per unit time is known as…

Q: Consider the system shown. If a change of 0.9 kPa in the pressure of air causes the brine-mercury…

A: Given data Shg=13.6ρhg=13600 kg/m3ρw=1000 kg/m3P2-P1=0.9 KPa

Q: The water level in a tank is 12 m above the ground. A hose is connected to the bottom of the tank,…

A: Draw the diagram of the tank with a hosepipe and nozzle, Let h be the height of the water stream…

Q: Consider the water flowing through the transition shown. If the difference in the level of mercury…

A: As per given  H=64mm Diameter D1=0.1m and D2=0.04m ρHg  = 13 550  kg/m3 We have to determine volumes…

Q: Oil AIR WATER Mercury

A:

Q: 36. The top floor of a building is 20 m above the basement. Show that the water pressure in the…

A:

Q: Oil (SG = 0.85) is flowing in a 10cm diameter pipe. The elevation of the pipe is 5m above the datum…

A:

Q: A 10 ft3 vessel of hydrogen at a pressure of 305 psia is vigorously stirred by paddles until the…

A:

Q: Choose correct answer: Pump converts ___________ A. Mechanical energy to Hydraulic energy B.…

A: Pump converts the Mechanical energy into hydraulic energy of the liquid.

Q: Water from a reservoir is raised in a vertical tube of internal diameter D = 30 cm under the…

A: Calculate the pressure at the piston face              P=Patm-ρgh=96-1000×9.81×1.5=81.3 kPa…

Q: A rigid tank holds 20 lbm of air at a pressure of 20 psi and a temperature of 70°F. Increase the…

A:

Q: H.W.1/: The water in a tank is pressurized by air, and the pressure is measured by a multifluid…

A: The gage pressure of air is 97.8057 kPa.

Q: 4. A spherical vessel of 1.7m diameter is made from 12mm thick plate, and it is to be subject4 to a…

A: Given data: d=1.7 mt=12 mm∆P=116 bar=116×10-4 GN/m2k=2.9 GN/m2E=200 GN/m2v=0.3 Need to determine the…

Q: For an ideal liquid, express the flow Q through an orifice in terms of the density of the liquid,…

A:

Q: The water level in a tank is 15 m above the ground. A hose is connected to the bottom of the tank,…

A: Given data: The height of the water level in the tank, h1 = z1 = 15 m Pressure at the water surface…

Q: Assuming that the density of air is constant at 1.22kg/m3, determine the height of air to represent…

A:

Q: An air bubble rises from the bottom of the well where the temperature is 20 degrees celsius to the…

A:

Q: A cylindrical tank with a diameter of 36 inches is open at the top. It is filled up to a depth of…

A:

Q: 22 L kerosene tank is filled with 2 cm diameter hose equipped with a 1.5 cm nozzle meter If it takes…

A:

Q: The water level in a tank is 10 m above the ground. A hose is connected to the bottom of the tank,…

A:

Q: The pressure of an automobile tire is measured to be 190 kPa (gage) before a trip and 215 kPa (gage)…

A: Given   Pressure, P1 = 190 kPa                 P2 = 215 kPa Temperature, T1 = 25oC Find Temperature…

Q: QI/ A container contains 4 kg of air at a pressure of 600 kPa and a temperature of 40 °C. The…

A: Given data: m=4 kgP1=600 kPaT1=40°CP2=250 kPaT2=15°C Need to determine the volume of each container.

Q: The water level in a tank is 34 ft above the ground. A hose is connected to the bottom of the tank…

A:

Q: The water level in a tank is 20 m above the ground. A hose is connected to the bottom of the tank,…

A: Consider the diagram shown below for the given system.

Q: The drinking water needs of an office are met by large water bottles. One end of a 0.35-in-diameter,…

A: The diameter of the plastic hose is D=0.35 in. The total length of the plastic hose is L=6 ft. The…

Q: A hemispherical tank of radius 3m is filled with 4500 liters of water. Find the time it will take to…

A: Given : r = 3 m V = 4500 L = 4.5 m3 P = 10 kW To find : Time taken

Q: a. What is gage pressure and absolute pressure? b. Define intensive and extensive properties? c.…

A: Given: a) Gauge pressure and absolute pressure b) intensive and extensive properties c) saturated…

Q: 2. The gage pressure of the air in the tank, as shown in the figure is measured to be 80 KPa.…

A: